- 您現在的位置：買賣IC網 > Datasheet目錄42 > LTC4257CS8 (Linear Technology)IC CTRLR INTFACE PWR/ETHER 8SOIC Datasheet資料下載
參數資料
| 型號： | LTC4257CS8 |
| 廠商： | Linear Technology |
| 文件頁數： | 12/20頁 |
| 文件大?。?/td> | 263K |
| 描述： | IC CTRLR INTFACE PWR/ETHER 8SOIC |
| 標準包裝： | 100 |
| 類型： | 以太網供電開關（PoE） |
| 應用： | IP 電話，LAN 網絡供電，網絡路由器和交換機 |
| 內部開關： | 是 |
| 電流限制： | 350mA |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
| 產品目錄頁面： | 1338 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
LTC4257
12
4257fb
EXTERNAL INTERFACE AND COMPONENT SELECTION
Transformer
Nodes on an Ethernet network commonly interface to the
outside world via an isolation transformer (Figure 8). For
powered devices, the isolation transformer must include
a center tap on the media (cable) side. Proper termination
is required around the transformer to provide correct
impedance matching and to avoid radiated and conducted
emissions. Transformer vendors such as Pulse, Bel Fuse,
Tyco and others (Table 3) can provide assistance with
selection of an appropriate isolation transformer and
proper termination methods. These vendors have trans-
formers specifically designed for use in PD applications.
Table 3. Power over Ethernet Transformer Vendors
VENDOR
CONTACT INFORMATION
Pulse Engineering
12220 World Trade Drive
San Diego, CA 92128
Tel: 858-674-8100
FAX: 858-674-8262
http://www.pulseeng.com/
Bel Fuse Inc.
206 Van Vorst Street
Jersey City, NJ 07302
Tel: 201-432-0463
FAX: 201-432-9542
http://www.belfuse.com/
Tyco Electronics
308 Constitution Drive
Menlo Park, CA 94025-1164
Tel: 800-227-7040
FAX: 650-361-2508
http://www.circuitprotection.com/
Diode Bridges
IEEE 802.3af allows power wiring in either of two configu-
rations on the TX/RX wires, plus power can be applied to
the PD via the spare wire pair in the RJ45 connector. The
PD is required to accept power in either polarity on both
the main and spare inputs, therefore it is common to install
diode bridges on both inputs in order to accommodate the
different wiring configurations. Figure 8 demonstrates an
implementation of these diode bridges. The specification
also mandates that the leakage back through the unused
bridge be less than 28礎 when the PD is powered with
57V.
The IEEE standard includes an AC impedance requirement
in order to implement the AC disconnect function. Capaci-
tor C14 in Figure 8 is used to meet this AC impedance
requirement. A 0.1礔 capacitor is recommended for this
application.
The LTC4257 has several different modes of operation
based on the voltage present between the V
IN
and GND
pins. The forward voltage drop of the input diodes in a PD
design subtracts from the input voltage and will affect the
transition point between modes. When using the LTC4257,
it is necessary to pay close attention to this forward
voltage drop. Selection of oversized diodes will help keep
the PD thresholds from exceeding IEEE specifications.
The input diode bridge of a PD can consume 4% of the
avialable power in some applications. It may be desirable
to use Scottky diodes in order to reduce this power loss.
APPLICATIO S I FOR ATIO
U
U
U
Figure 8. PD Front End with Isolation Transformer, Diode Bridges and Capacitor
16
14
15
1
3
2
RX
6
RX
+
3
TX
2
TX
+
RJ45
T1
PULSE H2019
4257 F08
1
7
8
5
4
11
9
10
6
8
7
D3
SMAJ58A
TVS
BR1
DF01SA
BR2
DF01SA
TO PHY
GND
8
5
4
LTC4257
C1
V
IN
V
OUT
V
OUT
SPARE
SPARE
+
C14
0.1礔
100V
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4260IUH#PBF | IC HOT SWAP CNTRL I2C 32-QFN |
| LTC4261IGN-2#PBF | IC CTRLR HOTSWAP W/ADC 28-SSOP |
| LTC4263IS#TRPBF | IC IEEE 803.2AF CNTRLR 14-SOIC |
| LTC4268IDKD-1#PBF | IC PD HIGH POWER W/CNTRL 32-DFN |
| LTC4274CUHF#PBF | IC CONTROLLER POE 38-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4257CS8-#1TRPBF | 制造商:LINEAR_TECH 功能描述: |
| LTC4257CS8#PBF | 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4257CS8#TR | 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4257CS8#TRPBF | 功能描述:IC CTRLR INTFACE PWR/ETHER 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4257CS81 | 制造商:Linear Technology 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。