參數資料
型號: PIC12CE674-10/P
廠商: Microchip Technology
文件頁數: 45/129頁
文件大?。?/td> 0K
描述: IC MCU OTP 2KX14 A/D&EE 8DIP
產品培訓模塊: Asynchronous Stimulus
8-bit PIC® Microcontroller Portfolio
標準包裝: 60
系列: PIC® 12C
核心處理器: PIC
芯體尺寸: 8-位
速度: 10MHz
外圍設備: POR,WDT
輸入/輸出數: 5
程序存儲器容量: 3.5KB(2K x 14)
程序存儲器類型: OTP
EEPROM 大?。?/td> 16 x 8
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 3 V ~ 5.5 V
數據轉換器: A/D 4x8b
振蕩器型: 內部
工作溫度: 0°C ~ 70°C
封裝/外殼: 8-DIP(0.300",7.62mm)
包裝: 管件
配用: ISPICR1-ND - ADAPTER IN-CIRCUIT PROGRAMMING
AC124001-ND - MODULE SKT PROMATEII 8DIP/SOIC
PIC12C67X
DS30561B-page 22
1999 Microchip Technology Inc.
4.3
PCL and PCLATH
The Program Counter (PC) is 13-bits wide. The low
byte comes from the PCL Register, which is a readable
and writable register. The high byte (PC<12:8>) is not
directly readable or writable and comes from PCLATH.
On any reset, the PC is cleared. Figure 4-3 shows the
two situations for the loading of the PC. The upper
example in the figure shows how the PC is loaded on a
write to PCL (PCLATH<4:0>
→ PCH). The lower exam-
ple in the figure shows how the PC is loaded during a
CALL
or GOTO instruction (PCLATH<4:3>
→ PCH).
FIGURE 4-3:
LOADING OF PC IN
DIFFERENT SITUATIONS
4.3.1
COMPUTED GOTO
A Computed GOTO is accomplished by adding an off-
set to the program counter (ADDWF PCL). When doing
a table read using a computed GOTO method, care
should be exercised if the table location crosses a PCL
memory boundary (each 256 byte block). Refer to the
application note
“Implementing a Table Read" (AN556).
PC
12
8
7
0
5
PCLATH<4:0>
PCLATH
Instruction with
ALU result
GOTO, CALL
Opcode <10:0>
8
PC
12
11 10
0
11
PCLATH<4:3>
PCH
PCL
87
2
PCLATH
PCH
PCL
PCL as
Destination
4.3.2
STACK
The PIC12C67X family has an 8-level deep x 13-bit
wide hardware stack. The stack space is not part of
either program or data space and the stack pointer is
not readable or writable. The PC is PUSHed onto the
stack when a CALL instruction is executed or an inter-
rupt causes a branch. The stack is POPed in the event
of a RETURN, RETLW or a RETFIE instruction execu-
tion. PCLATH is not affected by a PUSH or POP oper-
ation.
The stack operates as a circular buffer. This means that
after the stack has been PUSHed eight times, the ninth
push overwrites the value that was stored from the first
push. The tenth push overwrites the second push (and
so on).
4.4
Program Memory Paging
The
PIC12C67X
ignores
both
paging
bits
PCLATH<4:3>, which are used to access program
memory when more than one page is available. The
use of PCLATH<4:3> as general purpose read/write
bits for the PIC12C67X is not recommended since this
may affect upward compatibility with future products.
Note 1: There are no status bits to indicate stack
overflow or stack underflow conditions.
2: There are no instructions/mnemonics
called PUSH or POP. These are actions
that occur from the execution of the
CALL, RETURN, RETLW,
and RETFIE
instructions, or the vectoring to an inter-
rupt address.
相關PDF資料
PDF描述
PIC16F628-04/P IC MCU FLASH 2KX14 COMP 18DIP
PIC24FJ32GA002-I/SO IC PIC MCU FLASH 32KB 28SOIC
PIC24FJ16GA002-I/SP IC PIC MCU FLASH 16K 28-DIP
PIC18LF25J11-I/SS IC PIC MCU FLASH 32K 2V 28-SSOP
PIC16CE623-04I/SO IC MCU OTP 512X14 EE COMP 18SOIC
相關代理商/技術參數
參數描述
PIC12CE67X 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontroller with A/D Converter and EEPROM Data Memory
PIC12CR509 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers
PIC12CR509A 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers
PIC12CR509A-04/EJW 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers
PIC12CR509A-04/EP 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers