參數資料
型號： LTM9010IY-14#PBF
廠商： Linear Technology
文件頁數： 22/40頁
文件大?。?/td> 0K
描述： IC ADC 14BIT UMODULE 140-BGA
標準包裝： 210
系列： µModule®
位數： 14
采樣率（每秒）： 105M
數據接口： Serial LVDS
轉換器數目： 8
功率耗散（最大）： 1.11W
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 140-BFBGA
供應商設備封裝： 140-BGA（11.25x9）
包裝： 托盤
輸入數目和類型： 8 Differential; 8 Single-Ended
29
9009101114fa
LTM9011-14/
LTM9010-14/LTM9009-14
applicaTions inForMaTion
Table 4. Serial Programming Mode Register Map (PAR/SER = GND)
REGISTER A0: RESET REGISTER (ADDRESS 00h)
D7
D6
D5
D4
D3
D2
D1
D0
RESET
X
Note That CSA Controls Channels 1, 4, 5 and 8, CSB Controls Channels 2, 3, 6 and 7.
Bit 7
RESET
Software Reset Bit
0 = Not Used
1 = Software Reset. All Mode Control Registers Are Reset to 00h. The ADC Is Momentarily Placed in SLEEP Mode.
After the Reset SPI Write Command Is Complete, Bit D7 Is Automatically Set Back to Zero. The Reset Register Is Write Only.
Bits 6-0
Unused, Don’t Care Bits.
REGISTER A1 (CSA): FORMAT AND POWER-DOWN REGISTER (ADDRESS 01h with CSA = GND)
D7
D6
D5
D4
D3
D2
D1
D0
DCSOFF
RAND
TWOSCOMP
SLEEP
NAP_8
NAP_5
NAP_4
NAP_1
Note That CSA Controls Channels 1, 4, 5 and 8, CSB Controls Channels 2, 3, 6 and 7.
Bit 7
DCSOFF
Clock Duty Cycle Stabilizer Bit
0 = Clock Duty Cycle Stabilizer On
1 = Clock Duty Cycle Stabilizer Off. This Is Not Recommended.
Bit 6
RAND
Data Output Randomizer Mode Control Bit
0 = Data Output Randomizer Mode Off
1 = Data Output Randomizer Mode On
Bit 5
TWOSCOMP Two’s Complement Mode Control Bit
0 = Offset Binary Data Format
1 = Two’s Complement Data Format
Bits 4-0
SLEEP: NAP_X Sleep/Nap Mode Control Bits
00000 = Normal Operation
0XXX1 = Channel 1 in Nap Mode
0XX1X = Channel 4 in Nap Mode
0X1XX = Channel 5 in Nap Mode
01XXX = Channel 8 in Nap Mode
1XXXX = Sleep Mode. Channels 1, 4, 5 and 8 Are Disabled
Note: Any Combination of Channels Can Be Placed in Nap Mode.
are ignored. The data transfer ends when CS is taken
high again.
The first bit of the 16-bit input word is the R/W bit. The
next seven bits are the address of the register (A6:A0).
The final eight bits are the register data (D7:D0).
If the R/W bit is low, the serial data (D7:D0) will be writ-
ten to the register set by the address bits (A6:A0). If the
R/W bit is high, data in the register set by the address
bits (A6:A0) will be read back on the SDO pin (see the
Timing Diagrams section). During a read back command
the register is not updated and data on SDI is ignored.
The SDO pin is an open-drain output that pulls to ground
with a 200 impedance. If register data is read back
through SDO, an external 2k pull-up resistor is required.
If serial data is only written and read back is not needed,
then SDO can be left floating and no pull-up resistor
is needed. Table 4 shows a map of the mode control
registers.
相關PDF資料
PDF描述
LTM9010CY-14#PBF IC ADC 14BIT UMODULE 140BGA
VI-242-IW-F3 CONVERTER MOD DC/DC 15V 100W
MAX3460CSD+ IC TXRX RS485/422 14-SOIC
VE-2WP-IV-B1 CONVERTER MOD DC/DC 13.8V 150W
MAX3467CSA+ IC TXRX RS485/422 8-SOIC
相關代理商/技術參數
參數描述
LTM9011-14 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad 14-Bit, 125Msps ADC with Integrated Drivers
LTM9011CY-14 制造商:Linear Technology 功能描述:ADC 14BIT UMODULE 140BGA 制造商:Linear Technology 功能描述:ADC, 14BIT, UMODULE, 140BGA
LTM9011CY-14#PBF 功能描述:IC ADC 14BIT UMODULE 140BGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:µModule® 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTM9011IY-14#PBF 功能描述:IC ADC 14BIT UMODULE 140-BGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:µModule® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTM9012 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad 14-Bit, 125Msps ADC with Integrated Drivers
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*