參數資料
型號: PCM1716
英文描述: 24-Bit, 96kHz Sampling CMOS Delta-Sigma Stereo Audio DIGITAL-TO-ANALOG CONVERTER
中文描述: 24位,96kHz采樣的CMOSΔ-Σ立體聲音頻數字模擬轉換器
文件頁數: 13/14頁
文件大?。?/td> 222K
代理商: PCM1716
13
PCM1716
APPLICATION
CONSIDERATIONS
DELAY TIME
There is a finite delay time in delta-sigma converters. In A/D
converters, this is commonly referred to as latency. For a
delta-sigma D/A converter, delay time is determined by the
order number of the FIR filter stage, and the chosen sampling
rate. The following equation expresses the delay time of
PCM1716:
T
D
= 30
x
1/f
S
For f
S
= 44.1kHz, T
D
= 30/44.1kHz = 680
μ
s
Applications using data from a disc or tape source, such as
CD audio, DVD audio, Video CD, DAT, Minidisc, etc.,
generally are not affected by delay time. For some profes-
sional applications such as broadcast audio for studios, it is
important for total delay time to be less than 2ms.
OUTPUT FILTERING
For testing purposes all dynamic tests are done on the
PCM1716 using a 20kHz low pass filter. This filter limits
the measured bandwidth for THD+N, etc. to 20kHz. Failure
to use such a filter will result in higher THD+N and lower
SNR and Dynamic Range readings than are found in the
specifications. The low pass filter removes out of band
noise. Although it is not audible, it may affect dynamic
specification numbers.
The performance of the internal low pass filter from DC to
40kHz is shown in Figure 12. The higher frequency roll-off
of the filter is shown in Figure 13. If the user’s application
has the PCM1716 driving a wideband amplifier, it is recom-
mended to use an external low pass filter.
BYPASSING POWER SUPPLIES
The power supplies should be bypassed as close as possible
to the unit. Refer to Figure 15 for optimal values of bypass
capacitors.
POWER SUPPLY
CONNECTIONS
PCM1716 has three power supply connections: digital (V
DD
),
and analog (V
CC
). Each connection also has a separate
ground. If the power supplies turn on at different times, there
is a possibility of a latch-up condition. To avoid this condi-
tion, it is recommended to have a common connection
between the digital and analog power supplies. If separate
supplies are used without a common connection, the delta
between the two supplies during ramp-up time must be less
than 0.1V.
An application circuit to avoid a latch-up condition is shown
in Figure 14.
FIGURE 12. Low Pass Filter Response.
1
10
100
1k
10k
100k
1
0.5
0
–0.5
–1
L
Log Frequency (Hz)
FIGURE 13. Low Pass Filter Response.
1
10
100
1k
10k
100k
1M
10M
20
0
–20
–40
–60
–80
–100
L
Log Frequency (Hz)
FIGURE 14. Latch-Up Prevention Circuit.
DGND
AGND
V
DD
V
CC
Digital
Power Supply
Analog
Power Supply
相關PDF資料
PDF描述
PCM1717 Stereo Audio DIGITAL-TO-ANALOG CONVERTER
PCM1717E Stereo Audio DIGITAL-TO-ANALOG CONVERTER
PCM1718 Stereo Audio DIGITAL-TO-ANALOG CONVERTER
PCM1718E Stereo Audio DIGITAL-TO-ANALOG CONVERTER
PCM1719 Stereo Audio DIGITAL-TO-ANALOG CONVERTER
相關代理商/技術參數
參數描述
PCM1716E 功能描述:音頻數/模轉換器 IC 24-Bit 96kHz Smplg CMOS D-S Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
PCM1716E 制造商:Texas Instruments 功能描述:24BIT DAC CMOS STEREO SMD 1716
PCM1716E/2K 功能描述:音頻數/模轉換器 IC 24-Bit 96kHz Smplg CMOS D-S Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
PCM1716E/2KG4 功能描述:音頻數/模轉換器 IC 24-Bit 96kHz Smplg CMOS D-S Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel
PCM1716E-3 制造商:Rochester Electronics LLC 功能描述:- Bulk