參數資料
型號: M38039M5-XXXWG
廠商: Renesas Technology Corp.
英文描述: SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
中文描述: 單芯片8位CMOS微機
文件頁數: 70/119頁
文件大?。?/td> 1575K
代理商: M38039M5-XXXWG
Rev.1.00
REJ03B0212-0100
Apr 2, 2007
Page 70 of 117
3803 Group (Spec.L)
Boot Mode
The control program for CPU rewrite mode must be written into
the User ROM or Boot ROM area in parallel I/O mode
beforehand. (If the control program is written into the Boot ROM
area, the standard serial I/O mode becomes unusable.)
See Figure 67 for details about the Boot ROM area.
Normal microcomputer mode is entered when the
microcomputer is reset with pulling CNV
SS
pin low. In this case,
the CPU starts operating using the control program in the User
ROM area.
When the microcomputer is reset and the CNV
SS
pin high after
pulling the P4
5
/TxD
1
pin and CNV
SS
pin high, the CPU starts
operating (start address of program is stored into addresses
FFFC
16
and FFFD
16
) using the control program in the Boot
ROM area. This mode is called the “Boot mode”. Also, User
ROM area can be rewritten using the control program in the Boot
ROM area.
Block Address
Block addresses refer to the maximum address of each block.
These addresses are used in the block erase command.
CPU Rewrite Mode
In CPU rewrite mode, the internal flash memory can be operated
on (read, program, or erase) under control of the Central
Processing Unit (CPU).
In CPU rewrite mode, only the User ROM area shown in Figure
67 can be rewritten; the Boot ROM area cannot be rewritten.
Make sure the program and block erase commands are issued for
only the User ROM area and each block area.
The control program for CPU rewrite mode can be stored in
either User ROM or Boot ROM area. In the CPU rewrite mode,
because the flash memory cannot be read from the CPU, the
rewrite control program must be transferred to internal RAM
area before it can be executed.
Fig 67. Block diagram of built-in flash memory
Data block A:
2 Kbytes
Block 3: 24 Kbytes
Block 2: 16 Kbytes
Block 1: 8 Kbytes
Block 0: 8 Kbytes
FFFF
16
E000
16
C000
16
8000
16
2000
16
1800
16
1000
16
User ROM area
Data block B:
2 Kbytes
SFR area
Internal RAM area
(2 Kbytes)
FFFF
16
1000
16
0FFF
16
0FE0
16
083F
16
0040
16
0000
16
FFFF
16
F000
16
Boot ROM area
4 Kbytes
SFR area
Internal flash memory area
(60 Kbytes)
RAM
Notes 1
: The boot ROM area can be rewritten
in a parallel I/O mode. (Access to
except boot ROM area is disabled.)
2
: To specify a block, use the maximum
address in the block.
3
: The mask ROM version has the
reserved ROM area. Note the
difference of the area.
相關PDF資料
PDF描述
M38039M6L-XXXHP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38039M6L-XXXKP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38039M6L-XXXSP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M38039M6L-XXXWG 18-Mbit (512K x 36/1M x 18) Pipelined SRAM with NoBL(TM) Architecture; Architecture: NoBL, Pipeline; Density: 18 Mb; Organization: 512Kb x 36; Vcc (V): 3.1 to 3.6 V
M38039M6-XXXHP SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
相關代理商/技術參數
參數描述
M38049FFFP#U0 制造商:Renesas Electronics Corporation 功能描述:
M38049FFLHP#U0 制造商:Renesas Electronics Corporation 功能描述:
M38049RLSS 功能描述:DEV EMULATOR CHIP RAM 2KB 64SDIP RoHS:否 類別:編程器,開發系統 >> 內電路編程器、仿真器以及調試器 系列:- 產品變化通告:Development Systems Discontinuation 19/Jul/2010 標準包裝:1 系列:* 類型:* 適用于相關產品:* 所含物品:*
M3806 功能描述:電纜固定件和配件 LTSCG 625 BLACK RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M3806 BK001 制造商:Alpha Wire Company 功能描述:CBL 8COND 18AWG BLK 1000'