參數(shù)資料
型號: MK51DX256ZCMC10
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA121
封裝: 8 X 8 MM, MAPBGA-121
文件頁數(shù): 22/72頁
文件大?。?/td> 1005K
代理商: MK51DX256ZCMC10
Table 15. MCG specifications (continued)
Symbol
Description
Min.
Typ.
Max.
Unit
Notes
Jcyc_pll
PLL period jitter (RMS)
fvco = 48 MHz
fvco = 100 MHz
120
50
ps
Jacc_pll
PLL accumulated jitter over 1s (RMS)
fvco = 48 MHz
fvco = 100 MHz
1350
600
ps
Dlock
Lock entry frequency tolerance
± 1.49
± 2.98
%
Dunl
Lock exit frequency tolerance
± 4.47
± 5.97
%
tpll_lock
Lock detector detection time
0.15 +
1075(1/
fpll_ref)
ms
1. The startup time is defined as the time between the IRC being enabled, either by the MCG or by the IRCLKEN bit being
set, and the first edge of the internal reference clock.
2. This parameter is measured with the internal reference (slow clock) being used as a reference to the FLL (FEI clock
mode).
3. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=0.
4. The resulting system clock frequencies should not exceed their maximum specified values. The DCO frequency deviation
(
Δfdco_t) over voltage and temperature should be considered.
5. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=1.
6. The resulting clock frequency must not exceed the maximum specified clock frequency of the device.
7. This specification was obtained at TBD frequency.
8. This specification applies to any time the FLL reference source or reference divider is changed, trim value is changed,
DMX32 bit is changed, DRS bits are changed, or changing from FLL disabled (BLPE, BLPI) to FLL enabled (FEI, FEE,
FBE, FBI). If a crystal/resonator is being used as the reference, this specification assumes it is already running.
9. Excludes any oscillator currents that are also consuming power while PLL is in operation.
10. This specification was obtained using a Freescale developed PCB. PLL jitter is dependent on the noise characteristics of
each PCB and results will vary.
11. This specification applies to any time the PLL VCO divider or reference divider is changed, or changing from PLL disabled
(BLPE, BLPI) to PLL enabled (PBE, PEE). If a crystal/resonator is being used as the reference, this specification assumes
it is already running.
6.3.2 Oscillator electrical specifications
This section provides the electrical characteristics of the module.
6.3.2.1 Oscillator DC electrical specifications
Table 16. Oscillator DC electrical specifications
Symbol
Description
Min.
Typ.
Max.
Unit
Notes
VDD
Supply voltage
1.71
3.6
V
Table continues on the next page...
Peripheral operating requirements and behaviors
K51 Sub-Family Data Sheet Data Sheet, Rev. 5, 5/2011.
Freescale Semiconductor, Inc.
Preliminary
29
相關PDF資料
PDF描述
MK51N512CLQ100R 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
MK51N512CMD100R 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA144
MK51N256CLQ100 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
MK51N512CMD100 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA144
MK51N512CLQ100 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
相關代理商/技術參數(shù)
參數(shù)描述
MK51DX256ZCYY10 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Integrated measurement engine, Ethernet and LCD
MK51N256CLQ100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
MK51N256CMD100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
MK51N512CLL100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
MK51N512CLQ100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz