- 您現(xiàn)在的位置：買賣IC網 > PDF目錄359228 > MT312T-Y (Marktech Optoelectronics) 2x4mm Rectangular LED Lamps PDF資料下載
參數資料
| 型號： | MT312T-Y |
| 廠商： | Marktech Optoelectronics |
| 英文描述： | 2x4mm Rectangular LED Lamps |
| 中文描述： | 2x4mm矩形發(fā)光二極管 |
| 文件頁數： | 34/90頁 |
| 文件大?。?/td> | 318K |
| 代理商： | MT312T-Y |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁
MT312
DiSEqC Control
34
B1:
End of message interrupt (reset on read).
Bit B1 indicates a new message has been received. The end of a message is identi
fi
ed by a silent
period of about 6 ms following a byte. The end-of-message interrupt bit makes it easier for the host
processor to read DiSEqC
data from MT312. Instead of reading a byte at a time, it can read the
message as a whole.
It is important to note that MT312 does not stop accepting bytes after setting end-of-message
interrupt. It will receive new messages, if any, whilst the current message is being read by the host.
Since 2-wire bus read rate is higher than the byte receive rate, there is no reason for FIFO buffer
over
fl
ow. After every received message there will be an interrupt.
B0:
End of byte interrupt (reset on read).
Bit B0 is set when a new byte is received. The host may wish to ignore byte interrupts and opt to read
received messages, as described below.
It is important to note that MT312 does not stop accepting bytes after setting end-of-message
interrupt. It will receive new messages, if any, whilst the current message is being read by the host.
Since 2-wire bus read rate is higher than the byte receive rate, there is no reason for FIFO buffer
over
fl
ow.
After every received message there will be an interrupt.
5.3.2 DiSEqCM 2 Status Indicators. Register 119 (R)
B7-5:
DISEQC2 Finite State Machine State. This is primarily for debugging the device.
B4-0:
Silent period since last received bit, in multiples of 16 ms.
Bits B4-0 is reset to zero when a bit is received. When this 5-bit number reaches 176, the interrupt bit
B3 of DISEQC2 INT register is set. This is saturated to 31. Hence if the total period exceeds 496
ms this counter will continue to indicate 31.
5.3.3 DiSEqC 2 FIFO. Register 120 (R)
Odd byte read of register 120:
Even byte read of register 120:
This FIFO contains data bytes and parity bits collected. This can hold a maximum of 8 data bytes, 8 parity bits
and 8 parity error bits. The parity error bit is de
fi
ned as the inverse of the exclusive-OR combination (or
modulo-2 addition) of all 9 bits (8 data and 1 parity). This bit will be zero when there is no parity error.
NAME
ADR
B7
B6
B5
B4
B3
B2
B1
B0
Def
hex
DISEQC2 STAT
119
DISEQC2 STATUS[7:0]
R
00
NAME
ADR
B7
B6
B5
B4
B3
B2
B1
B0
Def
hex
DISEQC2 FIFO
120
DISEQC2 FIFO[7:0]
R
00
相關PDF資料 |
PDF描述 |
|---|---|
| MT3371BN | Wide Dynamic Range DTMF Receiver |
| MT3371BS | Wide Dynamic Range DTMF Receiver |
| MT3371BNR | Wide Dynamic Range DTMF Receiver |
| MT3371BSR1 | Wide Dynamic Range DTMF Receiver |
| MT3371BSR | Wide Dynamic Range DTMF Receiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT313024 | 制造商:TE Connectivity 功能描述: |
| MT3130C4 | 制造商:TE Connectivity 功能描述: |
| MT3133-Y | 制造商:MARKTECH 制造商全稱:Marktech Corporate 功能描述:Standard 10mm LED Lamps |
| MT3146-Y | 制造商:MARKTECH 制造商全稱:Marktech Corporate 功能描述:1X5 RECTANGULAR LED LAMPS |
| MT3149 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:六路閃燈IC，可選外圍元件改閃燈變順序及狀態(tài)。 |
發(fā)布緊急采購，3分鐘左右您將得到回復。