![](http://datasheet.mmic.net.cn/30000/M38507F8FP_datasheet_2360437/M38507F8FP_240.png)
3-32
APPENDIX
3850 Group (Spec. H) User’s Manual
3.3 Notes on use
3.3.2 Termination of unused pins
(1)
Terminate unused pins
Output ports : Open
Input ports :
Connect each pin to VCC or VSS through each resistor of 1 k
to 10 k.
As for pins whose potential affects to operation modes such as pins CNVSS, INT or others, select
the VCC pin or the VSS pin according to their operation mode.
I/O ports :
Set the I/O ports for the input mode and connect them to VCC or VSS through each resistor of
1 k
to 10 k.
Set the I/O ports for the output mode and open them at “L” or “H”.
When opening them in the output mode, the input mode of the initial status remains until the
mode of the ports is switched over to the output mode by the program after reset. Thus, the
potential at these pins is undefined and the power source current may increase in the input
mode. With regard to an effects on the system, thoroughly perform system evaluation on the user
side.
Since the direction register setup may be changed because of a program runaway or noise, set
direction registers by program periodically to increase the reliability of program.
The AVss pin when not using the A-D converter :
When not using the A-D converter, handle a power source pin for the A-D converter, AVss pin
as follows:
AVss: Connect to the Vss pin.
(2)
Termination remarks
Input ports and I/O ports :
Do not open in the input mode.
q Reason
The power source current may increase depending on the first-stage circuit.
An effect due to noise may be easily produced as compared with proper termination and
shown on the above.
I/O ports :
When setting for the input mode, do not connect to VCC or VSS directly.
q Reason
If the direction register setup changes for the output mode because of a program runaway or
noise, a short circuit may occur between a port and VCC (or VSS).
I/O ports :
When setting for the input mode, do not connect multiple ports in a lump to VCC or VSS through
a resistor.
q Reason
If the direction register setup changes for the output mode because of a program runaway or
noise, a short circuit may occur between ports.
At the termination of unused pins, perform wiring at the shortest possible distance (20 mm or less)
from microcomputer pins.