- 您現在的位置：買賣IC網 > PDF目錄359670 > MC7445ARX933LF (飛思卡爾半導體(中國)有限公司) RISC Microprocessor Hardware Specifications PDF資料下載
參數資料
| 型號： | MC7445ARX933LF |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | RISC Microprocessor Hardware Specifications |
| 中文描述： | RISC微處理器硬件規格 |
| 文件頁數： | 49/64頁 |
| 文件大小： | 1127K |
| 代理商： | MC7445ARX933LF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁當前第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
MPC7455 RISC Microprocessor Hardware Specifications, Rev. 4.1
Freescale Semiconductor
49
System Design Information
Figure 24. PLL Power Supply Filter Circuit
9.3 Decoupling Recommendations
Due to the MPC7455 dynamic power management feature, large address and data buses, and high operating
frequencies, the MPC7455 can generate transient power surges and high frequency noise in its power supply,
especially while driving large capacitive loads. This noise must be prevented from reaching other components in the
MPC7455 system, and the MPC7455 itself requires a clean, tightly regulated source of power. Therefore, it is
recommended that the system designer place at least one decoupling capacitor at each V
DD
, OV
DD
, and GV
DD
pin
of the MPC7455. It is also recommended that these decoupling capacitors receive their power from separate V
DD
,
OV
DD
/GV
DD
, and GND power planes in the PCB, utilizing short traces to minimize inductance.
These capacitors should have a value of 0.01 or 0.1 μF. Only ceramic surface mount technology (SMT) capacitors
should be used to minimize lead inductance, preferably 0508 or 0603 orientations where connections are made along
the length of the part. Consistent with the recommendations of Dr. Howard Johnson in
High Speed Digital Design:
A Handbook of Black Magic
(Prentice Hall, 1993) and contrary to previous recommendations for decoupling
Freescale microprocessors, multiple small capacitors of equal value are recommended over using multiple values of
capacitance.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB, feeding the
V
DD
, GV
DD
, and OV
DD
planes, to enable quick recharging of the smaller chip capacitors. These bulk capacitors
should have a low equivalent series resistance (ESR) rating to ensure the quick response time necessary. They should
also be connected to the power and ground planes through two vias to minimize inductance. Suggested bulk
capacitors: 100–330 μF (AVX TPS tantalum or Sanyo OSCON).
9.4 Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal level.
Unused active low inputs should be tied to OV
DD
. Unused active high inputs should be connected to GND. All NC
(no-connect) signals must remain unconnected.
Power and ground connections must be made to all external V
DD
, OV
DD
, GV
DD
, and GND pins in the MPC7455.
If the L3 interface is not used, GV
DD
should be connected to the OV
DD
power plane, and L3VSEL should be
connected to BVSEL.
9.5 Output Buffer DC Impedance
The MPC7455 processor bus and L3 I/O drivers are characterized over process, voltage, and temperature. To
measure Z
0
, an external resistor is connected from the chip pad to OV
DD
or GND. Then, the value of each resistor
is varied until the pad voltage is OV
DD
/2 (see
Figure 25
).
The output impedance is the average of two components, the resistances of the pull-up and pull-down devices. When
data is held low, SW2 is closed (SW1 is open), and R
N
is trimmed until the voltage at the pad equals OV
DD
/2. R
N
then becomes the resistance of the pull-down devices. When data is held high, SW1 is closed (SW2 is open), and
V
DD
AV
DD
10
2.2 μF
2.2 μF
GND
Low ESL Surface Mount Capacitors
相關PDF資料 |
PDF描述 |
|---|---|
| MC7445ARX933LG | RISC Microprocessor Hardware Specifications |
| MC7445ARX867LF | RISC Microprocessor Hardware Specifications |
| MC9328MXL | i.MX Integrated Portable System Processor |
| MRF18030BLSR3 | RF Power Field Effect Transistors N-Channel Enhancement-Mode Lateral MOSFETs |
| MW6S004NT1_07 | RF Power Field Effect Transistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC7445ARX933LG | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:RISC Microprocessor Hardware Specifications |
| MC7447A | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:PowerPC microprocessor |
| MC7447AHX1000LB | 功能描述:微處理器 - MPU APOLO7PM RV1.1 1.3V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC7447AHX1000NB | 功能描述:微處理器 - MPU APOLO7PM RV1.1 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC7447AHX1000NBR | 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 32BIT 0.13UM 1GHZ 1.8V/2.5V 360FCCBGA - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。