REF
參數資料
型號: LTC2413IGN
廠商: Linear Technology
文件頁數: 33/44頁
文件大小: 0K
描述: IC A/D CONV 24BIT MICRPWR 16SSOP
標準包裝: 100
位數: 24
采樣率(每秒): 6.8
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 2
功率耗散(最大): 1mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-SSOP(0.154",3.90mm 寬)
供應商設備封裝: 16-SSOP
包裝: 管件
輸入數目和類型: 1 個差分,雙極
LTC2413
39
sn2413 2413fs
APPLICATIO S I FOR ATIO
WU
U
Figure 45. Bridge Amplification Using a Single Amplifier
0.1
F
5V
REF+
REF
IN+
IN
GND
VCC
3
2
4
6
7
4
350
BRIDGE
5
6
2413 F45
1, 7, 8, 9,
10, 15, 16
2
LTC2413
+
LTC1050S8
5V
0.1
V
R2
46.4k
20k
175
1
F
10
F
R1
4.99k
()
AV = 9.95 =
R1 + R2
R1 + 175
+
1
F
+
be a source of error. The fact that input offset voltage has
relatively little effect on overall error may lead one to use
low performance amplifiers for this application. Note that
the gain of a device such as an LF156, (25V/mV over
temperature) will produce a worst-case error of –180ppm
at a noise gain of 3, such as would be encountered in an
inverting gain of 2, to produce –10V from a 5V reference.
The error associated with the 10V excitation would be
–80ppm. Hence, overall reference error could be as high
as 130ppm, the average of the two.
Figure 50 shows a similar scheme to provide excitation
using resistor arrays to produce precise gain. The circuit
is configured to provide 10V and –5V excitation to the
bridge, producing a common mode voltage at the input to
the LTC2413 of 2.5V, maximizing the AC input range for
applications where induced 60Hz could reach amplitudes
up to 2VRMS.
The circuits in Figures 48 and 50 could be used where
multiple bridge circuits are involved and bridge output can
be multiplexed onto a single LTC2413, via an inexpensive
multiplexer such as the 74HC4052.
Figure 49 shows the use of an LTC2413 with a differential
multiplexer. This is an inexpensive multiplexer that will
contribute some error due to leakage if used directly with
the output from the bridge, or if resistors are inserted as
a protection mechanism from overvoltage. Although the
bridge output may be within the input range of the A/D and
multiplexer in normal operation, some thought should be
given to fault conditions that could result in full excitation
voltage at the inputs to the multiplexer or ADC. The use of
amplification prior to the multiplexer will largely eliminate
errors associated with channel leakage developing error
voltages in the source impedance.
相關PDF資料
PDF描述
MS27467T15F19PA CONN PLUG 19POS STRAIGHT W/PINS
VI-J3B-MX-S CONVERTER MOD DC/DC 95V 75W
VI-J33-MX-S CONVERTER MOD DC/DC 24V 75W
MS27473T20B41PA CONN PLUG 41POS STRAIGHT W/PINS
MS27474E12F98S CONN RCPT 10POS JAM NUT W/SCKT
相關代理商/技術參數
參數描述
LTC2413IGN#PBF 功能描述:IC A/D CONV 24BIT MICRPWR 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2413IGN#PBF 制造商:Linear Technology 功能描述:A/D Converter (A-D) IC
LTC2413IGN#TR 功能描述:IC ADC 24BIT 50/60HZ MPWR 16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2413IGN#TRPBF 功能描述:IC A/D CONV 24BIT MICRPWR 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2414CGN 功能描述:IC ADC 8CH 24BIT DIFFINPUT28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極