- 您現在的位置：買賣IC網 > PDF目錄25635 > MR80C52XXX-20:R (TEMIC SEMICONDUCTORS) 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 PDF資料下載
參數資料
| 型號： | MR80C52XXX-20:R |
| 廠商： | TEMIC SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 |
| 文件頁數： | 50/198頁 |
| 文件大?。?/td> | 4822K |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁
143
8111C–MCU Wireless–09/09
AT86RF231
Generally, the Antenna Diversity algorithm is enabled with register bit ANT_DIV_EN (register
0x0D, ANT_DIV) set. In this case the control of an antenna diversity switch must be enabled by
register bit ANT_EXT_SW_EN (register 0x0D, ANT_DIV). The internal connection to digital
ground of the control pins pin 9 (DIG1) and pin 10 (DIG2) is disabled (refer to section 4.2), and
they feed the antenna switch signal and its inverse to the differential inputs of the RF Switch
(SW1).
Upon reception of a frame the AT86RF231 selects one antenna during preamble field detection.
The selected antenna is then indicated by register bit ANT_SEL (register 0x0D, ANT_DIV). After
the frame reception is completed, the antenna selection continues searching for new frames on
both antennas. However, the register bit ANT_SEL maintains its previous value (from the last
received frame) until a new SHR has been found, and the selection algorithm locked into one
antenna again. At this time the register bit ANT_SEL is updated again.
For transmission the antenna defined by register bits ANT_CTRL (register 0x0D, ANT_DIV) is
selected. If for example the same antenna is to be used for transmission as being selected for
reception, the antenna must be set using register bits ANT_CTRL, based on the value read from
register bit ANT_SEL. It is recommended t o read register bit ANT_SEL after
IRQ_2 (RX_START).
The autonomous search and selection allows the use of Antenna Diversity during reception
even if the microcontroller does currently not control the radio transceiver, for instance in
Extended Operating Mode.
A microcontroller defined selection of a certain antenna can be done by disabling the automated
Antenna Diversity algorithm (ANT_DIV_EN = 0) and selecting one antenna using register bit
ANT_CTRL.
If the AT86RF231 is not in a receive or transmit state, it is recommended to disable register bit
ANT_EXT_SW_EN to reduce the power consumption or avoid leakage current of an external RF
switch, especially during SLEEP state. If register bit ANT_EXT_SW_EN = 0, output pins
DIG1/DIG2 are pulled-down to digital ground.
11.4.3
Antenna Diversity Sensitivity Control
Due to a different receive algorithm used by the Antenna Diversity algorithm, the correlator
threshold of the receiver has to be adjusted. It is recommended to set register bits PDT_THRES
(register 0x0A, RX_CTRL) to 3.
11.4.4
Register Description
Register 0x0A (RX_CTRL):
The RX_CTRL controls the sensitivity of the Antenna Diversity Mode
Bit [7:4] - Reserved
Bit
7
6
5
4
3
2
1
0
+0x0A
Reserved
PDT_THRES
RX_CTRL
Read/Write
R/W
Reset Value
1
0
1
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| MQ80C32E-30/883 | 8-BIT, 30 MHz, MICROCONTROLLER, CQFP44 |
| MR80C52CXXX-16/883R | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
| MR80C52TXXX-16SB | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
| MD83C154TXXX-L16P883D | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
| MD83C154XXX-L16P883D | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR80C86 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86/B | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris Corporation 功能描述:Microprocessor, 16 Bit, 44 Pin, Ceramic, LCC |
| MR80C86-2 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86-2/883 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MR80C86-2/B | 制造商:Intersil Corporation 功能描述:MPU 80C86 16BIT CMOS 8MHZ 44PLCC - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。