參數資料
型號： PCM3794RHBRG4
元件分類： Codec
英文描述： 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier
中文描述： 16位，低功耗立體聲音頻編解碼器麥克風偏置，耳機，揚聲器放大器和數字
文件頁數： 16/63頁
文件大?。?/td> 915K
代理商： PCM3794RHBRG4
www.ti.com
PCM3793/94 DESCRIPTION
Analog Input
Gain Settings for Analog Input
A/D Converter
D/A Converter
Common Voltage
Line Output
Headphone Output
Headphone Plug Insertion Detection
PCM3793
PCM3794
SLES193A–AUGUST 2006–REVISED SEPTEMBER 2006
The AIN1L, AIN1R, AIN2L, AIN2R, AIN3L, and AIN3R pins can be used as microphone or line inputs with
selectable 0- or 20-dB boost and 1-Vrms input. All analog inputs have high input impedance (20 k
), which is
not changed by gain settings. One pair of inputs is selected by register 87 (AIL[1:0], AIR[1:0]). AIN1L and AIN1R
can be used as monaural differential inputs.
Analog signals can be adjusted from 30 dB to –12 dB in 1-dB steps following the 0- or 20-dB boost amplifier.
The gain level can be set for each channel by registers 79 and 80 (ALV[5:0], ARV[5:0]).
The ADC includes a multilevel delta-sigma modulator, aliasing filter, decimation filter, high-pass filter, and notch
filter and can accept a 1-Vrms full-scale voltage input. The decimation filter has a digital soft mute controlled by
register 81 (RMUL, RMUR). The high-pass filter can be disabled by register 81 (HPF[1:0]) and the notch filter
can be disabled by registers 96 to 104 if it is not necessary to cancel a dc offset or compensate for wind noise.
The DAC includes a multilevel delta-sigma modulator and interpolation filter. These can be used to obtain high
PSRR, low jitter sensitivity, and low out-of-band noise quickly and easily. The interpolation filter includes digital
attenuator, digital soft mute, three-band tone control (bass, midrange and treble), and 3-D sound controlled by
registers 92 to 95. The de-emphasis filter (32, 44.1 and 48 kHz) is controlled by registers 68 to 70 (ATL[5:0],
ATR[5:0], PMUL, PMUR, DEM[1:0]). Oversampling rate control can reduce out-of-band noise when operating at
low sampling rate by using register 70 (OVER).
The V
COM
pin is normally biased to 0.5 V
CC
, and it provides the common voltage to internal circuitry. It is
recommended that a 10-
μ
F capacitor be connected between this pin and ground to provide clean voltage and
avoid pop noise. The PCM3793/94 may have a little pop noise on each analog output if a capacitor smaller than
10
μ
F is used.
The HPOL/LOL and HPOR/LOR and HPCOM/MONO pins can be used as a monaural single-ended, monaural
differential, or stereo single-line output with 1-V
output by register 74 (HPS[1:0]). The line outputs can drive a
10-k
load. These outputs include an analog volume amplifier, except for the HPCOM/MONO pin that can be
set from 6 dB to –70 dB and mute with 0.5-, 1-, 2- or 4-dB steps for each output, as controlled by registers 64
and 65 (HLV[5:0], HRV[5:0], HMUL, HMUR). A dc blocking capacitor is not required when connecting to an
external speaker amplifier with monaural differential input. The center voltage is 0.5 V
CC
with zero data input.
The HPOL/LOL, HPOR/LOR, and HPCOM/MONO pins are stereo, monaural, or monaural differential
headphone outputs with more than 30 or 40 mWrms output power into a 32- or 16-
load, either through a dc
blocking capacitor or without a capacitor, as selected by register 74 (HPS[2:0]). These outputs include analog
volume amplifiers, except for the HPCOM/MONO pin, which can be set from 6 dB to –70 dB with 0.5-, 1-, 2- or
4-dB steps for each output using registers 64 and 65 (HLV[5:0], HRV[5:0], HMUL, HMUR). The center voltage is
0.5 V
CC
with zero data input.
The HDTI pin detects the insertion status of headphone plug and writes the status to register 77 (HPDS), which
can be read by the I
2
C interface. The polarity of the status indication can be inverted by register 75 (HPDP). The
headphone
and
speaker
amplifiers
are
disabled
insertion/extractrion if register 75, HPDE = 1. They are controlled by register settings if register 75, HPDE = 0.
HPCOM/MONO is not affected by the status when register 74, CMS[0] = 1.
or
enabled
automatically
by
headphone
plug
16
Submit Documentation Feedback
相關PDF資料
PDF描述
PCM3794RHBT 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier
PCM3793 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier
PCM3793RHB 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier
PCM3793RHBR 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier
PCM3793RHBRG4 16-Bit, Low-Power Stereo Audio CODEC With Microphone Bias, Headphone, and Digital Speaker Amplifier
相關代理商/技術參數
參數描述
PCM3794RHBT 功能描述:接口—CODEC Very Low-Pwr Stereo CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel
PCM3794RHBTG4 功能描述:接口—CODEC Very Low-Pwr Stereo CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel
PCM-38 功能描述:電線鑒定 Pre-Printed WM Card, Vinyl Cloth, .22" W RoHS:否 制造商:TE Connectivity / Q-Cees 產品:Labels and Signs 類型: 材料:Vinyl 顏色:Blue 寬度:0.625 in 長度:1 in
PCM-380 制造商:Panduit Corp 功能描述:
PCM-3810I-AE 制造商:Advantech Co Ltd 功能描述:250 KS/S, 12-BIT, MULTIFUNCTION PCI-10 - Bulk 制造商:Advantech Co Ltd 功能描述:250 kS/s, 12-bit, Multifunction PCI-104 module
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*