參數資料
型號: MPC755CRX400LE
廠商: Freescale Semiconductor
文件頁數: 37/56頁
文件大?。?/td> 0K
描述: IC MPU 32BIT 400MHZ PPC 360-CBGA
標準包裝: 44
系列: MPC7xx
處理器類型: 32-位 MPC7xx PowerPC
速度: 400MHz
電壓: 2V
安裝類型: 表面貼裝
封裝/外殼: 360-BBGA,F(xiàn)CCBGA
供應商設備封裝: 360-FCCBGA(25x25)
包裝: 托盤
MPC755 RISC Microprocessor Hardware Specifications, Rev. 8
42
Freescale Semiconductor
System Design Information
should be left unconnected by the system. If all parity generation is disabled through HID0, then all parity
checking should also be disabled through HID0, and all parity pins may be left unconnected by the system.
The L2 interface does not require pull-up resistors.
8.7
JTAG Configuration Signals
Boundary scan testing is enabled through the JTAG interface signals. The TRST signal is optional in the
IEEE 1149.1 specification, but is provided on all processors that implement the PowerPC architecture.
While it is possible to force the TAP controller to the reset state using only the TCK and TMS signals, more
reliable power-on reset performance will be obtained if the TRST signal is asserted during power-on reset.
Because the JTAG interface is also used for accessing the common on-chip processor (COP) function,
simply tying TRST to HRESET is not practical.
The COP function of these processors allows a remote computer system (typically, a PC with dedicated
hardware and debugging software) to access and control the internal operations of the processor. The COP
interface connects primarily through the JTAG port of the processor, with some additional status
monitoring signals. The COP port requires the ability to independently assert HRESET or TRST in order
to fully control the processor. If the target system has independent reset sources, such as voltage monitors,
watchdog timers, power supply failures, or push-button switches, then the COP reset signals must be
merged into these signals with logic.
The arrangement shown in Figure 24 allows the COP port to independently assert HRESET or TRST,
while ensuring that the target can drive HRESET as well. If the JTAG interface and COP header will not
be used, TRST should be tied to HRESET through a 0-
Ω isolation resistor so that it is asserted when the
system reset signal (HRESET) is asserted ensuring that the JTAG scan chain is initialized during power-on.
While Freescale recommends that the COP header be designed into the system as shown in Figure 24, if
this is not possible, the isolation resistor will allow future access to TRST in the case where a JTAG
interface may need to be wired onto the system in debug situations.
The COP header shown in Figure 24 adds many benefits—breakpoints, watchpoints, register and memory
examination/modification, and other standard debugger features are possible through this interface—and
can be as inexpensive as an unpopulated footprint for a header to be added when needed.
The COP interface has a standard header for connection to the target system, based on the 0.025"
square-post 0.100" centered header assembly (often called a Berg header). The connector typically has pin
14 removed as a connector key.
相關PDF資料
PDF描述
IDT7054L35PRF8 IC SRAM 32KBIT 35NS 128TQFP
MPC755BRX300LE IC MPU 32BIT 300MHZ PPC 360-CBGA
IDT7008L20PFI8 IC SRAM 512KBIT 20NS 100TQFP
HMM28DREF CONN EDGECARD 56POS .156 EYELET
FMC36DRES-S93 CONN EDGECARD 72POS .100 EYELET
相關代理商/技術參數
參數描述
MPC755CRX400TE 功能描述:微處理器 - MPU GF RV2.84A-40C 360CBGA RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC755CVT350LE 功能描述:微處理器 - MPU GF RV2.8,4A,105C,6W RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC755CVT400LE 功能描述:微處理器 - MPU GF RV2.84A105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC76 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Metal Plate Cement Resistors
MPC76-0.05HK 制造商:FUKUSHIMA 功能描述: