- 您現在的位置：買賣IC網 > PDF目錄8600 > MAX2038CCQ+T (Maxim Integrated Products)IC VGA W/OCTAL MIXER 8CH 100TQFP PDF資料下載
參數資料
| 型號： | MAX2038CCQ+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 11/24頁 |
| 文件大小： | 0K |
| 描述： | IC VGA W/OCTAL MIXER 8CH 100TQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 250 |
| 類型： | 可變增益放大器 |
| 應用： | 醫療用超聲波成像，聲納 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-TQFP 裸露焊盤 |
| 供應商設備封裝： | 100-TQFP-EP（14x14） |
| 包裝： | 帶卷 (TR) |
MAX2038
Ultrasound VGA Integrated
with CW Octal Mixer
______________________________________________________________________________________
19
Applications Information
Mode Select Response Time
The mode select response time is the time that the
device takes to switch between CW and VGA modes.
One possible approach to interfacing the CW outputs to
an instrumentation amplifier used to drive an ADC is
shown in Figure 2. In this implementation, there are four
large-value (in the range of 470nF to 1F) capacitors
between each of the CW_IOUT+, CW_IOUT-,
CW_QOUT+, CW_QOUT- outputs and the circuitry they
are driving. The output of the CW mixer usually drives
the input of an instrumentation amplifier made up of op
amps whose input impedance is set by common-mode
setting resistors.
There are clearly both a highpass corner and a lowpass
corner present in this output network. The lowpass cor-
ner is set primarily by the 115
Ω mixer pullup resistors,
the series 50
Ω resistors, and the shunt 0.022F capaci-
tor. This lowpass corner is used to filter a combination
of LO leakage and upper sideband. The highpass cor-
ner, however, is of a larger concern due to the fact that
it is dominated by the combination of a 1F DC-block-
ing capacitor and the pair of shunt 31.6k
Ω resistors.
If drawn, the simplified dominant highpass network
would look like Figure 3.
The highpass pole in this case is at fP = 1/(2 x pi x RC)
~ 5Hz. Note that this low highpass corner frequency is
required in order to filter the downconverted clutter tone,
which appears at DC, without interfering with CWD imag-
ing at frequencies as low as 400Hz. For example, if one
wanted to use CWD down to 400Hz, then a good choice
for the highpass pole would be at least a decade below
this (< 40Hz) as not to incur rolloff due to pole. Remember,
if the highpass pole is put at 400Hz, the response is 3dB
down at that corner frequency. The placement of the high-
pass pole at 5Hz in the above example is between the DC
and 40Hz limitations just discussed.
The bottom line is that any reasonably sized DC block
between the output of the mixer and the instrumentation
amplifier will pose a significant time constant that slows
the mode select switching speed.
An alternative solution to the approach in Figure 2,
which enables faster mode select response time, is
shown in Figure 4.
In Figure 4, the outputs of the CWD mixers are DC-
coupled into the inputs of the instrumentation ampli-
fiers. Therefore, the op amps must be able to accom-
modate the full compliance range of the mixer outputs,
which is a maximum of 11V when the mixers are dis-
abled, down to the 5V supply of the MAX2038 when the
mixers are enabled. The op amps can be powered from
11V for the high rail and 5V for the low rail, requiring a
6V op amp.
115
Ω
115
Ω
1
μF
1
μF
0.022
μF
31.6k
Ω
31.6k
Ω
50
Ω
CW_IOUT+
CW_IOUT-
Figure 2. Typical Example of a CW Mixer’s Output Circuit
1
μF
31.6k
Ω
Figure 3. Simplified Circuit of Highpass Pole
+11V
+5V
Figure 4. Improved Mode Select Response Time Achieved with
DC-Coupled Input to Instrumentation Amplifier
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2TX-IV-F2 | CONVERTER MOD DC/DC 5.2V 150W |
| AD8305ACP-R2 | IC LOGARITHM CONV 100DB 16-LFCSP |
| VE-2TW-IV-F4 | CONVERTER MOD DC/DC 5.5V 150W |
| VE-2TW-IV-F3 | CONVERTER MOD DC/DC 5.5V 150W |
| VE-2TV-IV-F4 | CONVERTER MOD DC/DC 5.8V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX2038EVKIT | 制造商:Maxim Integrated Products 功能描述:ULTRASOUND VARIABLE-GAIN AMPLIFIER WITH CWD (12B COMPATIBLE - Boxed Product (Development Kits) |
| MAX2038混頻器 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| MAX2039 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Evaluation Kit |
| MAX2039_1 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Evaluation Kit |
| MAX2039ETP | 功能描述:射頻混合器 1.7GHz-2.2GHz Up/Down Mixer RoHS:否 制造商:NXP Semiconductors 頻率范圍: 轉換損失——最大: 工作電源電壓:6 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。