參數資料
型號： LTC3773EG
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO36
封裝： 5.30 MM, PLASTIC, SSOP-36
文件頁數： 2/32頁
文件大?。?/td> 461K
代理商： LTC3773EG
LTC3773
10
3773fa
SENSE1+ (Pin 1/Pin 34): The (+) Input to the Channel 1
Differential Current Comparator. The ITH1 pin voltage and
controlled offsets between the SENSE1– and SENSE1+
pins in conjunction with RSENSE set the channel 1 current
trip threshold.
SENSE1– (Pin 2/Pin 35): The (–) Input to the Channel 1
Differential Current Comparator.
SDB/SDB1, SDB2, SDB3 (Pin 3/Pins 36, 37, 38): Shut-
down, Active Low. For G package, SDB1, SDB2 and SDB3
are shorted at the SDB pin. The power up thresholds for
channel 1, 2 and 3 are set at 1.2V, 1.8V and 2.4V respec-
tively. By pulling the SDB1, SDB2 and SDB3 pins below
0.4V, the IC is put into low current shutdown mode (IVCCQ
<30A). There is a 0.5A pull-up current at each SDB pin.
An external capacitor can be added at this pin to provide
power up delay.
TRACK1 (Pin 4/Pin 1): Channel 1 Tracking Input. TRACK1
is used for tracking multiple LTC3773s. See the Startup
Tracking application. To disable this feature, oat this pin
or tie it to VCC. TRACK1 provides a 1A pull-up current.
An external capacitor can be added at this pin to provide
soft-start. During startup or output short-circuit condition,
if the potential at TRACK1 is less than 0.54V, current limit
foldback is disabled. When channel 1 is powered down,
this pin will be pulled low.
VFB1 (Pin 5/Pin 2): Channel 1 Error Amplier Feedback
Input. This pin connects the error amplier input to an
external resistive divider from VOUT1.
ITH1 (Pin 6/Pin 3): Channel 1 Error Amplier Output and
Switching Regulator Compensation Point. The current
comparator’s threshold increases with this control volt-
age.
SGND (Pin 7/Pin 4): Signal Ground. This pin must be
routed separately under the IC to the PGND pin and then
to the main ground plane.
ITH2 (Pin 8/Pin 5): Channel 2 Error Amplier Output and
Switching Regulator Compensation Point. See ITH1.
ITH3 (Pin 9/Pin 6): Channel 3 Error Amplier Output and
Switching Regulator Compensation Point. See ITH1.
VFB2 (Pin 10/Pin 7): Channel 2 Error Amplier Feedback
Input. See VFB1.
VFB3 (Pin 11/Pin 8): Channel 3 Error Amplier Feedback
Input. See VFB1.
TRACK2 (Pin 12/Pin 9): Channel 2 Tracking Input. Tie the
TRACK2 pin to a resistive divider connected to the output
of channel 1 for either coincident or ratiometric output
tracking. See the Soft-Start/Tracking application. TRACK2
comes with a 1A pull-up current. An external capacitor
can be added at this pin to provide soft-start. During
startup or output short-circuit condition, if the potential
at TRACK2 is less than 0.54V, current limit foldback is
disabled. When channel 2 is powered down, this pin will
be pulled low.
TRACK3 (Pin 13/Pin 10): Channel 3 Tracking Input. See
TRACK2.
SENSE2– (Pin 14/Pin 11): The (–) Input to the Channel 2
Differential Current Comparator. See SENSE1–.
SENSE2+ (Pin 15/Pin 12): The (+) Input to the Channel 2
Differential Current Comparator. See SENSE1+.
SENSE3– (Pin 16/Pin 13): The (–) Input to the Channel 3
Differential Current Comparator. See SENSE1–.
SENSE3+ (Pin 17/Pin 14): The (+) Input to the Channel 3
Differential Current Comparator. See SENSE1+.
VCC (Pin 18/Pin 15): Main Input Supply. All internal circuits
except the output drivers are powered from this pin. VCC
should be connected to a low noise 5V power supply and
should be bypassed to SGND with at least a 1F capacitor
in close proximity to the LTC3773.
PLLFLTR (Pin 19/Pin 16): Phase-Locked Loop Lowpass
Filter. The phase-locked loop’s lowpass lter is tied to this
pin. Alternatively, when external frequency synchronizing
is not used, this pin can be forced low, left oating or tied
high to vary the frequency of the internal oscillator.
PIN FUNCTIONS (G/UHF)
相關PDF資料
PDF描述
LTC3801ES6#PBF 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO6
LTC3803ES6-3 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6
LTC3803IS6-3 1 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO6
LTC3805HMSE-5#TRPBF SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10
LTC3805MPMSE-5#PBF SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO10
相關代理商/技術參數
參數描述
LTC3773EG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3773EG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3773EUHF 制造商:Linear Technology 功能描述:DC DC Cntrlr Triple-OUT Sync Step Down 3.3V to 36V Input 38-Pin QFN EP
LTC3773EUHF#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3773EUHF#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*