- 您現在的位置：買賣IC網 > PDF目錄385506 > LTC2428 (Linear Technology Corporation) 16-Bit 2.5-V to 3.3-V/3.3-V To 5-V Level Shifting Transceiver With 3-State Outputs 48-TSSOP -40 to 85 PDF資料下載
參數資料
| 型號： | LTC2428 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 16-Bit 2.5-V to 3.3-V/3.3-V To 5-V Level Shifting Transceiver With 3-State Outputs 48-TSSOP -40 to 85 |
| 中文描述： | 4-/8-Channel 20位ADC的無延遲uPower |
| 文件頁數： | 19/28頁 |
| 文件大?。?/td> | 317K |
| 代理商： | LTC2428 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
19
LTC2424/LTC2428
APPLICATIO
S I
FOR
ATIO
U
W
U
U
Figure 16. Internal Serial Clock Timing Diagram
SCKCLK
SDO
D
IN
CSADC
CSMUX
t
EOCtest
MSB
LSB
EXR
SIG
BIT0
BIT4 BIT3 BIT2 BIT1
BIT19BIT18
BIT20
BIT21
BIT22
BIT23
24248 F16
TEST EOC
DON’T CARE
DON’T CARE
EN
D2
D1
D0
Hi-Z
Hi-Z
Hi-Z
TEST EOC
TEST EOC
V
CC
CS
10k
F
O
FS
SET
CSMUX
CSADC
SCK
CLK
MUXOUT
ADCIN
GND
D
IN
SDO
ZS
SET
0.1V
TO V
CC
–0.12V
REF
TO 1.12V
REF
CH0
TO CH7
2.7V TO 5.5V
LTC2424/LTC2428
= 50Hz REJECTION
= EXTERNAL OSCILLATOR
= 60Hz REJECTION
V
CC
When testing EOC, if the conversion is complete (EOC = 0),
the device will exit the sleep state and enter the data output
state if CSADC remains LOW. In order to prevent the
device from exiting the low power sleep state, CSADC
must be pulled HIGH before the first rising edge of SCK. In
the internal SCK timing mode, SCK goes HIGH and the
device begins outputting data at time t
EOCtest
after the
falling edge of CSADC (if EOC = 0) or t
EOCtest
after EOC
goes LOW (if CSADC is LOW during the falling edge of
EOC). The value of t
EOCtest
is 23
μ
s if the device is using its
internal oscillator (F
0
= logic LOW or HIGH). If F
O
is driven
by an external oscillator of frequency f
EOSC
, then t
EOCtest
is
3.6/f
EOSC
. If CSADC is pulled HIGH before time t
EOCtest
, the
device remains in the sleep state. The conversion result is
held in the internal static shift register.
If CSADC remains LOW longer than t
EOCtest
, the first rising
edge of SCK will occur and the conversion result is serially
shifted out of the SDO pin. The data output cycle begins on
this first rising edge of SCK and concludes after the 24th
rising edge. Data is shifted out the SDO pin on each falling
edge of SCK. The internally generated serial clock is output
to the SCK pin. This signal may be used to shift the
conversion result into external circuitry. EOC can be
latched on the first rising edge of SCK and the last bit of the
conversion result on the 24th rising edge of SCK. After the
24th rising edge, SDO goes HIGH (EOC = 1), SCK stays
HIGH, and a new conversion starts.
While operating in the internal serial clock mode, the SCK
output of the ADC may be used as the multiplexer clock
(CLK). D
IN
is latched into the multiplexer on the rising
edge of CLK. As shown in Figure 16, the multiplexer
channel is selected by serial shifting a 4-bit word into the
D
IN
pin on the rising edge of CLK. The first bit is an enable
bit which must be HIGH in order to program a channel. The
next three bits determine which channel is selected, see
Table 3. On the rising edge of CSADC (falling edge of
CSMUX), the new channel is selected and will be valid for
the next conversion. If D
IN
is held LOW during the data
output state, the previous channel selection remains valid.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2428C | 16-Bit 2.5-V to 3.3-V/3.3-V To 5-V Level Shifting Transceiver With 3-State Outputs 56-BGA MICROSTAR JUNIOR -40 to 85 |
| LTC2428CG | 4-/8-Channel 20-Bit uPower No Latency ADCs |
| LTC2428I | 4-/8-Channel 20-Bit uPower No Latency ADCs |
| LTC2428IG | 4-/8-Channel 20-Bit uPower No Latency ADCs |
| LTC2442 | 24-Bit High Speed 4-Channel Delta-Sigma ADC with Integrated Amplifi er |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2428CG | 功能描述:IC ADC 20BIT 8CH MICROPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2428CG#PBF | 功能描述:IC ADC 20BIT 8CH MICROPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2428CG#TR | 功能描述:IC ADC 20BIT 8CH MICROPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2428CG#TRPBF | 功能描述:IC ADC 20BIT 8CH MICROPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2428CGPBF | 制造商:Linear Technology 功能描述:ADC,LTC2428C 20bit D-S 8 ch SPI SSOP |
發布緊急采購，3分鐘左右您將得到回復。