- 您現在的位置：買賣IC網 > PDF目錄359243 > MVTX2801 (Zarlink Semiconductor Inc.) Unmanaged 4-Port 1000 Mbps Ethernet Switch PDF資料下載
參數資料
| 型號： | MVTX2801 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | Unmanaged 4-Port 1000 Mbps Ethernet Switch |
| 中文描述： | 非托管4端口1000 Mbps以太網交換機 |
| 文件頁數： | 26/106頁 |
| 文件大?。?/td> | 1455K |
| 代理商： | MVTX2801 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁
MVTX2801
Data Sheet
26
Zarlink Semiconductor Inc.
Table 6 - Timing diagram for serial mode in LED interface
The status bits shown in here are flow control (FC), transmitting data (TxD), receiving data (RxD), link up (LNK),
speed (SP0 and SP1), full duplex (FDX), and collision (COL). Note that SP[1:0] is defined as 10 for 1 Gbps, 01 for
100 Mbps, and 00 for 10 Mbps.
Also note that U0-U7 represent user-defined sub-frames in which additional status information may be embedded.
We will see later that the MVTX2801 provides registers that can be written by the CPU to indicate this additional
status information as it becomes available.
9.3 Parallel Mode
In parallel mode, the following pins are utilized:
LED_PORT_SEL[3:0] - indicates which of the 4 Gigabit port status bytes is being read out
LED_PORT_SEL[7:4] - No use.
LED_PORT_SEL[9:8] - indicates which of the 2 user-defined status bytes is being read out
LED_BYTEOUT_[7:0] - provides 8 bits for 4 different port status indicators. Note that these bits are active
low.
By default, the system is in parallel mode. In parallel mode, the 10 status bytes are scanned in a continuous loop,
with one byte read out per clock cycle, and the appropriate port select bit asserted.
9.4 LED Control Registers
An LED Control Register can be used for programming the LED clock rate, sample hold time, and pattern in parallel
mode.
In addition, the MVTX2801 provides 8 registers called LEDUSER[7:0] for user-defined status bytes. During
operation, the CPU can write values to these registers, which will be read out to the LED interface output (serial or
parallel). Only LEDUSER[1:0] are used in parallel mode. The content of the LEDUSER registers will be sent out by
the LED serial shift logic, or in parallel mode, a byte at a time.
Because in parallel mode there are only two user-defined registers, LEDUSER[7:2] is shared with LEDSIG[7:2].
For LEDSIG[j], where j = 2, 3, ..., 6, the corresponding register is used for programming the LED pin
LED_BYTEOUT_[j]. The format is as follows:
7
4
3
0
COL
FDX
SP1
SP0
COL
FDX
SP1
SP0
P0
info
P1
info
P2
info
P3
info
P4
info
P5
info
P6
info
P7
info
U0
U1
U2
U3
U4
U5
U6
U7
LE_SYNCO
LE_DO
LE_CLKO
FC
TxD
RxD
LNK
SP0
SP1
FDX
COL
0
7
6
5
4
3
2
1
相關PDF資料 |
PDF描述 |
|---|---|
| MVTX2801AG | Unmanaged 4-Port 1000 Mbps Ethernet Switch |
| MVTX2802 | Managed 4-Port 1000 Mbps Ethernet Switch |
| MVTX2802AG | Managed 4-Port 1000 Mbps Ethernet Switch |
| MVTX2803 | Unmanaged 8-Port 1000 Mbps Ethernet Switch |
| MVTX2803AG | Unmanaged 8-Port 1000 Mbps Ethernet Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MVTX2801A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Unmanaged 4 port Gigabit Ethernet switch |
| MVTX2801AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Unmanaged 4-Port 1000 Mbps Ethernet Switch |
| MVTX2802 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Managed 4-Port 1000 Mbps Ethernet Switch |
| MVTX2802A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Managed 4 port Gigabit Ethernet switch |
| MVTX2802AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Managed 4-Port 1000 Mbps Ethernet Switch |
發布緊急采購，3分鐘左右您將得到回復。