參數資料
型號: MC68HC11D0CFN2
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, 2 MHz, MICROCONTROLLER, PQCC44
封裝: PLASTIC, LCC-44
文件頁數: 49/138頁
文件大?。?/td> 1047K
代理商: MC68HC11D0CFN2
General Description
MC68HC711D3 Data Sheet, Rev. 2.1
18
Freescale Semiconductor
1.10 Non-Maskable Interrupt/Programming Voltage (XIRQ/VPP)
The XIRQ input provides the capability for asynchronously applying non-maskable interrupts to the MCU
after a power-on reset (POR). During reset, the X bit in the condition code register (CCR) is set masking
any interrupt until enabled by software. This level-sensitive input requires an external pullup resistor to
VDD.
In the programming configuration of the bootstrap mode, this pin is used to supply one-time
programmable read-only memory (OTPROM) programming voltage, VPP, to the MCU. To avoid
programming accidents during reset, this pin should be equal to VDD during normal operation unless
XIRQ is active.
1.11 MODA and MODB (MODA/LIR and MODB/VSTBY)
As reset transitions, these pins are used to latch the part into one of the four central processor unit (CPU)
controlled modes of operation. The LIR output can be used as an aid to debugging once reset is
completed. The open-drain LIR pin goes to an active low during the first E-clock cycle of each instruction
and remains low for the duration of that cycle. The VSTBY input is used to retain random-access memory
(RAM) contents during power down.
1.12 Read/Write (R/W)
This pin performs either of two separate functions, depending on the operating mode.
In single-chip and bootstrap modes, R/W functions as input/output port D bit 7. Refer to Chapter 5
Input/Output (I/O) Ports for further information.
In expanded multiplexed and test modes, R/W performs a read/write function. R/W controls the
direction of transfers on the external data bus.
1.13 Port D Bit 6/Address Strobe (PD6/AS)
This pin performs either of two separate functions, depending on the operating mode.
In single-chip and bootstrap modes, the pin functions as input/output port D bit 6.
In the expanded multiplexed and test modes, it provides an address strobe (AS) function. AS is
used to demultiplex the address and data signals at port C.
Refer to Chapter 2 Operating Modes and Memory for further information.
1.14 Input/Output Lines (PA7–PA0, PB7–PB0, PC7–PC0, and PD7–PD0)
In the 44-pin PLCC package, 32 input/output lines are arranged into four 8-bit ports: A, B, C, and D. The
lines of ports B, C, and D are fully bidirectional. Port A has two bidirectional, three input-only, and three
output-only lines in the 44-pin PLCC packaging. In the 40-pin DIP, two of the output-only lines are not
bonded.
Each of these four ports serves a purpose other than input/output (I/O), depending on the operating mode
or peripheral functions selected.
NOTE
Ports B, C, and two bits of port D are available for I/O functions only in
single-chip and bootstrap modes.
相關PDF資料
PDF描述
MC68HC11D0CFB2 8-BIT, 2 MHz, MICROCONTROLLER, PQFP44
MC68HC11D3CFN2 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQCC44
MC68HC711D3CP3 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDIP40
MC68HC11D3CFN3 8-BIT, MROM, 3 MHz, MICROCONTROLLER, PQCC44
MC68HC11D3CFB1 8-BIT, MROM, 3 MHz, MICROCONTROLLER, PQFP44
相關代理商/技術參數
參數描述
MC68HC11D0CFN3 制造商: 功能描述: 制造商:undefined 功能描述:
MC68HC11D0CFNE2 功能描述:8位微控制器 -MCU 8B MCU 192 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HC11D0CFNE2R 功能描述:8位微控制器 -MCU 8B MCU 192 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HC11D0CFNE3 功能描述:8位微控制器 -MCU 8B MCU 192 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HC11D0CFNE3R 功能描述:8位微控制器 -MCU 8B MCU 192 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT