參數資料
型號: MPC5603PEFMLQ7
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 64 MHz, MICROCONTROLLER, PQFP144
封裝: 20 X 20 MM, 1.40 MM HEIGHT, 0.50 MM PITCH, ROHS COMPLIANT, LQFP-144
文件頁數: 33/72頁
文件大?。?/td> 1382K
代理商: MPC5603PEFMLQ7
MPC5604P Microcontroller Data Sheet, Rev. 4
Freescale Semiconductor
39
3.12
16 MHz RC Oscillator Electrical Characteristics
fUL
D
Frequency un-LOCK range
-18
18
% fsys
fCS
fDS
D
Modulation Depth
Center spread
±0.25
±4.012
%fsys
Down Spread
-0.5
-8.0
fMOD
D
Modulation frequency13
100
kHz
1 All values given are initial design targets and subject to change.
2 Considering operation with PLL not bypassed.
3 “Loss of Reference Frequency” window is the reference frequency range outside of which the PLL is in self clocked
mode.
4 Self clocked mode frequency is the frequency that the PLL operates at when the reference frequency falls outside
the fLOR window.
5 f
VCO self clock range is 20-150 MHz. fSCM represents fSYS after PLL output divider (ERFD) of 2 through 16 in
enhanced mode.
6 This value is determined by the crystal manufacturer and board design.
7 Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum
fSYS. Measurements are made with the device powered by filtered supplies and clocked by a stable external clock
signal. Noise injected into the PLL circuitry via VDDPLL and VSSPLL and variation in crystal oscillator frequency
increase the CJITTER percentage for a given interval.
8 Proper PC board layout procedures must be followed to achieve specifications.
9 Values are with frequency modulation disabled. If frequency modulation is enabled, jitter is the sum of C
JITTER and
either fCS or fDS (depending on whether center spread or down spread modulation is enabled).
10 This value is determined by the crystal manufacturer and board design. For 4 MHz to 20 MHz crystals specified for
this PLL, load capacitors should not exceed these limits.
11 This specification applies to the period required for the PLL to relock after changing the MFD frequency control bits
in the synthesizer control register (SYNCR).
12 This value is true when operating at frequencies above 60 MHz, otherwise f
CS is 2% (above 64 MHz).
13 Modulation depth will be attenuated from depth setting when operating at modulation frequencies above 50kHz.
Table 24. 16 MHz RC Oscillator Electrical Characteristics
Symbol
Parameter
Conditions
Min
Typ
Max
Unit
fRC
P
RC oscillator frequency
TA = 25 °C
16
MHz
Δ
RCMVAR
P
Fast internal RC oscillator variation in
temperature and supply with respect to
fRC at TA = 55 °C in high-frequency
Configuration
-5
5
%
Δ
RCMTRIM
P
Post Trim Accuracy: The variation of the
PTF1 from the 16 MHz
1 PTF = Post Trimming Frequency: The frequency of the output clock after trimming at typical supply voltage and
temperature
TA = 25 °C
-1
1
%
Table 23. PLLMRFM Electrical Specifications1
(VDDPLL = 3.0 V to 3.6 V, VSS = VSSPLL = 0 V, TA = TL to TH) (continued)
Symbol
Parameter
Conditions
Value
Unit
min
max
相關PDF資料
PDF描述
MPC5603PGF0MLL4 32-BIT, FLASH, 40 MHz, MICROCONTROLLER, QFP100
MPC5603PGF0MLL4R 32-BIT, FLASH, 40 MHz, MICROCONTROLLER, QFP100
MPC5603PGF0MLQ6R 32-BIT, FLASH, 64 MHz, MICROCONTROLLER, QFP144
MPC5603PGF0VLL6 32-BIT, FLASH, 64 MHz, MICROCONTROLLER, PQFP100
MPC5603PGF0VLL4R 32-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
MPC5603PFF0MLL7R 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:microcontroller units (MCUs)
MPC5603PFF0MLQ7R 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:microcontroller units (MCUs)
MPC5603PFF0VLL7R 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:microcontroller units (MCUs)
MPC5603PFF0VLQ7R 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:microcontroller units (MCUs)
MPC5604B 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:MPC5604B/C Microcontroller Data Sheet