- 您現在的位置：買賣IC網 > PDF目錄45049 > M41T66Q6F (STMICROELECTRONICS) REAL TIME CLOCK, QCC16 PDF資料下載
參數資料
| 型號： | M41T66Q6F |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 時鐘/數據恢復及定時提取 |
| 英文描述： | REAL TIME CLOCK, QCC16 |
| 封裝： | 3 X 3 MM, ROHS COMPLIANT, QFN-16 |
| 文件頁數： | 14/33頁 |
| 文件大?。?/td> | 336K |
| 代理商： | M41T66Q6F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
M41T66
Clock operation
3.7
Output driver pin
When the OFIE bit, AFE bit, and watchdog register are not set to generate an interrupt, the
IRQ/OUT pin becomes an output driver that reflects the contents of D7 of the calibration
register. In other words, when D7 (OUT bit) is a '0,' then the IRQ/OUT pin will be driven low.
Note:
The IRQ/OUT pin is an open drain which requires an external pull-up resistor.
3.8
Oscillator stop detection
If the oscillator fail (OF) bit is internally set to a '1,' this indicates that the oscillator has either
stopped, or was stopped for some period of time and can be used to judge the validity of the
clock and date data. This bit will be set to '1' any time the oscillator stops.
In the event the OF bit is found to be set to '1' at any time other than the initial power-up, the
STOP bit (ST) should be written to a '1,' then immediately reset to '0.' This will restart the
oscillator.
The following conditions can cause the OF bit to be set:
●
The first time power is applied (defaults to a '1' on power-up).
●
The voltage present on VCC or battery is insufficient to support oscillation.
●
The ST bit is set to '1.'
●
External interference of the crystal
If the oscillator fail interrupt enable bit (OFIE) is set to a '1,' the IRQ/OUTpin will also be
activated. The IRQ/OUT output is cleared by resetting the OFIE or OF bit to '0' (NOT by
reading the flag register).
The OF bit will remain set to '1' until written to logic '0.' The oscillator must start and have
run for at least 1 second before attempting to reset the OF bit to '0.' If the trigger event
occurs during a power-down condition, this bit will be set correctly.
相關PDF資料 |
PDF描述 |
|---|---|
| M41T81M6F | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| M41T81MY6TR | 1 TIMER(S), REAL TIME CLOCK, PDSO18 |
| M41T81MX6 | 1 TIMER(S), REAL TIME CLOCK, PDSO28 |
| M41T81SM6F | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
| M41T81SM6E | 1 TIMER(S), REAL TIME CLOCK, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M41T80 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SERIAL ACCESS RTC WITH ALARMS |
| M41T80_06 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial access Real Time Clock with alarm |
| M41T80_11 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial access real-time clock with alarm |
| M41T80M | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SERIAL ACCESS RTC WITH ALARMS |
| M41T80M6 | 功能描述:實時時鐘 USE 511-M41T80M6E RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。