參數資料
型號: MR83C154XXX-16P883
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44
封裝: LCC-44
文件頁數: 56/142頁
文件大小: 61013K
代理商: MR83C154XXX-16P883
20
XMEGA B3 [DATASHEET]
8074D–AVR–08/2013
10.
System Clock and Clock options
10.1
Features
Fast start-up time
Safe run-time clock switching
Internal oscillators:
32MHz run-time calibrated oscillator
2MHz run-time calibrated oscillator
32.768kHz calibrated oscillator
32kHz ultra low power (ULP) oscillator with 1kHz output
External clock options
0.4MHz - 16MHz crystal oscillator
32.768kHz crystal oscillator
External clock
PLL with 20MHz - 128MHz output frequency
Internal and external clock options and 1x to 31x multiplication
Lock detector
Clock prescalers with 1x to 2048x division
Fast peripheral clocks running at 2 and 4 times the CPU clock
Automatic run-time calibration of internal oscillators
External oscillator and PLL lock failure detection with optional non-maskable interrupt
10.2
Overview
Atmel AVR XMEGA devices have a flexible clock system supporting a large number of clock sources. It incorporates
both accurate internal oscillators and external crystal oscillator and resonator support. A high-frequency phase locked
loop (PLL) and clock prescalers can be used to generate a wide range of clock frequencies. A calibration feature (DFLL)
is available, and can be used for automatic run-time calibration of the internal oscillators to remove frequency drift over
voltage and temperature. An oscillator failure monitor can be enabled to issue a non-maskable interrupt and switch to the
internal oscillator if the external oscillator or PLL fails.
When a reset occurs, all clock sources except the 32kHz ultra low power oscillator are disabled. After reset, the device
will always start up running from the 2MHz internal oscillator. During normal operation, the system clock source and
prescalers can be changed from software at any time.
Figure 10-1 on page 21 presents the principal clock system in the XMEGA B3 family of divices. Not all of the clocks need
to be active at a given time. The clocks for the CPU and peripherals can be stopped using sleep modes and power
reduction registers, as described in “Power Management and Sleep Modes” on page 23.
相關PDF資料
PDF描述
MQ83C154CXXX-16P883 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQFP44
MD83C154XXX-20P883D 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40
MR80C154-25P883D 8-BIT, 25 MHz, MICROCONTROLLER, CQCC44
MQ83C154XXX-36/883R 8-BIT, MROM, 36 MHz, MICROCONTROLLER, CQFP44
MQ80C154-20P883 8-BIT, 20 MHz, MICROCONTROLLER, CQFP44
相關代理商/技術參數
參數描述
MR850 功能描述:整流器 3.0 Amp 50 Volt 150ns RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel
MR850 _AY _10001 制造商:PanJit Touch Screens 功能描述:
MR850 R0 制造商:SKMI/Taiwan 功能描述:Diode Switching 50V 3A 2-Pin DO-201AD T/R
MR850_ R2 _10001 制造商:PanJit Touch Screens 功能描述:
MR850_09 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:SOFT RECOVERY, FAST SWITCHING PLASTIC RECTIFIER