- 您現在的位置：買賣IC網 > PDF目錄5537 > OPA659IDRBR (Texas Instruments)IC OPAMP WBND VFB JFET IN 8-SON PDF資料下載
參數資料
| 型號： | OPA659IDRBR |
| 廠商： | Texas Instruments |
| 文件頁數： | 4/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP WBND VFB JFET IN 8-SON |
| 標準包裝： | 3,000 |
| 放大器類型： | J-FET |
| 電路數： | 1 |
| 轉換速率： | 2550 V/µs |
| 增益帶寬積： | 350MHz |
| -3db帶寬： | 650MHz |
| 電流 - 輸入偏壓： | 10pA |
| 電壓 - 輸入偏移： | 1000µV |
| 電流 - 電源： | 32mA |
| 電流 - 輸出 / 通道： | 70mA |
| 電壓 - 電源，單路/雙路(±)： | ±3.5 V ~ 6.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-VDFN 裸露焊盤 |
| 供應商設備封裝： | 8-SON 裸露焊盤（3x3） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
APPLICATION INFORMATION
Wideband, Noninverting Operation
OPA659
R
OUT
0.1 F
m
10 F
m
0.1 F
m
10 F
m
50
Load
W
50
Source
W
R
T
R
G
V
IN
V
OUT
R
F
+6V
-
6V
OPA659
R
OUT
0.1 F
m
10 F
m
0.1 F
m
10 F
m
50
Load
W
50
Source
W
R
T
V
IN
V
OUT
+6V
-
6V
SBOS342B – DECEMBER 2008 – REVISED AUGUST 2009 ............................................................................................................................................ www.ti.com
Voltage-feedback op amps can use a wide range of
resistor values to set the gain. To retain a controlled
The OPA659 is a very broadband, unity-gain stable,
frequency response for the noninverting voltage
voltage-feedback amplifier with a high impedance
amplifier of Figure 35, the parallel combination of RF
JFET-input stage. Its very high gain bandwidth
|| RG should always be less than 200. In the
product (GBP) of 350MHz can be used to either
noninverting configuration, the parallel combination of
deliver high signal bandwidths for low-gain buffers, or
RF || RG forms a pole with the parasitic input and
to deliver broadband, low-noise, transimpedance
board layout capacitance at the inverting input of the
bandwidth to photodiode-detector applications. The
OPA659. For best performance, this pole should be
OPA659 is designed to to provide very low distortion
at
a
frequency
greater
than
the
closed-loop
and accurate pulse response with low overshoot and
bandwidth for the OPA659. For this reason, a direct
ringing. To achieve the full performance of the
short from the output to the inverting input is
OPA659, careful attention to printed circuit board
recommended for the unity-gain follower application.
(PCB) layout and component selection are required,
Table 1 lists several recommended resistor values for
as discussed in the remaining sections of this data
noninverting gains with a 50
input/output match.
sheet.
Figure 34 shows the noninverting gain of +1 circuit;
Figure 35 shows the more general circuit used for
other noninverting gains. These circuits are used as
the basis for most of the noninverting gain Typical
Characteristics graphs. Most of the graphs were
characterized using signal sources with 50
driving
impedance,
and
with
measurement
equipment
presenting a 50
load impedance. In Figure 34, the
shunt resistor RT at VIN should be set to 50 to
match the source impedance of the test generator
and cable, while the series output resistor, ROUT, at
VOUT should also be set to 50 to provide matching
impedance for the measurement equipment load and
cable.
Generally,
data
sheet
voltage
swing
Figure 35. General Noninverting Test Circuit
specifications are measured at the output pin, VOUT,
Table 1. Resistor Values for Noninverting Gains
with 50
Input/Output Match
NONINVERTING
GAIN
RF
RG
RT
ROUT
+1
0
Open
49.9
+2
249
49.9
+5
249
61.9
49.9
+10
249
27.4
49.9
Figure 34. Noninverting Gain of +1 Test Circuit
12
Copyright 2008–2009, Texas Instruments Incorporated
Product Folder Link(s): OPA659
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4104ESA+T | IC OP AMP LOW NOISE 8-SOIC |
| P40-G240-WHX | CIRCUIT PROT 240MA 40VIMP TBU |
| RL0510S-R10-F | RES 0.10 OHM 1/6W 1% 0402 |
| 5MT 100-R | FUSE 100MA 250VAC 5X20 NORM |
| 5MT 1.6-R | FUSE 1.6A 250VAC 5X20 NORM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPA659IDRBT | 功能描述:高速運算放大器 650MHz unity gain stable JFET inp Amp RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| OPA659IDRBT | 制造商:Texas Instruments 功能描述:Operational Amplifier (Op-Amp) IC 制造商:Texas Instruments 功能描述:IC, OP-AMP, 350MHZ, 2550V/ us, SON-8 |
| OPA660 | 制造商:BB 制造商全稱:BB 功能描述:Wide Bandwidth OPERATIONAL TRANSCONDUCTANCE AMPLIFIER AND BUFFER |
| OPA660AP | 功能描述:IC OPAMP TRANSCOND 850MHZ 8DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品變化通告:Discontinuation 18/May/2012 標準包裝:2,000 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.42 V/µs 增益帶寬積:1.5MHz -3db帶寬:- 電流 - 輸入偏壓:15nA 電壓 - 輸入偏移:1000µV 電流 - 電源:116µA 電流 - 輸出 / 通道:100mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5 V，±0.9 V ~ 2.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:851 (CN2011-ZH PDF) 其它名稱:296-20930-2 |
| OPA660AU | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。