- 您現在的位置：買賣IC網 > PDF目錄9857 > MAX1316ECM+T (Maxim Integrated Products)IC ADC 14BIT 8CH 2MSPS 48LQFP PDF資料下載
參數資料
| 型號： | MAX1316ECM+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 7/27頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 14BIT 8CH 2MSPS 48LQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,000 |
| 位數： | 14 |
| 采樣率（每秒）： | 2M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 1.82W |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 8 個單端，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
MAX1316–MAX1318/MAX1320–MAX1322/MAX1324–MAX1326
8-/4-/2-Channel, 14-Bit, Simultaneous-Sampling ADCs
with ±10V, ±5V, and 0 to +5V Analog Input Ranges
______________________________________________________________________________________
15
Clock Modes
These devices provide an internal clock of 10MHz
(typ). Alternatively, an external clock can be used.
Internal Clock
Internal-clock mode frees the microprocessor from the
burden of running the ADC conversion clock. For internal-
clock operation, connect INTCLK/EXTCLK to AVDD and
connect CLK to DGND. Table 1 illustrates the total con-
version time using internal-clock mode.
External Clock
For external-clock operation, connect INTCLK/EXTCLK
to AGND and connect an external-clock source to CLK.
Note that INTCLK/EXTCLK is referenced to the analog
power supply, AVDD. The external-clock frequency can
be up to 15MHz, with a duty cycle between 30% and
70%. Clock frequencies of 100kHz and lower can be
used, but the droop in the T/H circuits reduce linearity.
Selecting an Input Buffer
Most applications require an input buffer to achieve 14-
bit accuracy. Although slew-rate and bandwidth are
important, the most critical specification is settling time.
The sampling requires a relatively brief sampling inter-
val of 150ns. At the beginning of the acquisition, the
internal sampling capacitor array connects to CH_ (the
amplifier output), causing some output disturbance.
Ensure the amplifier is capable of settling to at least 14-
bit accuracy during this interval. Use a low-noise, low-
distortion, wideband amplifier (such as the MAX4350 or
MAX4265), which settles quickly and is stable with the
ADC’s capacitive load (in parallel with any bypass
capacitors on the analog inputs).
Applications Section
Digital Interface
The bidirectional, parallel, digital interface sets the 8-bit
configuration register (see the
Configuration Register
section) and outputs the 14-bit conversion result. The
interface includes the following control signals: chip
select (CS), read (RD), write (WR), end of conversion
(EOC), end of last conversion (EOLC), convert start
(CONVST), shutdown (SHDN), all on (ALLON), internal-
clock select (INTCLK /EXTCLK), and external-clock input
(CLK). Figures 4, 5, 6, 7, Table 4, and the
Timing
Characteristics section show the operation of the inter-
face. D0–D7 are bidirectional, and D8–D13 are output
only. All bits are high impedance when RD = 1 or CS = 1.
Configuration Register
Enable channels as active by writing to the configuration
register through I/O lines D0–D7 (Table 2). The bits in the
configuration register map directly to the channels, with
D0 controlling channel zero, and D7 controlling channel
seven. Setting any bit high activates the corresponding
input channel, while resetting any bit low deactivates the
corresponding channel. Devices with fewer than eight
channels contain some bits that have no function.
Figure 3. Software Channel Wake-Up Timing (ALLON = 0)
CONVST
D0–D7
CLK
WR
EOC
EOLC
LATCH
tACQ
DUMMY
CONVERSION
START
ACTUAL
CONVERSION
START
DATA-IN
DATA-IN CHANGES ONE OR MORE CHANNELS
FROM POWER-DOWN TO ACTIVE MODE
12345
14
15
1
>14 CYCLES
SAMPLE
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3043CUE+T | IC RS485/422 TRANS QUAD 16TSSOP |
| MAX3040CUE+T | IC RS485/422 TRANS QUAD 16TSSOP |
| MAX122BEAG+T | IC ADC 12BIT 333KSPS 24-SSOP |
| MS27499E12B22PA | CONN RCPT 22POS BOX MNT W/PINS |
| MS27656T11F35PA | CONN RCPT 13POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX13170ECAI+ | 制造商:Maxim Integrated Products 功能描述:+5V MULTIPROTOCOL 3TX/3RX SOFTWARE-SELECTABLE CLOCK/DATA TR - Rail/Tube |
| MAX13170EEAI+ | 制造商:Maxim Integrated Products 功能描述:+5V MULTIPROTOCOL 3TX/3RX SOFTWARE-SELECTABLE CLOCK/DATA TR - Rail/Tube |
| MAX13171EETU+ | 制造商:Maxim Integrated Products 功能描述:MULTIPROTOCOL, PIN-SELECTABLE DATA INTERFACE CHIPSET - Rail/Tube |
| MAX13171EETU+T | 制造商:Maxim Integrated Products 功能描述:MULTIPROTOCOL, PIN-SELECTABLE DATA INTERFACE CHIPSET - Tape and Reel |
| MAX13172ECAI+ | 制造商:Maxim Integrated Products 功能描述:+5V MULTIPROTOCOL SOFTWARE-SELECTABLE CLOCK TRANSCEIVERS - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。