- 您現在的位置：買賣IC網 > PDF目錄2085 > MAX1118EKA+T (Maxim Integrated Products)IC ADC 8-BIT 100KSPS SOT23-8 PDF資料下載
參數資料
| 型號： | MAX1118EKA+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 14/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 8-BIT 100KSPS SOT23-8 |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 位數： | 8 |
| 采樣率（每秒）： | 100k |
| 數據接口： | MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 680µW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 |
| 供應商設備封裝： | SOT-23-8 |
| 包裝： | 標準包裝 |
| 輸入數目和類型： | 2 個單端，單極 |
| 產品目錄頁面： | 1395 (CN2011-ZH PDF) |
| 其它名稱： | MAX1118EKA+TDKR |
MAX1117/MAX1118/MAX1119
Single-Supply, Low-Power,
2-Channel, Serial 8-Bit ADCs
_______________________________________________________________________________________
9
nected to an autozero supply. Since the device
requires only a single supply, the negative input of the
comparator is set to equal VDD/2. The capacitive DAC
restores the positive input to VDD/2 within the limits of 8-
bit resolution. This action is equivalent to transferring a
charge QIN = 16pF x VIN from CHOLD to the binary-
weighted capacitive DAC, which in turn forms a digital
representation of the analog-input signal.
Input Voltage Range
Internal protection diodes that clamp the analog input
to VDD and GND allow the input pins (CH0, CH1) to
swing from (GND - 0.3V) to (VDD + 0.3V) without dam-
age. However, for accurate conversions, the inputs
must not exceed (VDD + 50mV) or be less than (GND -
50mV).
Input Bandwidth
The ADC’s input tracking circuitry has a 4MHz small-
signal bandwidth, so it is possible to digitize high-
speed transient events and measure periodic signals
with bandwidths exceeding the ADC’s sampling rate by
using undersampling techniques. To avoid high-fre-
quency signals being aliased into the frequency band
of interest, anti-alias filtering is recommended.
Serial Interface
The MAX1117/MAX1118/MAX1119 have a 3-wire serial
interface. The CNVST and SCLK inputs are used to
control the device, while the three-state DOUT pin is
used to access the conversion results.
The serial interface provides connection to microcon-
trollers (Cs) with SPI, QSPI, and MICROWIRE serial
interfaces at clock rates up to 5MHz. The interface sup-
ports either an idle high or low SCLK format. For SPI
and QSPI, set CPOL = CPHA = 0 or CPOL = CPHA = 1
in the SPI control registers of the C. Figure 5 shows
the MAX1117/MAX1118/MAX1119 common serial-inter-
face connections. See Figures 6a–6d for details on the
serial interface timing and protocol.
Digital Inputs and Outputs
The MAX1117/MAX1118/MAX1119 perform conver-
sions using an internal clock. This frees the P from the
burden of running the SAR conversion clock and allows
the conversion results to be read back at the P’s con-
venience at any clock rate up to 5MHz.
The acquisition interval begins with the falling edge of
CNVST. CNVST can idle between conversions in either
a high or low state. If idled in a low state, CNVST must
be brought high for at least 50ns, then brought low to
initiate a conversion. To select CH1 for conversion, the
CNVST pin must be brought high and low for a second
time (Figures 6c and 6d).
After CNVST is brought low, allow 7.5
μs for the conver-
sion to be completed. While the internal conversion is in
progress, DOUT is low. The MSB is present at the
DOUT pin immediately after conversion is completed.
The conversion result is clocked out at the DOUT pin
and is coded in straight binary (Figure 7). Data is
clocked out at SCLK’s falling edge in MSB-first format
at rates up to 5MHz. Once all data bits are clocked
out, DOUT goes high impedance (100ns to 500ns after
the rising edge) of the eighth SCLK pulse.
CNVST
SCLK
DOUT
I/O
SCK
MISO
+3V
SS
a) SPI
CNVST
SCLK
DOUT
CS
SCK
MISO
+3V
SS
b) QSPI
MAX1117
MAX1118
MAX1119
MAX1117
MAX1118
MAX1119
MAX1117
MAX1118
MAX1119
SCLK
DOUT
I/O
SK
SI
c) MICROWIRE
Figure 5. Common Serial-Interface Connections
相關PDF資料 |
PDF描述 |
|---|---|
| MAX11205BEUB+T | IC ADC 16BIT SRL 13.75SPS 10UMAX |
| MAX11206EEE+ | IC ADC 20BIT 16QSOP |
| MAX11208BEUB+ | IC ADC 20BIT SRL 13.75SPS 10UMAX |
| MAX11209EEE+T | ADC 18BIT DELT-SIG PROGR 16-QSOP |
| MAX11213EEE+ | IC ADC 16BIT 16QSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1119 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Single-Supply, Low-Power, 2-Channel, Serial 8-Bit ADCs |
| MAX11190ETE+ | 制造商:Maxim Integrated Products 功能描述:DUAL, 2.2V TO 3.6V, 12-BIT, 3MSPS SAR ADC IN TINY TQFN PACKA - Rail/Tube |
| MAX11190ETE+T | 制造商:Maxim Integrated Products 功能描述:DUAL, 2.2V TO 3.6V, 12-BIT, 3MSPS SAR ADC IN TINY TQFN PACKA - Tape and Reel |
| MAX1119EKA | 制造商:Maxim Integrated Products 功能描述:8 PIN COUNT SOT PACKAGE TYPE - Cut Tape Product |
| MAX1119EKA+ | 制造商:Maxim Integrated Products 功能描述:ADC SGL SAR 100KSPS 8BIT SERL 8PIN SOT-23 - Rail/Tube 制造商:Maxim Integrated Products 功能描述:IC 8BIT ADC SERIAL 2CH 8SOT |
發布緊急采購，3分鐘左右您將得到回復。