參數資料
型號: LTC3731HUH#PBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 5 A SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PQCC32
封裝: 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32
文件頁數: 3/34頁
文件大小: 427K
代理商: LTC3731HUH#PBF
LTC3731H
3731Hfb
C) Continuous Current Operation
Tying the FCB pin to ground will force continuous current
operation.Thisistheleastefficientoperatingmode,butmay
be desirable in certain applications. The output can source
or sink current in this mode. When sinking current while
in forced continuous operation, the controller will cause
current to flow back into the input filter capacitor. If large
enough, the input capacitor will prevent the input supply
from boosting to unacceptably high levels; see CIN/COUT
selection in the Applications Information section.
Frequency Synchronization
The phase-locked loop allows the internal oscillator to be
synchronized to an external source using the PLLIN pin.
The output of the phase detector at the PLLFLTR pin is
also the DC frequency control input of the oscillator, which
operates over a 225kHz to 680kHz range corresponding
to a voltage input from 0V to 2.4V. When locked, the
PLL aligns the turn on of the top MOSFET to the rising
edge of the synchronizing signal. When no frequency
information is supplied to the PLLIN pin, PLLFLTR goes
low, forcing the oscillator to minimum frequency. A DC
source can be applied to the PLLFLTR pin to externally
set the desired operating frequency. A discharge current
of approximately 20A will be present at the pin with no
PLLIN input signal.
Input capacitance ESR requirements and efficiency losses
are reduced substantially in a multiphase architecture
because the peak current drawn from the input capacitor
is effectively divided by the number of phases used and
power loss is proportional to the RMS current squared. A
3-stage, single output voltage implementation can reduce
input path power loss by 90%.
Power Good
The PGOOD pin is connected to the drain of an internal
N-channel MOSFET. The MOSFET is turned on once an
internal delay of about 100s has elapsed and the output
voltage has been away from its nominal value by greater
than 10%. If the output returns to normal prior to the delay
timeout, the timer is reset. There is no delay time for the
rising of the PGOOD output once the output voltage is
within the ±10% “window.”
Phase Mode
The PHASMD pin determines the phase shift between
the rising edge of the TG1 output and the rising edge of
the CLKOUT signal. Grounding the pin will result in 30
degrees phase shift and tying the pin to VCC will result
in 60 degrees. These phase shift values enable extension
to 6- and 12-phase systems. The PGOOD function above
and the PHASMD function are tied to a common pin in
the UH package.
Undervoltage Shutdown Adjust
The voltage applied to the UVADJ pin is compared to the
internal1.2Vreferencetohaveanexternallyprogrammable
undervoltage shutdown. The RUN/SS pin is internally held
low until the voltage applied to the UVADJ pin exceeds
the 1.2V threshold.
Short-Circuit Detection
The RUN/SS capacitor is used initially to turn on and limit
the inrush current from the input power source. Once the
controllers have been given time, as determined by the
capacitor on the RUN/SS pin, to charge up the output
capacitors and provide full load current, the RUN/SS
capacitor is then used as a short-circuit timeout circuit.
If the output voltage falls to less than 70% of its nominal
output voltage, the RUN/SS capacitor begins discharg-
ing, assuming that the output is in a severe overcurrent
and/or short-circuit condition. If the condition lasts for
a long enough period, as determined by the size of the
RUN/SScapacitor,thecontrollerwillbeshutdownuntilthe
RUN/SS pin voltage is recycled. This built-in latchoff can
be overridden by providing >5A at a compliance of 3.8V
to the RUN/SS pin. This additional current shortens the
soft-start period but prevents net discharge of the RUN/SS
capacitor during a severe overcurrent and/or short-circuit
condition. Foldback current limiting is activated when the
outputvoltagefallsbelow70%ofitsnominallevelwhether
or not the short-circuit latchoff circuit is enabled. Foldback
current limit can be overridden by clamping the EAIN pin
such that the voltage is held above the (70%)(0.6V) or
0.42V level even when the actual output voltage is low. Up
to 100A of input current can safely be accommodated
by the RUN/SS pin.
operaTion (Refer to Functional Diagram)
相關PDF資料
PDF描述
LTC3772BETS8#PBF 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8
LTC3772ETS8#PBF 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8
LTC3783IDHD 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3783IFE#TR 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3783IDHD#TR 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
LTC3731IG 制造商:Linear Technology 功能描述:LDO Cntrlr SYNC BUCK REG 0.6V to 6V 36-Pin SSOP
LTC3731IG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3731IG#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3731IUH 制造商:Linear Technology 功能描述:LDO Cntrlr SYNC BUCK REG 0.6V to 6V 32-Pin QFN EP
LTC3731IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX