- 您現在的位置：買賣IC網 > PDF目錄45051 > M48T58Y-70MH1E (STMICROELECTRONICS) 0 TIMER(S), REAL TIME CLOCK, PDSO28 PDF資料下載
參數資料
| 型號： | M48T58Y-70MH1E |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 時鐘/數據恢復及定時提取 |
| 英文描述： | 0 TIMER(S), REAL TIME CLOCK, PDSO28 |
| 封裝： | 0.330 INCH, ROHS COMPLIANT, PLASTIC, SOH-28 |
| 文件頁數： | 11/33頁 |
| 文件大?。?/td> | 511K |
| 代理商： | M48T58Y-70MH1E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
M48T58, M48T58Y
Clock operations
Doc ID 2412 Rev 7
6.5
Battery low flag
The M48T58/Y automatically performs periodic battery voltage monitoring upon power-up.
The battery low flag (BL), bit D6 of the flags register 1FFDh, will be asserted high if the
internal or SNAPHAT battery is found to be less than approximately 2.5 V and the battery
low enable (BLE) bit has been previously set to '1.' The BL flag will remain active until
completion of battery replacement and subsequent battery low monitoring tests.
If a battery low is generated during a power-up sequence, this indicates that the battery
voltage is below 2.5 V (approximately), which may be insufficient to maintain data integrity.
Data should be considered suspect and verified as correct. A fresh battery should be
installed.
The SNAPHAT top may be replaced while VCC is applied to the device.
Note:
This will cause the clock to lose time during the interval the SNAPHAT battery/crystal top is
disconnected.
Note:
Battery monitoring is a useful technique only when performed periodically. The M48T58/Y
only monitors the battery when a nominal VCC is applied to the device. Thus applications
which require extensive durations in the battery back-up mode should be powered-up
periodically (at least once every few months) in order for this technique to be beneficial.
Additionally, if a battery low is indicated, data integrity should be verified upon power-up via
a checksum or other technique.
6.6
Century bit
Bit D5 and D4 of clock register 1FFCh contain the CENTURY ENABLE bit (CEB) and the
CENTURY bit (CB). Setting CEB to a '1' will cause CB to toggle, either from a '0' to '1' or
from '1' to '0' at the turn of the century (depending upon its initial state). If CEB is set to a '0,'
CB will not toggle.
Note:
The WRITE bit must be set in order to write to the CENTURY bit.
相關PDF資料 |
PDF描述 |
|---|---|
| M48T58Y-70PC1TR | 0 TIMER(S), REAL TIME CLOCK, PDIP28 |
| M48T59V-70MH1E | 0 TIMER(S), REAL TIME CLOCK, PDSO28 |
| M48T59V-70PC1 | 0 TIMER(S), REAL TIME CLOCK, PDIP28 |
| M48T59Y-70PC1DS | 0 TIMER(S), REAL TIME CLOCK, PDIP28 |
| M48T59V-70MH1TR | 0 TIMER(S), REAL TIME CLOCK, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M48T58Y-70MH1EE | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:5.0V, 64 Kbit (8 Kb x 8) TIMEKEEPER SRAM |
| M48T58Y-70MH1F | 功能描述:實時時鐘 64K (8Kx8) 70ns RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| M48T58Y-70MH1FE | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:5.0V, 64 Kbit (8 Kb x 8) TIMEKEEPER SRAM |
| M48T58Y-70MH1TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:5.0V, 64 Kbit (8 Kb x 8) TIMEKEEPER SRAM |
| M48T58Y-70MH1TRE | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:5.0V, 64 Kbit (8 Kb x 8) TIMEKEEPER SRAM |
發布緊急采購，3分鐘左右您將得到回復。