- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3588IDD-1#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO10 PDF資料下載
參數資料
| 型號： | LTC3588IDD-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO10 |
| 封裝： | 3 X 3 MM, LEAD FREE, PLASTIC, MO-229WEED-2, DFN-10 |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 391K |
| 代理商： | LTC3588IDD-1#TRPBF |
LTC3588-1
12
35881fa
APPLICATIONS INFORMATION
PGOOD Signal
The PGOOD signal can be used to enable a sleeping
microprocessor or other circuitry when VOUT reaches
regulation, as shown in Figure 5. Typically VIN will be
somewhere between the UVLO thresholds at this time and
a load could only be supported by the output capacitor.
Alternatively, waiting a period of time after PGOOD goes
high would let the input capacitor accumulate more energy
allowing load current to be maintained longer as the buck
efciently transfers that energy to the output. While active,
a microprocessor may draw a small load when operating
sensors, and then draw a large load to transmit data.
Figure 5 shows the LTC3588-1 responding smoothly to
such a load step.
Input and Output Capacitor Selection
The input and output capacitors should be selected
based on the energy needs and load requirements of the
application. In every case the VIN capacitor should be
rated to withstand the highest voltage ever present at VIN.
For 100mA or smaller loads, storing energy at the input
takes advantage of the high voltage input since the buck
can deliver 100mA average load current efciently to the
output. The input capacitor should then be sized to store
enough energy to provide output power for the length of
time required. This may involve using a large capacitor,
letting VIN charge to a high voltage, or both. Enough energy
should be stored on the input so that the buck does not
reach the UVLO falling threshold which would halt energy
transfer to the output. In general:
P
LOADtLOAD =
1
2
ηC
IN VIN
2 V
UVLOFALLING
2
()
V
UVLOFALLING ≤ VIN ≤ VSHUNT
The above equation can be used to size the input capaci-
tor to meet the power requirements of the output for the
desired duration. Here
η is the average efciency of the
buck converter over the input range and VIN is the input
voltage when the buck begins to switch. This equation
may overestimate the input capacitor necessary since load
current can deplete the output capacitor all the way to the
lower PGOOD threshold. It also assumes that the input
source charging has a negligible effect during this time.
The duration for which the regulator sleeps depends on
the load current and the size of the output capacitor. The
sleep time decreases as the load current increases and/or
as the output capacitor decreases. The DC sleep hysteresis
window is ±12mV around the programmed output volt-
age. Ideally this means that the sleep time is determined
by the following equation:
t
SLEEP = COUT
24mV
I
LOAD
35881 F05a
35881 F05b
PZ1
VIN
CAP
VIN2
D1
D0
PZ2
PGOOD
SW
VOUT
LTC3588-1
MICROPROCESSOR
GND
1μF
6V
4.7μF
6V
10μF
25V
47μF
6V
10μH
3.3V
EN
CORE
GND
TX
250μs/DIV
VIN = 5V
L = 10μH, COUT = 47μF
LOAD STEP BETWEEN 5mA and 55mA
OUTPUT
VOLTAGE
20mV/DIV
AC-COUPLED
LOAD
CURRENT
25mA/DIV
5mA
MIDE V21BL
Figure 5. 3.3V Piezoelectric Energy Harvester Powering a Microprocessor
with a Wireless Transmitter and 50mA Load Step Response
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3588EDD-1#TRPBF | SWITCHING REGULATOR, PDSO10 |
| LTC3608IWKG#TRPBF | 8 A SWITCHING REGULATOR, PQCC52 |
| LTC3610IWP#TR | SWITCHING REGULATOR, PQCC64 |
| LTC3610IWP | SWITCHING REGULATOR, PQCC64 |
| LTC3610IWP#TRPBF | SWITCHING REGULATOR, PQCC64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3588IDD-2#PBF | 功能描述:IC ENERGY HARVESTING PSU 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3588IDD-2#TRPBF | 功能描述:IC ENERGY HARVESTING PSU 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3588IMSE-1#PBF | 功能描述:IC ENERGY HARVESTING PSU 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:熱電冷卻器 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.173"，4.40mm 寬）裸露焊盤 供應商設備封裝:28-TSSOP 裸露焊盤 包裝:管件 產品目錄頁面:1410 (CN2011-ZH PDF) |
| LTC3588IMSE-1#PBF | 制造商:Linear Technology 功能描述:PIEZOELECTRIC ENERGY HARVESTING POWER SU |
| LTC3588IMSE-1#TRPBF | 功能描述:IC ENERGY HARVESTING PSU 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
發布緊急采購，3分鐘左右您將得到回復。