- 您現在的位置：買賣IC網 > PDF目錄17008 > MAX11200EVKIT+ (Maxim Integrated Products)KIT EVALUATION FOR MAX11200 PDF資料下載
參數資料
| 型號： | MAX11200EVKIT+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 10/27頁 |
| 文件大?。?/td> | 0K |
| 描述： | KIT EVALUATION FOR MAX11200 |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
18
Maxim Integrated
24-Bit, Single-Channel, Ultra-Low-Power,
Delta-Sigma ADCs with GPIO
MAX11200/MAX11210
STAT1: Status Register
SYSOR: The system gain overrange bit when set to 1 indicates that a system gain calibration was over range. The
SCGC calibration coefficient is maximum value of 1.9999999. This bit, when set to 1, indicates that the full-scale value
out of the converter is likely not available.
RATE[2:0]: The data rate bits indicate the conversion rate that corresponds to the result in the DATA register or the
rate that was used for calibration coefficient calculation. If the previous conversions were done at a different rate, the
RATE[2:0] bits indicate a rate different than the rate of the conversion in progress.
OR: The overrange bit, OR, is set to 1 to indicate the conversion result has exceeded the maximum value of the
converter and that the result has been clipped or limited to the maximum value. The OR bit is set to 0 to indicate the
conversion result is within the full-scale range of the device.
UR: The underrange bit, UR, is set to 1 to indicate the conversion result has exceeded the minimum value of the
converter and that the result has been clipped or limited to the minimum value. The UR bit is set to 0 to indicate the
conversion result is within the full-scale range of the device.
MSTAT: The measurement status bit, MSTAT is set to 1 when a signal measurement is in progress. When MSTAT = 1,
a conversion, self-calibration, or system calibration is in progress and indicates that the modulator is busy. When the
modulator is not converting, the MSTAT bit is set to 0.
RDY: The RDY ready bit is set to 1 to indicate that a conversion result is available. Reading the DATA register resets the
RDY bit to 0 only after another conversion has been initiated. If the DATA has not been read before another conversion
is initiated, the RDY bit remains 1; if the DATA is read before another conversion is initiated, the RDY bit resets to 0. If
the DATA for the previous conversion is read during a following conversion, the RDY bit is reset immediately after the
DATA read operation has completed.
Table 11. STAT1 Register (Read Only)
BIT
B7
B6
B5
B4
B3
B2
B1
B0
BIT NAME
SYSOR
RATE2
RATE1
RATE0
OR
UR
MSTAT
RDY
DEFAULT
0
相關PDF資料 |
PDF描述 |
|---|---|
| HCC06DRTF-S13 | CONN EDGECARD 12POS .100 EXTEND |
| HK1608R47J-T | INDUCTOR HI FREQ 470NH 5% 0603 |
| PCM16XD0 | PROCESSOR MODULE FOR MPLAB-ICE |
| SDR1006-681KL | INDUCTOR POWER 680UH 0.28A SMD |
| 0982660110 | CBL 10POS 0.5MM JMPR TYPE D 8" |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX11200EVKIT+ | 功能描述:數據轉換 IC 開發工具 MAX11200 Eval Kit RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| MAX11201 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:24-Bit, Single-Channel, Ultra-Low-Power, Delta Sigma ADC with 2-Wire Serial Interface |
| MAX11201AEUB+ | 功能描述:模數轉換器 - ADC 24-Bit Delta-Sigma RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX11201AEUB+T | 功能描述:模數轉換器 - ADC 24-Bit Delta-Sigma RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX11201BEUB+ | 功能描述:模數轉換器 - ADC 24-Bit Delta-Sigma RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。