- 您現在的位置：買賣IC網 > PDF目錄25635 > MR80C52XXX-20:R (TEMIC SEMICONDUCTORS) 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 PDF資料下載
參數資料
| 型號： | MR80C52XXX-20:R |
| 廠商： | TEMIC SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44 |
| 文件頁數： | 130/198頁 |
| 文件大小： | 4822K |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁當前第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁
37
8111C–MCU Wireless–09/09
AT86RF231
This state can only be entered by setting pin 11 (SLP_TR) = H while the radio transceiver is in
the RX_ON state, refer to Section 7.1.2.5 “RX_ON and BUSY_RX - RX Listen and Receive
State” on page 36. Pin 17 (CLKM) is disabled 35 clock cycles after the rising edge at the
SLP_TR pin, see Figure 6-16 on page 28. This allows the microcontroller to complete its power-
down sequence.
Note that for CLKM clock rates 250 kHz and 62.5 kHz the master clock signal CLKM is switched
off immediately after rising edge of SLP_TR.
The reception of a frame shall be indicated to the microcontroller by an interrupt indicating the
receive status. CLKM is turned on again, and the radio transceiver enters the BUSY_RX state
on page 28). Using this radio transceiver state it is essential to enable at least one interrupt indi-
cating the reception status. Otherwise the reception of a frame does not activate CLKM and the
microcontroller remains in its power-down mode.
After the receive transaction has been completed, the radio transceiver enters the RX_ON state.
The radio transceiver only reenters the RX_ON_NOCLK state, when the next rising edge of pin
SLP_TR pin occurs.
If the AT86RF231 is in the RX_ON_NOCLK state, and pin SLP_TR is reset to logic low, it enters
the RX_ON state, and it starts to supply clock on the CLKM pin again.
In states RX_ON_NOCLK and RX_ON, the radio transceiver current consumptions are equiva-
lent. However, the RX_ON_NOCLK current consumption is reduced by the current required for
driving pin 17 (CLKM).
Note
A reset in state RX_ON_NOCLK requires further to reset pin SLP_TR to logic low, otherwise
the radio transceiver enters directly the SLEEP state.
7.1.2.7
BUSY_TX - Transmit State
A transmission can only be initiated in state PLL_ON. There are two ways to start a
transmission:
Rising edge of pin 11 (SLP_TR)
TX_START command to register bits TRX_CMD (register 0x02, TRX_STATE).
Either of these causes the radio transceiver into the BUSY_TX state.
During the transition to BUSY_TX state, the PLL frequency shifts to the transmit frequency. The
actual transmission of the first data chip of the SHR starts after 16 s to allow PLL settling and
PA ramp-up, see Figure 7-6 on page 41. After transmission of the SHR, the Frame Buffer con-
tent is transmitted. In case the PHR indicates a frame length of zero, the transmission is aborted.
After the frame transmission has completed, the AT86RF231 automatically turns off the power
amplifier, generates an IRQ_3 (TRX_END) interrupt and returns into PLL_ON state.
7.1.2.8
RESET State
The RESET state is used to set back the state machine and to reset all registers of the
AT86RF231 to their default values, exception are register bits CLKM_CTRL (register 0x03,
TRX_CTRL_0). These register bits require a specific treatment, for details see Section 9.6.4
相關PDF資料 |
PDF描述 |
|---|---|
| MQ80C32E-30/883 | 8-BIT, 30 MHz, MICROCONTROLLER, CQFP44 |
| MR80C52CXXX-16/883R | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
| MR80C52TXXX-16SB | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
| MD83C154TXXX-L16P883D | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
| MD83C154XXX-L16P883D | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR80C86 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86/B | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris Corporation 功能描述:Microprocessor, 16 Bit, 44 Pin, Ceramic, LCC |
| MR80C86-2 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86-2/883 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MR80C86-2/B | 制造商:Intersil Corporation 功能描述:MPU 80C86 16BIT CMOS 8MHZ 44PLCC - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。