- 您現在的位置：買賣IC網 > PDF目錄98003 > LTC3773EG (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO36 PDF資料下載
參數資料
| 型號： | LTC3773EG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO36 |
| 封裝： | 5.30 MM, PLASTIC, SSOP-36 |
| 文件頁數： | 5/32頁 |
| 文件大?。?/td> | 461K |
| 代理商： | LTC3773EG |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC3773
13
3773fa
Main Control Loop
The LTC3773 uses a constant frequency, current mode
step down architecture. During normal operation, each
top MOSFET is turned on each cycle when the oscillator
sets the RS latch, and turned off when the main current
comparator, I1, resets the RS latch. The peak inductor
current at which I1 resets the RS latch is controlled by
the voltage on the ITH pin, which is the output of the error
amplier EA. The error amplier input pin, VFB, receives the
output voltage feedback signal from an external resistor
divider. This feedback signal is compared to the internal
0.6V reference voltage by the EA. When the load current
increases it causes a slight decrease in VFB relative to the
0.6V reference, which in turn causes the ITH voltage to
increase until the average inductor current matches the
new load current. While the top N-channel MOSFET is off,
the bottom N-channel MOSFET is turned on until either the
next cycle begins or the inductor current starts to reverse,
as indicated by the current reversal comparator, I2.
The top MOSFET drivers are biased from oating boot-
strap capacitor CB, which is normally recharged during
each off cycle through an external Schottky diode. When
VIN decreases to a voltage close to VOUT, however, the
loop may enter dropout and attempt to turn on the top
MOSFET continuously. The dropout detector counts the
number of oscillator cycles that the bottom MOSFET
remains off and periodically triggers a brief refresh pulse
to recharge CB.
Shutdown, Soft-Start and Tracking Startup
The main control loop is enabled by allowing the SDBn pin
to go high. In the G package, SDB1, SDB2 and SDB3 are
shorted together at the SDB pin. The power-up thresholds
for channels 1, 2 and 3 are set at 1.2V, 1.8V and 2.4V
respectively. By forcing the SDB1, SDB2 and SDB3 pins
below 0.4V, the IC enters low current shutdown mode, and
the chip draws less than 30A. Releasing SDBn allows an
internal 0.5A current source to pull up the SDBn pin. If
a resistive divider connected to VIN drives the SDB pin,
the controller will automatically start up when VIN is fully
powered up.
The start-up of VOUT is controlled by the LTC3773’s TRACK
pin. An external capacitor at the TRACK pin provides the
soft-start function. During soft-start, the error amplier
EA compares the feedback signal, VFB, to the TRACK pin’s
potential (instead of the 0.6V reference), which rises linearly
from 0V to 0.6V. This allows the output voltage to rise
smoothly from 0V to its nal value while maintaining control
of the inductor current. When the potential at the TRACK
pin approaches the 0.6V reference voltage, the control
loop servos VFB to the internal reference. The TRACK pin
can also be used for power up/down tracking. A resistor
divider on VOUT1 connected to the TRACK2/TRACK3 pin
allows the startup of VOUT2/VOUT3 to track that of VOUT1
(refer to the Soft-Start/Tracking section for more detail).
Low Current Operation
The PLLIN/FC pin is a multifunction pin: 1) an external
clock input for PLL synchronization, and 2) a logic input
to select between three modes of operation.
A) Continuous Current Operation: When the PLLIN/FC
pin voltage is above 3V or driven by an external oscil-
lator, the controller performs as a continuous, PWM
current mode synchronous switching regulator. The
top and bottom MOSFETs are alternately turned on to
maintain the output voltage independent of direction
of inductor current. This is the least efcient light load
operating mode, but has lowest output ripple. The
output can source or sink current in this mode. When
sinking current while in forced continuous operation,
the controller can cause current to ow back into the
input supply lter capacitor. Be sure to use an input
capacitor with enough capacitance to prevent the input
voltage from boosting too high. See CIN and COUT Se-
lection in the Applications Information section. Certain
applications must not allow continuous operation at
startup with prebiased output or power down; this can
be easily avoided by shorting the PGOOD output to the
PLLIN/FC pin. The controller will be forced to operate
in Burst Mode until all three outputs are within 10%
of their nominal values.
B) Burst Mode Operation: When the PLLIN/FC pin volt-
age is below 1V and the regulated output voltage is
within 10% of its nominal value, the controller behaves
(Refer to the Functional Diagram)
OPERATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3801ES6#PBF | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803ES6-3 | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803IS6-3 | 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3805HMSE-5#TRPBF | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805MPMSE-5#PBF | SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3773EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3773EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3773EUHF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Triple-OUT Sync Step Down 3.3V to 36V Input 38-Pin QFN EP |
| LTC3773EUHF#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3773EUHF#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。