![](http://datasheet.mmic.net.cn/280000/MC68HC08MR4_datasheet_16093998/MC68HC08MR4_71.png)
M68ICS08MR In-Circuit Simulator
User
’
s Manual
MOTOROLA
Using the MON08 Interface
71
User
’
s Manual
—
M68ICS08MR In-Circuit Simulator
Section 4. Using the MON08 Interface
4.1 Introduction
The MON08 debugging interface is used to debug and program an MCU that is
installed on your target application. To facilitate this operation, your target
board MCU must be connected to the appropriate MRICS
’
s MONO8 connector
by a MON08 interface cable. This section explains how to accomplish the
MON08 interface connection.
4.2 Target System Header Placement
Two headers are available for use on the target board, however only one is used
at a time for a given application. The header used is dependent upon which
MCU is selected for installation.
MR16/32
—
16-pin header, such as Berg Electronics part number
67997-616, installed in J7 (
Table 4-1
)
MR4/8
—
16-pin header, such as Berg Electronics part number
67997-616, installed in J8 (
Table 4-2
)