- 您現在的位置：買賣IC網 > PDF目錄368020 > PI7C8150-33 PCI Bridge | 2-Port PCI-to-PCI Bridge PDF資料下載
參數資料
| 型號： | PI7C8150-33 |
| 英文描述： | PCI Bridge | 2-Port PCI-to-PCI Bridge |
| 中文描述： | PCI橋| 2端口PCI至PCI橋 |
| 文件頁數： | 57/115頁 |
| 文件大?。?/td> | 879K |
| 代理商： | PI7C8150-33 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
PI7C8150B
2-PORT PCI-TO-PCI BRIDGE
ADVANCE INFORMATION
Page 57 of 115
July 31, 2003 – Revision 1.031
the initiator. When PI7C8150B detects a parity error on the write data for the initial
delayed write request transaction, the following events occur:
!
If the parity-error-response bit corresponding to the initiator bus is set, PI7C8150B
asserts TRDY_L to the initiator and the transaction is not queued. If multiple data
phases are requested, STOP_L is also asserted to cause a target disconnect. Two cycles
after the data transfer, PI7C8150B also asserts PERR_L.
!
If the parity-error-response bit is not set, PI7C8150B returns a target retry.
It queues the transaction as usual. PI7C8150B does not assert PERR_L.
In this case, the initiator repeats the transaction.
!
PI7C8150B sets the detected-parity-error bit in the status register corresponding to the
initiator bus, regardless of the state of the parity-error-response bit.
Note:
If parity checking is turned off and data parity errors have occurred for queued or
subsequent delayed write transactions on the initiator bus, it is possible that the initiator’s
re-attempts of the write transaction may not match the original queued delayed write
information contained in the delayed transaction queue. In this case, a master timeout
condition may occur, possibly resulting in a system error (P_SERR_L assertion).
For downstream transactions, when PI7C8150B is delivering data to the target on the
secondary bus and S_PERR_L is asserted by the target, the following events occur:
!
PI7C8150B sets the secondary interface data parity detected bit in the secondary status
register, if the secondary parity error response bit is set in the bridge control register.
!
PI7C8150B captures the parity error condition to forward it back to the initiator on the
primary bus.
Similarly, for upstream transactions, when PI7C8150B is delivering data to the target on
the primary bus and P_PERR_L is asserted by the target, the following events occur:
!
PI7C8150B sets the primary interface data-parity-detected bit in the status register, if
the primary parity-error-response bit is set in the command register.
!
PI7C8150B captures the parity error condition to forward it back to the initiator on the
secondary bus.
A delayed write transaction is completed on the initiator bus when the initiator repeats the
write transaction with the same address, command, data, and byte enable bits as the
delayed write command that is at the head of the posted data queue. Note that the parity bit
is not compared when determining whether the transaction matches those in the delayed
transaction queues.
Two cases must be considered:
!
When parity error is detected on the initiator bus on a subsequent re-attempt of the
transaction and was not detected on the target bus
!
When parity error is forwarded back from the target bus
For downstream delayed write transactions, when the parity error is detected on the
initiator bus and PI7C8150B has write status to return, the following events occur:
相關PDF資料 |
PDF描述 |
|---|---|
| PI7C8150A | PCI Bridge | 2-Port PCI-to-PCI Bridge |
| PI7C8150A-33 | PCI Bridge | 2-Port PCI-to-PCI Bridge |
| PI7C8150B | PCI Bridge | Asynchronous 2-Port PCI Bridge |
| PI7C8152A | ENHANCED 2- PORT TO PCI BRIDGE INTEL 21152 COMPORISON |
| PI7C81552 | ENHANCED 2-PORT PCI TO PCI BRIDGE INTEL 21152 COMPARISON |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C8150A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCI Bridge | 2-Port PCI-to-PCI Bridge |
| PI7C8150A-33 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCI Bridge | 2-Port PCI-to-PCI Bridge |
| PI7C8150AMA | 制造商:Pericom Semiconductor Corporation 功能描述:PCI to PCI Bridge 208-Pin FQFP |
| PI7C8150AMA-33 | 制造商:Pericom Semiconductor Corporation 功能描述:PCI-to-PCI Bridge 208-Pin FQFP |
| PI7C8150AMAE | 功能描述:外圍驅動器與原件 - PCI 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。