參數資料
型號: M48T35AV-10MH1F
廠商: STMICROELECTRONICS
元件分類: 時鐘/數據恢復及定時提取
英文描述: 0 TIMER(S), REAL TIME CLOCK, PDSO28
封裝: 0.330 INCH, ROHS COMPLIANT, PLASTIC, SOH-28
文件頁數: 6/29頁
文件大?。?/td> 512K
代理商: M48T35AV-10MH1F
Clock operations
M48T35AV
Doc ID 6845 Rev 8
Table 5.
Register map
Keys:
S = SIGN bit
FT = FREQUENCY TEST bit (must be set to '0' upon power for normal operation)
R = READ bit
W = WRITE bit
ST = STOP bit
0 = Must be set to '0'
CEB = CENTURY ENABLE bit
CB = CENTURY bit
Note:
When CEB is set to '1,' CB will toggle from '0' to '1' or from '1' to '0' at the turn of the century
(dependent upon the initial value set).
When CEB is set to '0,' CB will not toggle. The WRITE bit does not need to be set to write to
CEB.
3.4
Calibrating the clock
The M48T35AV is driven by a quartz-controlled oscillator with a nominal frequency of
32,768 Hz. The devices are tested not to exceed 35 ppm (parts per million) oscillator
frequency error at 25°C, which equates to about ±1.53 minutes per month. With the
calibration bits properly set, the accuracy of each M48T35AV improves to better than
+1/–2 ppm at 25°C.
The oscillation rate of any crystal changes with temperature (see Figure 9 on page 16).
Most clock chips compensate for crystal frequency and temperature shift error with
cumbersome “trim” capacitors. The M48T35AV design, however, employs periodic counter
correction. The calibration circuit adds or subtracts counts from the oscillator divider circuit
at the divide by 256 stage, as shown in Figure 10 on page 16. The number of times pulses
are blanked (subtracted, negative calibration) or split (added, positive calibration) depends
upon the value loaded into the five calibration bits found in the control register. Adding
counts speeds the clock up, subtracting counts slows the clock down.
The calibration byte occupies the five lower order bits (D4-D0) in the control register 7FF8h.
These bits can be set to represent any value between 0 and 31 in binary form. Bit D5 is the
SIGN bit; '1' indicates positive calibration, '0' indicates negative calibration. Calibration
Address
Data
Function/range
BCD format
D7
D6
D5
D4
D3
D2
D1
D0
7FFFh
10 years
Year
00-99
7FFEh
0
10 M.
Month
01-12
7FFDh
0
10 date
Date
01-31
7FFCh
0
FT
CEB
CB
0
Day
Century/day
00-01/01-07
7FFBh
0
10 hours
Hours
00-23
7FFAh
0
10 minutes
Minutes
00-59
7FF9h
ST
10 seconds
Seconds
00-59
7FF8h
W
R
S
Calibration
Control
相關PDF資料
PDF描述
M48T35AY-70MH6F REAL TIME CLOCK, PDSO28
M48T35AY-70MH6TR 0 TIMER(S), REAL TIME CLOCK, PDSO28
M48T35AV-10MH1 0 TIMER(S), REAL TIME CLOCK, PDSO28
M48T35AY-70MH1F REAL TIME CLOCK, PDSO28
M48T35AV-10MH6E REAL TIME CLOCK, PDSO28
相關代理商/技術參數
參數描述
M48T35AV-10MH1TR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:256 Kbit 32Kb x8 TIMEKEEPER SRAM
M48T35AV-10MH6 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:256 Kbit 32Kb x8 TIMEKEEPER SRAM
M48T35AV-10MH6E 功能描述:NVRAM 256K (32Kx8) 100ns BULK RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube
M48T35AV-10MH6F 功能描述:NVRAM 256K (32Kx8) 100ns RoHS:否 制造商:Maxim Integrated 數據總線寬度:8 bit 存儲容量:1024 Kbit 組織:128 K x 8 接口類型:Parallel 訪問時間:70 ns 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 工作電流:85 mA 最大工作溫度:+ 70 C 最小工作溫度:0 C 封裝 / 箱體:EDIP 封裝:Tube
M48T35AV-10MH6TR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:256 Kbit 32Kb x8 TIMEKEEPER SRAM