參數資料
型號: MAX3349EAEBE+T
廠商: Maxim Integrated Products
文件頁數: 3/17頁
文件大?。?/td> 0K
描述: IC TXRX USB 2.0 FS 16-UCSP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 2,500
類型: 收發器
驅動器/接收器數: 1/1
規程: USB 2.0
電源電壓: 4 V ~ 5.5 V
安裝類型: 表面貼裝
封裝/外殼: 16-WFBGA,CSPBGA
供應商設備封裝: 16-UCSP(2x2)
包裝: 帶卷 (TR)
MAX3349EA
USB 2.0 Full-Speed Transceiver with UART
Multiplexing Mode
______________________________________________________________________________________
11
USB Mode
The MAX3349EA is in USB mode when VBUS is greater
than VTH-BUS and the bus detect output (BD) is logic-
high. In USB mode, power for the MAX3349EA is
derived from VBUS, typically provided through the USB
connector. An internal linear regulator generates the
required +3.3V VTRM voltage from VBUS. VTRM powers
the internal USB transceiver circuitry and the D+ enu-
meration resistor. Bypass VTRM to GND with a 1F
ceramic capacitor as close to the device as possible.
Do not power external circuitry from VTRM.
Disable Mode
Connect VBUS to a system power supply and leave VL
unconnected or connect to ground to enter disable
mode. In disable mode, D+ and D- are high imped-
ance, and withstand external signals up to +5.5V. OE,
SUS, and control signals are ignored.
UART Mode
Connect VL and VUART to system power supplies, and
leave VBUS unconnected or below VTH-BUS to operate
the MAX3349EA in UART mode. The MAX3349EA sup-
ports VUART from +2.7V to +3.3V (see Table 1).
USB Control Signals
OE
OE controls the direction of communication for USB
mode. When OE is logic-low, VP and VM operate as
logic inputs, and D+/D- are outputs. When OE is logic-
high, VP and VM operate as logic outputs, and D+/D-
are inputs. RCV is the output of the differential USB
receiver connected to D+/D-, and is not affected by the
OE logic level.
ENUM
Drive ENUM logic-high to enable the internal 1.5k
pullup resistor from D+ to VTRM. Drive ENUM logic-low
to disable the internal pullup resistor and logically dis-
connect the MAX3349EA from the USB.
SUS
Operate the MAX3349EA in low-power USB suspend
mode by driving SUS logic-high. In suspend mode, the
USB differential receiver is turned off and VBUS con-
sumes 38A (typ) of supply current. The single-ended
VP and VM receivers remain active to detect a SE0
state on USB bus lines D+ and D-. The USB transmitter
remains enabled in suspend mode to allow transmis-
sion of a remote wake-up on D+ and D-.
VBUS(V)
VTRM(V)
VL(V)
VUART(V)
CONFIGURATION
+4.0 to +5.5
+3.0 to +3.6 Output
+1.4 to +2.75
GND, Unconnected, or
+2.7V to +3.3V
USB Mode
+4.0 to +5.5
+3.0 to +3.6 Output
GND or Unconnected
GND, Unconnected, or
+2.7V to +3.3V
Disable Mode
GND or Unconnected
High Impedance
+1.4 to +2.75
+2.7V to +3.3V
UART Mode
Table 1. Power-Supply Configuration
INPUTS
OUTPUTS
VP
VM
D+
D-
00
0
01
0
1
10
1
0
11
1
Table 2. USB Transmit Truth Table (
OE = 0)
INPUTS
OUTPUTS
D+
D-
VP
VM
RCV
0000
RCV*
0101
0
1010
1
1111X
Table 3a. USB Receive Truth Table (
OE = 1,
SUS = 0)
INPUTS
OUTPUTS
D+
D-
VP
VM
RCV
0000
0
0101
0
1010
0
1111
0
Table 3b. USB Receive Truth Table (
OE = 1,
SUS = 1)
* = Last state.
X = Undefined.
相關PDF資料
PDF描述
MAX3349EETE+ IC TXRX USB 2.0 FS 16-TQFN
MAX334EWE IC SWITCH QUAD SPST 16SOIC
MAX335EWG IC SWITCH OCTAL SPST 24SOIC
MAX3362AKA#TG16 IC TXRX RS485/422 SGL SOT23-8
MAX336CWI IC MULTIPLEXER 16X1 28SOIC
相關代理商/技術參數
參數描述
MAX3349EEBE 制造商:Maxim Integrated Products 功能描述:USB 2.0 FULL-SPEED TRANSCEIVER WITH - Rail/Tube
MAX3349EEBE+ 制造商:Maxim Integrated Products 功能描述:USB 2.0 FULL-SPEED TRANSCEIVER WITH - Rail/Tube 制造商:Maxim Integrated Products 功能描述:USB 2.0 FULL-SPEED TRANSCEIVER WITH UART 制造商:Rochester Electronics LLC 功能描述:
MAX3349EEBE+T 制造商:Maxim Integrated Products 功能描述:USB 2.0 FULL-SPEED TRANSCEIVER WITH - Tape and Reel
MAX3349EEBE-T 功能描述:USB 接口集成電路 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
MAX3349EETE+ 功能描述:IC TXRX USB 2.0 FS 16-TQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP(0.300",7.62mm) 供應商設備封裝:16-PDIP 包裝:管件