- 您現在的位置：買賣IC網 > PDF目錄385566 > MC1H3 (Microchip Technology Inc.) High Voltage Power Module Users Guide PDF資料下載
參數資料
| 型號： | MC1H3 |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | High Voltage Power Module Users Guide |
| 中文描述： | 高壓電源模塊用戶指南 |
| 文件頁數： | 33/60頁 |
| 文件大小： | 1522K |
| 代理商： | MC1H3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
2003 Microchip Technology Inc.
DS70096A-page 27
Set Up and Operation
1.4.8
Firing Signal Isolation and Low Voltage Power Supplies
1.4.8.1
INTRODUCTION
The choice of isolation strategy and how the low voltage power supplies are to be
derived are two of the major decisions that determine the architecture of a motor drive
controller. For this design, the requirement was for flexibility while maintaining user
safety. It was essential that the system could work off a wide range of input voltages.
1.4.8.2
FIRING SIGNAL ISOLATION (APPENDIX A, SHEET 5)
Either optical or transformer-based isolation strategies can be used for transmitting
gate firing commands. For this design, it was decided to use optocouplers, as it was
possible that a particular firing command may be used for commutation as opposed to
high frequency modulation. This could lead to transformer saturation at low speeds.
The hardware implemented is described below:
U6-U13 – HCPL4503 optocouplers. These parts were chosen to provide good
noise immunity, while requiring low current consumption on the output side.
Speed was also a consideration, so that too much delay or pulse distortion was
not introduced.
R153-R160 – Pull-up resistors for the open collector outputs of the optocouplers.
R162-169 – Series resistors to ensure at least 18 mA flows through the emitter
stage of the optocouplers. Note that the ground return is via a transistor (Q15) that
allows shutdown during detection of an over-current from one of the isolated Hall
effect current transducers.
U32 and U33 – Schmitt-triggered inverters which clean up the edges from the
outputs of the optocouplers.
1.4.8.3
LOW VOLTAGE POWER SUPPLIES (APPENDIX A, SHEET 5 AND 8)
The requirement for operation over a wide range of input voltage resulted in using the
+5V supply coming from the control board as the power source for all the low voltage
power supplies. This was true for both the isolated and live sides of the system. The
power supply circuitry on the live side is described below:
U18 – An isolating (3 kV rated) 1W unregulated DC-DC converter with 5V input
and 15V (nominal) output. The +15V supply is used for the gate drive of the power
devices and the comparators on the live side of the isolation barrier.
L4 and C83: A filter to reduce the reflected ripple on the +5V supply from the
control board caused by the DC-DC converter.
L3 and C77: A filter to reduce the magnitude of the ripple on the live +15V supply.
U5 – A 5V linear regulator for the live control circuit supplies.
D4 – A 1A diode to protect U5 against reverse bias during power-down.
R61 – A 0
resistor linking the low voltage power supply star point to the -DC bus.
相關PDF資料 |
PDF描述 |
|---|---|
| MC33023DWG | High Speed Single−Ended PWM Controller |
| MC33023DWR2 | High Speed Single−Ended PWM Controller |
| MC33023DWR2G | High Speed Single−Ended PWM Controller |
| MC33025DWG | High Speed Double−Ended PWM Controller |
| MC33025DWR2 | High Speed Double−Ended PWM Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC1JJN0600 | 功能描述:環形公制連接器 M40 C Straight 6 Position Extension RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A |
| MC1JJN0800 | 功能描述:環形公制連接器 M40 C Straight Extension 8 Pos. RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A |
| MC1LKN0600 | 功能描述:環形公制連接器 M40 C Straight Recpt 6 Position RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A |
| MC1LKN0800 | 功能描述:環形公制連接器 M40 C Straight Recpt 8 Position RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A |
| MC1M | 制造商:G & J HALL 功能描述:STEP DRILL 4-12MM 1MM STEP 制造商:G & J HALL 功能描述:STEP DRILL, 4-12MM, 1MM STEP 制造商:G & J HALL 功能描述:STEP DRILL, 4-12MM, 1MM STEP; Drill Bit Size Metric:4mm; Overall Length:75.5mm; SVHC:No SVHC (19-Dec-2012); Drill Bit Type:Step; Material:Steel; Material Thickness Max:5mm; Range:4mm - 12mm; Range:4mm - 12mm; Shank Dia:6mm; S ;RoHS Compliant: NA |
發布緊急采購，3分鐘左右您將得到回復。