- 您現在的位置：買賣IC網 > PDF目錄1943 > MAX4919BETD+T (Maxim Integrated Products)IC CTLR OVP/OCP BATT PWR 14-TDFN PDF資料下載
參數資料
| 型號： | MAX4919BETD+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 18/19頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CTLR OVP/OCP BATT PWR 14-TDFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 類型： | 過壓和過流控制器 |
| 應用： | 手機，數碼相機，媒體播放器 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 14-TDFN-EP（3x3） |
| 包裝： | 帶卷 (TR) |
MAX4919B/MAX4920B/MAX4921B
GN1 Driver
An internal 5.5V supply powers the on-chip charge
pump used to drive GN1 above IN, allowing the use of
a low-cost nFET. The GN1 voltage is approximately two
times VIN until VIN exceeds 5.5V, at which point, GN1
clamps to 9.5V (MAX4919B/MAX4920B) or 8.1V
(MAX4921B).
ACOK
ACOK is an active-low open-drain output that asserts
when VUVLO <VIN < VOVLO for the 25ms debounce
period. ACOK deasserts immediately to overvoltage
and undervoltage faults. Connect a pullup resistor from
ACOK to the logic I/O voltage of the host system.
PWR_ON
PWR_ON is one of the logic inputs that enables the
internal 1.8A switch. Drive PWR_ON high to turn on the
internal switch. PWR_ON also controls the logic output
ONOK. The ONOK open-drain output is the inverse of
the PWR_ON input state (see Figure 5). Note that
ONOK is high impedance when VIN < VUVLO, and VBTI
< 2.82V (typ). If VBTI is greater than 2.15V (typ), but
less than 2.82V (typ), PWR_ON and ONOK are dis-
abled and ONOK pulls high. When BTI rises above
2.82V (typ) again, PWR_ON is again enabled and
ONOK goes back to its previous logic level before a
low condition at BTI (see Figure 6).
Battery Switchover
An internal 1.8A (min) pFET with a 100m
(typ) RON
connects BTI to the load at BTO. The internal battery
switchover FET turns on when either HP_PWR,
PWR_ON, or PWR_HOLD is high. Note that when BTI
< 2.15V, the internal switch remains inactive, regard-
less of the logic control signals.
Battery Power-Up Logic with Overvoltage
and Overcurrent Protection
8
_______________________________________________________________________________________
UVLO
OVLO
IN
ACOK
ADAPTER
VOLTAGE
ACOK
ONE-SHOT
P2
STATUS
OFF
ON
25ms DEBOUNCE PERIOD
OFF
t1SHAC
Figure 1. ACOK One-Shot Timing Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4926ELT+T | IC CTLR OVP W/EXT PFET 6-UDFN |
| MAX4927ETN+ | IC ETHERNET SWITCH QUAD 56TQFN |
| MAX4929EEEP+T | IC SWITCH HDMI 2:1 20-QSOP |
| MAX4939CTN+ | IC TRANSMIT/RCVR SWITCH 56-TQFN |
| MAX4943ELA+T | IC CTLR OVP W/FET 7.40V 8-UDFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX491C/D | 功能描述:RS-422/RS-485 接口 IC RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube |
| MAX491C/D DIE | 制造商:Maxim Integrated Products 功能描述: |
| MAX491CPD | 功能描述:RS-422/RS-485 接口 IC RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube |
| MAX491CPD+ | 功能描述:RS-422/RS-485 接口 IC RS-485/RS-422 Transceiver RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube |
| MAX491CSD | 功能描述:RS-422/RS-485 接口 IC RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。