參數資料
型號: M38749MFT-XXXGP
廠商: Mitsubishi Electric Corporation
英文描述: SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
中文描述: 單芯片8位CMOS微機
文件頁數: 29/92頁
文件大?。?/td> 1292K
代理商: M38749MFT-XXXGP
35
3874 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
Fig. 29 Operation of UART serial I/O function
(2) Asynchronous Serial I/O (UART) Mode
Clock asynchronous serial I/O mode (UART) can be selected by
clearing the serial I/O1 mode selection bit (b6) of the serial I/O1
control register to “0”.
Eight serial data transfer formats can be selected, and the transfer
formats used by a transmitter and receiver must be identical.
The transmit and receive shift registers each have a buffer regis-
Fig. 28 Block diagram of UART serial I/O1
ter, but the two buffers have the same address in memory. Since
the shift register cannot be written to or read from directly, transmit
data is written to the transmit buffer, and receive data is read from
the receive buffer.
The transmit buffer can also hold the next data to be transmitted,
and the receive buffer register can hold a character while the next
character is being received.
XIN
1/4
OE
PE FE
1/16
Data bus
Receive buffer register
Address 001816
Receive shift register
Receive buffer full flag (RBF)
Receive interrupt request (RI)
Baud rate generator
Frequency division ratio 1/(n+1)
Address 001C16
ST/SP/PA generator
Transmit buffer register
Data bus
Transmit shift register
Address 001816
Transmit shift register shift completion flag (TSC)
Transmit buffer empty flag (TBE)
Transmit interrupt request (TI)
Address 001916
STdetector
SP detector
UART control register
Address 001B16
Character length selection bit
Address 001A16
BRG count source selection bit
Transmit interrupt source selection bit
Serial I/O1 synchronous clock selection bit
Clock control circuit
Character length selection bit
7 bits
8 bits
Serial I/O control register
P46/SCLK1
Serial I/O1 status register
P44/RXD
P45/TXD
TSC=0
TBE=1
RBF=0
TBE=0
RBF=1
ST
D0
D1
SP
D0
D1
ST
SP
TBE=1
TSC=1V
ST
D0
D1
SP
D0
D1
ST
SP
Transmit buffer write signal
VGenerated at 2nd bit in 2-stop-bit mode
1 start bit
7 or 8 data bits
1 or 0 parity bit
1 or 2 stop bit (s)
1 : Error flag detection occurs at the same time that the RBF flag becomes “1” (at 1st stop bit, during reception).
2 : The transmit interrupt (TI) can be selected to occur when either the TBE or TSC flag becomes “1”, depending on the setting of the transmit interrupt
source selection bit (TIC) of the serial I/O1 control register.
3 : The receive interrupt (RI) is set when the RBF flag becomes “1”.
4 : After data is written to the transmit buffer register when TSC=1, 0.5 to 1.5 cycles of the data shift cycle is necessary until changing to TSC=0.
Notes
Serial I/O output TXD
Serial I/O input RXD
Receive buffer read signal
Transmit or receive clock
相關PDF資料
PDF描述
M38B41E1H-XXXXFP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38B42E1H-XXXXFP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38B48E1H-XXXXFP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M39012/01-0017 CABLE TERMINATED, MALE, N CONNECTOR, CRIMP, PLUG
M39012/01-0501 CABLE TERMINATED, MALE, N CONNECTOR, CRIMP, PLUG
相關代理商/技術參數
參數描述
M38749T-RPD 功能描述:EMULATION POD FOR 38000 SERIES 3 RoHS:否 類別:編程器,開發(fā)系統(tǒng) >> 配件 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program RoHS指令信息:IButton RoHS Compliance Plan 標準包裝:1 系列:- 附件類型:USB 至 1-Wire? RJ11 適配器 適用于相關產品:1-Wire? 設備 產品目錄頁面:1429 (CN2011-ZH PDF)
M3874-BK001 制造商:Alpha Wire 功能描述:
M3874-BK002 制造商:Alpha Wire 功能描述:
M3874-BK005 制造商:Alpha Wire 功能描述:
M3874-BK199 制造商:Alpha Wire 功能描述: