
175
8111C–MCU Wireless–09/09
AT86RF231
20. Appendix A - Continuous Transmission Test Mode
20.1
Overview
The AT86RF231 offers a Continuous Transmission Test Mode to support final application / pro-
duction tests as well as certification tests. Using this test mode the radio transceiver transmits
continuously a previously transferred frame (PRBS mode) or a continuous wave signal (CW
mode).
In CW mode two different signal frequencies per channel can be transmitted:
f
1 = fCH + 0.5 MHz
f
2 = fCH - 0.5 MHz
Here f
CH is the channel center frequency programmed by register 0x08 (PHY_CC_CCA).
Note, in CW mode it is not possible to transmit an RF signal directly on the channel center
frequency.
to use a frame of maximum length (127 bytes) and arbitrary PSDU data for the PRBS mode. The
SHR and the PHR are not transmitted. The transmission starts with the PSDU data and is
repeated continuously.
20.2
Configuration
Before enabling Continuous Transmission Test Mode all register configurations shall be done as
follow:
TX channel setting (optional)
TX output power setting (optional)
Mode selection (PRBS / CW)
A register access to register 0x36 and 0x1C enables the Continuous Transmission Test Mode.
The transmission is started by enabling the PLL (TRX_CMD = PLL_ON) and writing the
TX_START command to register 0x02.
Even for CW signal transmission it is required to write valid PSDU data to the Frame Buffer. For
PRBS mode it is recommended to write a frame of maximum length.
informs about writing (W) or reading (R) a register or the Frame Buffer.
Table 20-1.
Continuous Transmission Programming Sequence.
Step
Action
Register
R/W
Value
Description
1
RESET
Reset AT86RF231
2
Register Access
0X0E
W
0x01
Set IRQ mask register, enable IRQ_0 (PLL_LOCK)
3
Register Access
0x04
W
0x00
Disable TX_AUTO_CRC_ON
4
Register Access
0x02
W
0x03
Set radio transceiver state TRX_OFF
5
Register Access
0x03
W
0x01
Set clock at pin 17 (CLKM)
6
Register Access
0x08
W
0x33
Set IEEE 802.15.4 CHANNEL, e.g. 19
7
Register Access
0x05
W
0x00
Set TX output power, e.g. to Pmax