- 您現在的位置：買賣IC網 > PDF目錄3367 > OPA567AIRHGRG4 (Texas Instruments)IC OPAMP GP R-R 1.2MHZ 12VQFN PDF資料下載
參數資料
| 型號： | OPA567AIRHGRG4 |
| 廠商： | Texas Instruments |
| 文件頁數： | 20/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP R-R 1.2MHZ 12VQFN |
| 標準包裝： | 2,500 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 1.2 V/µs |
| 增益帶寬積： | 1.2MHz |
| 電流 - 輸入偏壓： | 1pA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 9mA |
| 電流 - 輸出 / 通道： | 2.4A |
| 電壓 - 電源，單路/雙路(±)： | 2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 12-VQFN 裸露焊盤 |
| 供應商設備封裝： | 12-VQFN-EP（5x5） |
| 包裝： | 帶卷 (TR) |
OPA567
SBOS287A
3
www.ti.com
ELECTRICAL CHARACTERISTICS: VS = +2.7V to +5.5V
Boldface limits apply over the specified temperature range, TA = –40°C to +85°C.
At TCASE = +25°C, RL = 1k, and connected to VS/2, unless otherwise noted.
NOTES:
(1) See typical characteristic,
Maximum Output Voltage vs Frequency.
(2) See typical characteristic,
Total Harmonic Distortion + Noise vs Frequency.
(3) Swing to the rail is measured in final test. Under those conditions, the AOL is derived from characterization.
(4) See Safe Operating Area (SOA) plots.
(5) See typical characteristic,
Overshoot vs Load Capacitance.
(6) See the
Typical Characteristics section. Higher frequency output impedance can affect frequency stability.
(7) External current limit setting resistor is required; see Figure 1.
(8) ILIMIT is the value of the desired current limit and is equal to 9800(ISET), where ISET is the current through the ISET pin. ILIMIT tolerance is proportional to the ratio of
ILIMIT/ISET. Errors from this parameter can be calibrated out—see the Applications Information section.
(9) VSET is a voltage reference that equals the difference between the voltage of the ISET pin and V–, and is referenced to the negative rail. Errors from this parameter
can be calibrated out—see the
Applications Information section.
OPA567
PARAMETER
CONDITION
MIN
TYP
MAX
UNITS
OFFSET VOLTAGE
Input Offset Voltage
VOS
IO = 0V, VS = +5V
±0.5
±2mV
vs Temperature
dVOS /dT
TA = –40°C to +85°C
±1.3
V/
°C
vs Power Supply
PSRR
VS = +2.7V to +5.5V, VCM = (V–) +0.55V
12
60
V/V
INPUT BIAS CURRENT
Input Bias Current
IB
±1
±10
pA
vs Temperature
(doubles every 10
°C)
Input Offset Current
IOS
±2
±10
pA
NOISE
Input Voltage Noise Density, f = 1kHz
en
12
nV/
√Hz
f = 0.1Hz to 10Hz
8
V
PP
Current Noise Density, f = 1kHz
in
0.6
fA/
√Hz
INPUT VOLTAGE RANGE
Common-Mode Voltage Range
VCM
Linear Operation
(V–) – 0.1
(V+) + 0.1
V
Common-Mode Rejection Ratio
CMRR
VS = +5V, –0.1V < VCM < 3.2V
80
100
dB
VS = +5V, –0.1V < VCM < 5.1V
60
80
dB
INPUT IMPEDANCE
Differential
1013 || 4.5
|| pF
Common-Mode
1013 || 9
|| pF
OPEN-LOOP GAIN
Open-Loop Voltage Gain
AOL
0.2V < VO < 4.8V, RL = 1k, VS = +5V
100
126
dB
0.3V < VO < 4.7V, RL = 1.15, VS = +5V
90
dB
FREQUENCY RESPONSE
Gain Bandwidth Product
GBW
1.2
MHz
Slew Rate
SR
G = +1, VO = 4.0V Step
1.2
V/
s
Full-Power Bandwidth(1)
See Typical Characteristics
Settling Time:
±0.1%
G = –1, VO = 4.0V Step
5
s
Total Harmonic Distortion + Noise(2)
THD+N
See Typical Characteristics
OUTPUT
Voltage Output Swing from Rail
VO
RL = 1k, AOL > 100dB
(V–) + 0.2
(VS) ± 0.02
(V+) – 0.2
V
IO = ±2A, VS = +5V, AOL > 80dB (3)
(V–) + 0.3
(VS) ± 0.2
(V+) – 0.3
V
Maximum Continuous Current Output: dc (4)
2.4
A
Capacitive Load Drive(5)
CLOAD
See Typical Characteristics
Closed-Loop Output Impedance(6)
RO
G = 1, dc
0.1
G = 1, f = 10kHz
0.44
G = 1, f = 1.2MHz
45
Output Disabled Output Impedance
12M || 570
|| pF
CURRENT LIMIT (ISET Pin)
Output Current Limit (7)
Externally Adjustable
±0.2 to ±2.2
A
Current Limit Equation(8)
ILIMIT = ISET 9800
A
RSET Equation
RSET = 9800 (1.18V/ILIMIT)
Current Limit Tolerance (8), Positive
ILIMIT = 1A
±3
±10
%
Negative
ILIMIT = 1A
±3
±15
%
VSET Tolerance(9)
(V–) + 1.05
(V–) + 1.18
(V–) + 1.3
V
ENABLE/SHUTDOWN INPUT
Enable Pin Bias Current
VSD = 0V
0.2
A
HIGH (Output enabled)
VSD
Pin Open or Forced HIGH
(V–) + 2.5
V
LOW (Output disabled)
VSD
Pin Forced LOW
(V–) + 0.8
V
Output Disable Time
RL = 1
0.5
s
Output Enable Time
RL = 1
15
s
相關PDF資料 |
PDF描述 |
|---|---|
| 2JQ 1-R | FUSE 1A 350V FAST 2AG 2JQ |
| 2JQ 150-R | FUSE 150MA 350V FAST 2AG 2JQ |
| MAX9610HELT+T | IC AMP CURR SENSE 100V/V 6UDFN |
| 2JQ 1.5-R | FUSE 1.5A 350V FAST 2AG 2JQ |
| 2JQ 1.25-R | FUSE 1.25A 350V FAST 2AG 2JQ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OPA567AIRHGT | 功能描述:運算放大器 - 運放 Rail-to-Rail I/O 2A Power Amplifier RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA567AIRHGT | 制造商:Texas Instruments 功能描述:IC OP-AMP GP R-R 1.2MHZ 12VQFN |
| OPA567AIRHGTG4 | 功能描述:運算放大器 - 運放 Rail-to-Rail I/O 2A Power Amplifier RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| OPA569 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Op Amp. Output Signal Swings Within 200mV of Rails at 2A Output Current |
| OPA569AIDWP | 功能描述:運算放大器 - 運放 2A Pwr Op Amp Rail-To-Rail I/O RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。