- 您現在的位置：買賣IC網 > PDF目錄1946 > MAXQ3120-FFN+ (Maxim Integrated Products)IC MCU 32KB FLASH 80-MQFP PDF資料下載
參數資料
| 型號： | MAXQ3120-FFN+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 18/33頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU 32KB FLASH 80-MQFP |
| 標準包裝： | 66 |
| 系列： | MAXQ® |
| 核心處理器： | RISC |
| 芯體尺寸： | 16-位 |
| 速度： | 8MHz |
| 連通性： | UART/USART |
| 外圍設備： | LCD，POR，PWM，WDT |
| 輸入/輸出數： | 32 |
| 程序存儲器容量： | 32KB（16K x 16） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 512 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.8 V ~ 3.6 V |
| 數據轉換器： | A/D 2x16b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 80-BQFP |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
In-Circuit Debug
Embedded debugging capability is available through
the JTAG-compatible TAP. Embedded debug hardware
and embedded ROM firmware provide in-circuit
debugging capability to the user application, eliminat-
ing the need for an expensive in-circuit emulator.
Figure 4 shows a block diagram of the in-circuit debug-
ger. The in-circuit debug features include:
Hardware debug engine
Set of registers able to set breakpoints on register,
code, or data accesses
Set of debug service routines stored in the utility
ROM
The embedded hardware debug engine is an indepen-
dent hardware block in the microcontroller. The debug
engine can monitor internal activities and interact with
selected internal registers while the CPU is executing
user code. Collectively, the hardware and software fea-
tures allow two basic modes of in-circuit debugging:
Background mode allows the host to configure and set
up the in-circuit debugger while the CPU continues to
execute the application software at full speed. Debug
mode can be invoked from background mode.
Debug mode allows the debug engine to take control
of the CPU, providing read/write access to internal reg-
isters and memory, and single-step trace operation.
Serial Peripherals
The MAXQ3120 incorporates two 8051-style universal
synchronous/asynchronous receiver/transmitters. The
USARTs allow the device to conveniently communicate
with other RS-232 interface-enabled devices, as well as
PCs and serial modems when paired with an external
RS-232 line driver/receiver. The dual independent
USARTs can communicate simultaneously at different
baud rates with two separate peripherals. The USART
can detect framing errors and indicate the condition
through a user-accessible software bit.
The time base of the serial ports is derived from either a
division of the system clock or the dedicated baud
clock generator. The following table summarizes the
operating characteristics as well as the maximum baud
rate of each mode.
Serial port 0 contains additional functionality to support
low-speed infrared transmission in combination with the
PWM function of timer 2. When enabled in this mode,
the serial port automatically outputs a waveform gener-
ated by combining the normal serial port output wave-
form with the PWM carrier waveform output by timer 2,
using a logical OR or logical NOR function. The output
of serial port 0 in this mode can be used to drive an
infrared LED to communicate using a fixed-frequency
carrier modulated signal. Depending on the drive
strength required, the output may require a buffer when
used for this purpose.
MAXQ3120
High-Precision ADC
Mixed-Signal Microcontroller
____________________________________________________________________
25
MODE
TYPE
START BITS
DATA BITS
STOP BIT
MAX BAUD RATE AT 8MHz
Mode 0
Synchronous
—
8
—
2Mbps
Mode 1
Asynchronous
1
8
1
250kbps
Mode 2
Asynchronous
1
8 + 1
1
250kbps
Mode 3
Asynchronous
1
8 + 1
1
250kbps
Figure 4. In-Circuit Debugger
TAP
CONTROLLER
CPU
DEBUG
ENGINE
DEBUG
SERVICE
ROUTINES
(UTILITY ROM)
TMS
TCK
TDI
TDO
CONTROL
BREAKPOINT
ADDRESS
DATA
MAXQ3120
相關PDF資料 |
PDF描述 |
|---|---|
| MAXQ3210-EMX+ | IC MCU 16BIT LP 24-DIP |
| MAXQ3212-EJX+ | IC MCU 16BIT LP 24-TSSOP |
| MAXQ610X-0000+ | MCU 16BIT W/IR MODULE BARE DIE |
| MAXQ612J-0000+ | IC MCU 16BIT 128KB IR MOD 44WQFN |
| MAXQ613K-0000+ | IC MCU 16BIT IR MOD 44TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAXQ3120-FFN+ | 功能描述:IC MCU 32KB FLASH 80-MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MAXQ® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C，智能卡，UART/USART，USB 外圍設備:LED，POR，WDT 輸入/輸出數:9 程序存儲器容量:64KB（64K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件 |
| MAXQ3120-KIT | 制造商:Maxim Integrated Products 功能描述:MAXQ3120 EVALUATION KIT - Bulk |
| MAXQ314 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Single-Phase Power-Measurement IC with I2C Interface |
| MAXQ314+ | 功能描述:16位微控制器 - MCU Integrated Circuits (ICs) PMIC - Energy Metering - IC PWR MEASUREMENT 1PH 10-TQFN RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MAXQ314-KIT | 功能描述:開發板和工具包 - 其他處理器 MAXQ314 Eval Kit RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。