- 您現在的位置：買賣IC網 > PDF目錄299520 > MSA-2743 100 MHz - 6000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | MSA-2743 |
| 元件分類： | 放大器 |
| 英文描述： | 100 MHz - 6000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| 封裝： | PLASTIC, SOT-343, SC70, 4 PIN |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 220K |
| 代理商： | MSA-2743 |
11
from the circuit, a typical value
for R3 is 1K
Ω. Rc is a feedback
element that keeps I
d constant.
The value of Rc is approximated
by assuming a 0.5V drop across it;
see equation below. For 50 mA I
d,
5Volt Vcc bias, a typical value for
R1 is 560
Ω and R2 is 110Ω. A CAD
program such as Avago Tech-
nologies ADS is recommended
to determine the values of R1 and
R2 at other bias levels. The value
of the RF choke should be large
compared to 50
Ω, typical value
for a 1.9 GHz amplifier would be
22 nH. The DC blocking capacitors
are calculated as described above.
A typical value for C3 would be
1.0 uF.
Rc = 0.5
Ω
I
d
The active bias solution will only
require about a 1.3V difference
between Vcc and V
d for good bias
stability over temperature. For
more details on the active bias
circuit please refer to application
note AN-A003 Biasing MODAMP
MMICs.
RFC
Vd
C2
C3
Vcc
27x
C1
Rc
R3
R2
R1
Figure 4. Active Bias Circuit.
1.9 GHz Design
To illustrate the simplicity of using
the MSA-2743, a 1.9 GHz ampli-
fier for PCS type applications is
presented. The amplifier uses a
5.25V, 50 mA supply. The input and
output of the MSA-2743 is already
well matched to 50
Ω and no ad-
ditional matching is needed.
RFC=
22 nH
C2=18 pF
C3=330 pF
Vcc=5.25V
27x
C1=18 pf
Rc=27
Ω
Figure 5. Schematic of 1.9 GHz Circuit.
A schematic diagram of the
complete 1.9 GHz circuit with DC
biasing is shown in Figure 5. DC
bias is applied to the MSA-2743
through the RFC at the RF Output
pin. The power supply connection
is bypassed to ground with capaci-
tor C3. Provision is made for an
additional bypass capacitor, C4,
to be added to the bias line near
the +5 volt connection. C4 will not
normally be needed unless several
stages are cascaded using a com-
mon power supply.
The input terminal of the
MSA-2743 is not at ground
potential, an input DC blocking
capacitor is needed.
The values of the DC blocking and
RF bypass capacitors should be
chosen to provide a small reac-
tance (typically < 5 ohms) at the
lowest operating frequency. For
this 1.9 GHz design example, 18 pF
capacitors with a reactance of 4.5
ohms are adequate. The reactance
of the RF choke (RFC) should be
high (i.e., several hundred ohms)
at the lowest frequency of op-
eration. A 22 nH inductor with a
reactance of 262 ohms at 1.9 GHz
is sufficiently high to minimize the
loss from circuit loading.
Table 2. Component Parts List for the
MSA-2743 Amplifier at 1.9 GHz.
R1
7
Ωchipresistor
RFC
nHLL1608-FHN
C1,C
18pFchipcapacitor
C3
330pFchipcapacitor
The completed 1.9 GHz amplifier
for this example with all compo-
nents and SMA connectors as-
sembled is shown in Figure 6.
IN
OUT
Vcc
MSA-2X43
IP 4/00
Agilent Technologies
27x
Figure 6. Complete 1.9 GHz Amplifier.
Performance of MSA-2743 1.9 GHz
Amplifier
The amplifier is biased at a Vcc of
5.25 volts, I
d of 50 mA. The mea-
sured gain, noise figure, input and
output return loss of the complet-
ed amplifier is shown in Figure 7.
Noise figure is a nominal 4.0 to
4.1 dB from 1800 through 2000
MHz. Gain is a minimum of 15.1
dB from 1800 MHz through 2000
MHz. The amplifier output inter-
cept point (OIP3) was measured at
a nominal +28.5 dBm. P
-1dB mea-
sured +15.0 dBm.
FREQUENCY (GHz)
Figure 7. Gain, Noise Figure, Input and Output
Return Loss Results.
GAIN,
NOISE
FIGURE,
INPUT
and
OUTPUT
RETURN
LOSS
(dB)
1.5
2.3
1.9
1.7
2.1
20
10
0
-10
-20
-30
Figure 7. Gain, Noise Figure, Input and Output
Return Loss Results.
相關PDF資料 |
PDF描述 |
|---|---|
| MSC1020 | 14 pin DIP, 5.0 Volt, HCMOS/TTL, Clock Oscillator |
| MSC1150M | 14 pin DIP, 5.0 Volt, HCMOS/TTL, Clock Oscillator |
| MSC1356-01 | QUARTZ CRYSTAL RESONATOR, 6.312 MHz |
| MSC26000013 | 26 CONTACT(S), MALE, STRAIGHT TELECOM AND DATACOM CONNECTOR, SURFACE MOUNT |
| MSC3005 | 14 pin DIP, 5.0 Volt, HCMOS/TTL, Clock Oscillator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MSA-2743-BLK | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Cascadable Silicon Bipolar Gain Block MMIC Amplifier |
| MSA-2743-TR1 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Cascadable Silicon Bipolar Gain Block MMIC Amplifier |
| MSA-2743-TR2 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Cascadable Silicon Bipolar Gain Block MMIC Amplifier |
| MSA28 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:MOLDED SSOP |
| MSA2805D | 制造商:CRANE 制造商全稱:CRANE 功能描述:DC/DC CONVERTERS 28 VOLT INPUT |
發布緊急采購，3分鐘左右您將得到回復。