- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3533EDE#TR (LINEAR TECHNOLOGY CORP) 7 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO14 PDF資料下載
參數資料
| 型號： | LTC3533EDE#TR |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 7 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | 4 X 3 MM, 0.75 MM HEIGHT, PLASTIC, MO-229WGED-3, DFN-14 |
| 文件頁數： | 15/16頁 |
| 文件大小： | 313K |
| 代理商： | LTC3533EDE#TR |
LTC3533
8
3533f
OPERATION
Error Amplier
The error amplier is a voltage mode amplier. The loop
compensation components are congured around the
amplier (from FB to VC) to obtain stability of the converter.
For improved bandwidth, an additional RC feed-forward
network can be placed across the upper feedback divider
resistor. The voltage on the RUN/SS pin clamps the error
amplier output, VC, to provide a soft-start function.
Supply Current Limits
There are two different supply current limit circuits in the
LTC3533, working consecutively, each having internally
xed thresholds which vary inversely with VIN.
The rst circuit is a current limit amplier, sourcing cur-
rent into FB to drop the output voltage, should the peak
input current exceed 4.5A typical. This method provides a
closed loop means of clamping the input current. During
conditions where VOUT is near ground, such as during a
short circuit or startup, this threshold is cut to 750mA,
providing a fold-back feature. For this current limit feature
to be most effective, the Thevenin resistance from FB to
ground should be greater than 100k.
Should the peak input current exceed 7A typical, the second
circuit, a high speed peak current limit comparator, shuts
off PMOS switch A. The delay to output of this comparator
is typically 50ns.
Reverse Current Limit
During xed frequency operation, the LTC3533 operates in
forced continuous conduction mode. The reverse current
limit comparator monitors the inductor current from the
output through switch D. Should this negative inductor
current exceed 500mA typical, the LTC3533 shuts off
switch D.
Four-Switch Control
Figure 1 shows a simplied diagram of how the four in-
ternal switches are connected to the inductor, VIN, VOUT
and GND.Figure 2 shows the regions of operation for the
LTC3533 as a function of the control voltage, VC.
Dependent on VC’s magnitude, the LTC3533 will operate
in either buck, buck/boost or boost mode. The four power
switches are properly phased so the transfer between op-
erating modes is continuous, smooth and transparent to
the user. When VIN approaches VOUT the buck/boost region
is entered, where the conduction time of the four switch
region is typically 150ns. Referring to Figures 1 and 2, the
various regions of operation will now be described.
Buck Region (VIN > VOUT)
Switch D is always on and switch C is always off during
this mode. When the control voltage, VC, is above volt-
age V1, switch A begins to switch. During the off time of
switch A, synchronous switch B turns on for the remainder
of the period. Switches A and B will alternate similar to a
typical synchronous buck regulator. As the control volt-
age increases, the duty cycle of switch A increases until
the maximum duty cycle of the converter in buck mode
reaches DMAX_BUCK, given by:
DMAX_BUCK = 100 – D4SW %
where D4SW = duty cycle % of the four switch range.
3
SW1
7
SW2
PMOS A
NMOS B
11
PVIN
PMOS D
NMOS C
3533 F01
9
PVOUT
L1
85%
DMAX
BOOST
DMIN
BOOST
DMAX
BUCK
DUTY
CYCLE
0%
V4 (
≈1.5V)
V3 (
≈1.15V)
BOOST REGION
BUCK REGION
BUCK/BOOST REGION
V2 (
≈1V)
V1 (
≈0.7V)
3533 F02
A ON, B OFF
PWM CD SWITCHES
D ON, C OFF
PWM AB SWITCHES
FOUR SWITCH PWM
CONTROL
VOLTAGE, VC
Figure 1. Simplied Diagram of Output Switches
Figure 2. Switch Control vs Control Voltage, VC
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3533EDE | 7 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PDSO14 |
| LTC3535EDD#PBF | SWITCHING REGULATOR, PDSO12 |
| LTC3538EDCB#PBF | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB#TR | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3534 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:40V, 2A Synchronous Buck-Boost DC/DC |
| LTC3534EDHC#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 16DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3534EDHC#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 16DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3534EGN#PBF | 功能描述:IC REG BUCK BST SYNC 0.5A 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3534EGN#TRPBF | 功能描述:IC REG BUCK BST SYNC 0.5A 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。