- 您現在的位置：買賣IC網 > PDF目錄65811 > MK2049-01SILF (INTEGRATED DEVICE TECHNOLOGY INC) 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 PDF資料下載
參數資料
| 型號： | MK2049-01SILF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| 封裝： | 0.300 INCH, SOIC-20 |
| 文件頁數： | 6/10頁 |
| 文件大小： | 125K |
| 代理商： | MK2049-01SILF |
MK2049-01
Communications Clock PLL
MDS 2049-01 K
5
Revision 091801
Integrated Circuit Systems, Inc. 525 Race Street San Jose CA 95126 (408)295-9800tel www.icst.com
PC Board Layout
=connect to VDD
=connect to GND
V
G
1
16
2
3
4
15
14
13
5
6
8
12
11
10
9
18
20
cap
resist.
cap
G
V
17
V
cap
resist.
cap
LAYOUT AND EXTERNAL COMPONENTS
A proper board layout is critical to the successful use of the MK2049. In particular, the CAP1 and CAP2 pins are very
sensitive to noise and leakage (CAP2 at pin 18 is the most sensitive). Traces must be as short as possible and the two
capacitors and resistor must be mounted next to the device as shown below. The capacitor shown between pins 15
and 17, and the one between pins 5 and 7 are the power supply decoupling capacitors. The high frequency output
clocks on pins 8 and 9 should have a series termination of 33
connected close to the pin. Additional improvements
will come from keeping all components on the same side of the board, minimizing vias through other signal layers, and
routing other signals away from the MK2049.
You may also refer to MAN05 for additional suggestions on layout of
the crystal section.
The crystal traces should include pads for small capacitors from X1 and X2 to ground; these are used to adjust the
stray capacitance of the board to match the crystal load capacitance. The typical telecom reference frequency is
accurate to much less than 1 ppm, so the MK2049 may lock and run properly even if the board capacitance is not
adjusted with these fixed capacitors. However, ICS MicroClock recommends that the adjustment capacitors be
included to minimize the effects of variation in individual crystals, temperature, and aging. The value of these
capacitors (typically 0-4 pF) is determined once for a given board layout, using the procedure described later in this
section, titled “Determining the Crystal Frequency Adjustment Capacitors”.
The MK2049-01 requires a minimum number of external components for proper operation. Decoupling capacitors of
0.01F must be connected between VDD and GND pins close to the chip (especially pins 4 and 7, 15 and 17), and
33
series terminating resistors should be used on clock outputs with traces longer than 1 inch (assuming 50
traces). The loop filter components should be connected as close to the chip as possible. Refer to the next section
for more information.
Figure 1. MK2049-01 Layout Example
7
cap
G
Optional;
see text
Cutout in ground and power plane.
Route all traces away from this area.
19
相關PDF資料 |
PDF描述 |
|---|---|
| MK2049-01SILF | 44.736 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-36SILF | 155.52 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-44SILFTR | 51.84 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-44SILF | 51.84 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| MK2049-44SITR | 51.84 MHz, OTHER CLOCK GENERATOR, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MK2049-01SITR | 制造商:ICS 制造商全稱:ICS 功能描述:Communications Clock PLL |
| MK2049-01STR | 制造商:Integrated Device Technology Inc 功能描述:PLL CLOCK SYNTHESIZER SGL 20SOIC - Tape and Reel |
| MK2049-02 | 制造商:ICS 制造商全稱:ICS 功能描述:Communications Clock PLLs |
| MK2049-02S | 制造商:ICS 制造商全稱:ICS 功能描述:Communications Clock PLLs |
| MK2049-02SI | 制造商:ICS 制造商全稱:ICS 功能描述:Communications Clock PLLs |
發布緊急采購，3分鐘左右您將得到回復。