參數資料
型號: MC33591FTA
廠商: MOTOROLA INC
元件分類: 消費家電
英文描述: PLL Tuned UHF Receiver for Data Transfer Applications
中文描述: SPECIALTY CONSUMER CIRCUIT, PQFP24
封裝: PLASTIC, LQFP-24
文件頁數: 16/28頁
文件大?。?/td> 699K
代理商: MC33591FTA
STROBE OSCILLATOR
16
MC33591 Technical Data
MOTOROLA
Programming SOE=0 sets ROMEO2 to state 6. The circuit is in Sleep mode.
State 7:
A high level applied on STROBE sets the circuit into state 7. If an ID or its complement is detected, the state
machine advances to state 8. If not, it will stay in state 7 as long as STROBE is high.
State 8:
After ID or its complement detection, ID byte is sent to the microcontroller on MOSI line at 310kBd. This warns
the microcontroller that data are received which means that an high level has to be maintained on STROBE. At
any time a low level applied on STROBE sets the circuit into state 6.
State 9:
If Header or its complement is detected, the state machine advances to state 10. If not, it will stay in state 9 as
long as STROBE is high.
State 10:
If Header has been received, data and clock signals are output on the SPI port. If the complement of Header has
been received, output data are complemented too. At any time a low level applied on STROBE sets the circuit
into state 6, after the current byte is fully transmitted.
State 11:
If data are received after a End of Message they are output on the MOSI pin without clock recovery.
For all states:
At any time, a low level applied on RESETB for more than one Ts forces the state machine to state 1. When the
transition condition from one state to the next one is fulfilled, the transition time is one Ts except reaching state 6.
The transition time for reaching state 6 is 2
Ts (+ time needed to shift out a full byte if STROBE pin is forced to
low when in state 10).
STROBE OSCILLATOR
The Strobe Oscillator is a relaxation oscillator in which an external capacitor C5 is charged by an external
resistance R2 (refer to figure 17 and table 11). When a threshold is reached or exceeded C5 is discharged and
the cycle restarts. The period is: T
Strobe
=0.12 R2 C5.
The circuit may be forced into states 0b, 3, 7 etc. (see State Machine Diagrams) by setting the STROBE pin to
V
CC
. As V
CC
is above the oscillator threshold voltage referred to in the previous paragraph, the condition in which
the STROBE pin is set to V
CC
is internally detected and the oscillator pull-down circuitry disabled to limit the
current which must be supplied.
F
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
.
相關PDF資料
PDF描述
MC33680 0.4W, 75V, 0.3A, SIGNAL DIODE, SOD123
MC33680FTBR2 Dual DC-DC Regulator for Electronic Organizer
MC33680FTB Single Output LDO, 400mA, Fixed(2.85V), Low Noise, Fast Transient Response 8-MSOP -40 to 85
MC33765DTB Very Low Dropout/Ultra Low Noise 5 Outputs Voltage Regulator
MC33765DTBR2 Very Low Dropout/Ultra Low Noise 5 Outputs Voltage Regulator
相關代理商/技術參數
參數描述
MC33591FTAE 功能描述:射頻接收器 UHF RECEIVER RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
MC33591FTAER2 功能描述:射頻接收器 UHF RECEIVER RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
MC33591FTAR2 功能描述:IC RF RECEIVER 315,434MHZ 24LQFP RoHS:否 類別:RF/IF 和 RFID >> RF 接收器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 09/Jan/2012 標準包裝:50 系列:* 頻率:850MHz ~ 2.175GHz 靈敏度:- 數據傳輸率 - 最大:- 調制或協議:- 應用:* 電流 - 接收:* 數據接口:PCB,表面貼裝 存儲容量:- 天線連接器:PCB,表面貼裝 特點:- 電源電壓:4.75 V ~ 5.25 V 工作溫度:0°C ~ 85°C 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(6x6) 包裝:托盤
MC33591MOD315 功能描述:BOARD EVALUATION FOR MC33591 RX RoHS:否 類別:RF/IF 和 RFID >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 類型:用于 200/300 系列的歐盟開發套件 適用于相關產品:Zensys RF 模塊 所含物品:開發板,模塊,編程器,軟件,線纜,電源 其它名稱:703-1019Q3225667
MC33591MOD315EV 功能描述:開發板和工具包 - 無線 MC33493 (TANGO3) RF EVAL RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:AT32UC3L 核心:AVR32 頻率: 接口類型:USB 工作電源電壓:5 V