- 您現在的位置：買賣IC網 > PDF目錄10356 > LTC2362CTS8#TRPBF (Linear Technology)IC ADC 12BIT 500KSPS TSOT23-8 PDF資料下載
參數資料
| 型號： | LTC2362CTS8#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT 500KSPS TSOT23-8 |
| 標準包裝： | 2,500 |
| 位數： | 12 |
| 采樣率（每秒）： | 500k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 7.2mW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 薄型，TSOT-23-8 |
| 供應商設備封裝： | TSOT-23-8 |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，單極 |
| 配用： | DC1190A-C-ND - BOARD SAR ADC LTC2362 |
LTC2360/LTC2361/LTC2362
18
236012fa
APPLICATIONS INFORMATION
BOARD LAYOUT AND BYPASSING
Wire wrap boards are not recommended for high resolution
and/or high speed A/D converters. To obtain the best per-
formance from the LTC2360/LTC2361/LTC2362, a printed
circuit board with ground plane is required. Layout for the
printed circuit board should ensure that digital and analog
signal lines are separated as much as possible. In particular,
care should be taken not to run any digital track alongside
an analog signal track or underneath the ADC. The analog
input should be screened by the ground plane.
High quality tantalum and ceramic bypass capacitors
should be used at the VDD pin as shown in the Block
Diagram on the rst page of this data sheet. For optimum
performance, a 2.2μF surface mount AVX capacitor with
a 0.1μF ceramic is recommended for the VDD and VREF
pins. Alternatively, 2.2μF ceramic chip capacitors such as
Murata GRM235Y5V106Z016 may be used. The capacitors
must be located as close to the pins as possible. The traces
connecting the pins and the bypass capacitors must be
kept short and should be made as wide as possible.
Figure 16 shows the recommended system ground con-
nections. All analog circuitry grounds should be terminated
at the LTC2360/LTC2361/LTC2362. The ground return
from the LTC2360/LTC2361/LTC2362 to the power supply
should be low impedance for noise free operation. Digital
circuitry grounds must be connected to the digital supply
common.
In applications where the ADC data outputs and control sig-
nals are connected to a continuously active microprocessor
bus, it is possible to get errors in the conversion results.
These errors are due to feedthrough from the micropro-
cessor to the successive approximation comparator. The
problem can be eliminated by forcing the microprocessor
into a wait state during conversion or by using three-state
buffers to isolate the ADC data bus.
Figure 16. Power Supply Ground Practice
236012 F16
GND
AIN
VDD
CAIN
CONV
SDO
SCK
CVDD
PIN 1
VIAS TO GROUND PLANE
+
2.2μF
相關PDF資料 |
PDF描述 |
|---|---|
| MS27472T12B35SD | CONN RCPT 22POS WALL MNT W/SCKT |
| MS27473E14A18S | CONN PLUG 18POS STRAIGHT W/SCKT |
| AAA6FPZ | CONN PLUG FEMAL 6PIN PLAS SILVER |
| MS27473P12A98P | CONN PLUG 10POS STRAIGHT W/PINS |
| MS27473E8F6PA | CONN PLUG 6POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2362HS6#TRMPBF | 功能描述:IC ADC 12BIT 500KSPS TSOT23-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC2362HS6#TRPBF | 功能描述:IC ADC 12BIT 500KSPS TSOT23-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2362HTS8#TRMPBF | 功能描述:IC ADC 12BIT 500KSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2362HTS8#TRPBF | 功能描述:IC ADC 12BIT 500KSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2362IS6#TRMPBF | 功能描述:IC ADC 12BIT 500KSPS TSOT23-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。