- 您現在的位置：買賣IC網 > PDF目錄45242 > MC68HC08KX8P (FREESCALE SEMICONDUCTOR INC) 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP16 PDF資料下載
參數資料
| 型號： | MC68HC08KX8P |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP16 |
| 封裝： | PLASTIC, DIP-16 |
| 文件頁數： | 141/210頁 |
| 文件大?。?/td> | 1346K |
| 代理商： | MC68HC08KX8P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁當前第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁
Memory
MC68HC908KX8 MC68HC908KX2 MC68HC08KX8 Data Sheet, Rev. 2.1
36
Freescale Semiconductor
2.10 FLASH Block Protection
Due to the ability of the on-board charge pump to erase and program the FLASH memory in the target
application, provision is made for protecting a block of memory from unintentional erase or program
operations due to system malfunction. This protection is done by using the FLASH block protect register
(FLBPR). The FLBPR determines the range of the FLASH memory which is to be protected. The range
of the protected area starts from a location defined by FLBPR and ends at the bottom of the FLASH
memory ($FFFF). When the memory is protected, the HVEN bit cannot be set in either erase or program
operations.
NOTE
In performing a program or erase operation, the FLASH block protect
register must be read after setting the PGM or ERASE bit and before
asserting the HVEN bit.
When FLBPR is programmed with all 0s, the entire memory is protected from being programmed and
erased. When all the bits are erased (all 1s), the entire memory is accessible for program and erase.
When bits within the FLBPR are programmed, they lock a block of memory address ranges as shown in
2.11 FLASH Block Protect Register. Once the FLBPR is programmed with a value other than $FF, any
erase or program of the FLBPR or the protected block of FLASH memory is prohibited. The FLBPR itself
can be erased or programmed only with an external voltage, VTST, present on the IRQ pin. This voltage
also allows entry from reset into the monitor mode.
2.11 FLASH Block Protect Register
The FLASH block protect register (FLBPR) is implemented as a byte within the FLASH memory, and
therefore can be written only during a programming sequence of the FLASH memory. The value in this
register determines the starting location of the protected range within the FLASH memory.
BPR7–BPR0 — FLASH Block Protect Bits
These eight bits represent bits 13–6 of a 16-bit memory address. Bits 15 and 14 are 1s and bits 5–0
are 0s.
The resultant 16-bit address is used for specifying the start address of the FLASH memory for block
protection. The FLASH is protected from this start address to the end of FLASH memory, at $FFFF.
With this mechanism, the protect start address can be $XX00, $XX40, etc., (64 bytes page boundaries)
within the FLASH memory. See Figure 2-6 and Table 2-2.
Address:
$FF7E
Bit 7
654321
Bit 0
Read:
BPR7
BPR6
BPR5
BPR4
BPR3
BPR2
BPR1
BPR0
Write:
Reset:
UUUUUUUU
U = Unaffected by reset. Initial value from factory is 1.
Write to this register is by a programming sequence to the FLASH memory.
Figure 2-5. FLASH Block Protect Register (FLBPR)
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC908KX8VP | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDIP16 |
| MC68HC908KX8CDW | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDSO16 |
| MC68HC908LK24CFQ | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP80 |
| MC68HC908LK24CFU | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 |
| MC68HC908LK24CPK | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP80 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC08LJ12 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Addendum to MC68HC908LJ12 Technical Data |
| MC68HC08LJ12CFB | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Addendum to MC68HC908LJ12 Technical Data |
| MC68HC08LJ12CFU | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Addendum to MC68HC908LJ12 Technical Data |
| MC68HC08LJ12CPB | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:low-voltage version of the MC68HC908LJ12 |
| MC68HC08LN56 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
發布緊急采購，3分鐘左右您將得到回復。