參數資料
型號: LTC2207CUK-14
廠商: LINEAR TECHNOLOGY CORP
元件分類: ADC
英文描述: 14-Bit, 105Msps/80Msps ADCs
中文描述: 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48
封裝: 7 X 7 MM, PLASTIC, MO-220WKKD-2, QFN-48
文件頁數: 18/32頁
文件大?。?/td> 1298K
代理商: LTC2207CUK-14
LTC2207-14/LTC2206-14
18
220714614fa
INPUT DRIVE CIRCUITS
Input Filtering
A first order RC lowpass filter at the input of the ADC can
serve two functions: limit the noise from input circuitry and
provide isolation from ADC S/H switching. The LTC2207-
14/LTC2206-14 have a very broadband S/H circuit, DC to
700MHz; it can be used in a wide range of applications;
therefore, it is not possible to provide a single recom-
mended RC filter.
Figures 3, 4a and 4b show three examples of input RC
filtering at three ranges of input frequencies. In general
it is desirable to make the capacitors as large as can be
tolerated–this will help suppress random noise as well
as noise coupled from the digital circuitry. The LTC2207-
14/LTC2206-14 do not require any input filter to achieve
data sheet specifications; however, no filtering will put
more stringent noise requirements on the input drive
circuitry.
Transformer Coupled Circuits
Figure 3 shows the LTC2207-14/LTC2206-14 being driven
by an RF transformer with a center-tapped secondary. The
secondary center tap is DC biased with V
CM
, setting the
ADC input signal at its optimum DC level. Figure 3 shows
a 1:1 turns ratio transformer. Other turns ratios can be
used; however, as the turns ratio increases so does the
impedance seen by the ADC. Source impedance greater
than 50
Ω
can reduce the input bandwidth and increase
high frequency distortion. A disadvantage of using a
transformer is the loss of low frequency response. Most
small RF transformers have poor performance at frequen-
cies below 1MHz.
Center-tapped transformers provide a convenient means
of DC biasing the secondary; however, they often show
poor balance at high input frequencies, resulting in large
2nd order harmonics.
Figure 4a shows transformer coupling using a transmis-
sion line balun transformer. This type of transformer has
much better high frequency response and balance than
flux coupled center tap transformers. Coupling capacitors
are added at the ground and input primary terminals to
allow the secondary terminals to be biased at 1.25V. Figure
4b shows the same circuit with components suitable for
higher input frequencies.
APPLICATIONS INFORMATION
相關PDF資料
PDF描述
LTC2207IUK-14 14-Bit, 105Msps/80Msps ADCs
LTC2207UK-14 14-Bit, 105Msps/80Msps ADCs
LTC2206 16-Bit, 105Msps/80Msps ADCs
LTC2206CUK 16-Bit, 105Msps/80Msps ADCs
LTC2206IUK 16-Bit, 105Msps/80Msps ADCs
相關代理商/技術參數
參數描述
LTC2207CUK-14#PBF 功能描述:IC ADC 14BIT 105MSPS 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
LTC2207CUK-14#TRPBF 功能描述:IC ADC 14BIT 105MSPS 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
LTC2207IUK 制造商:Linear Technology 功能描述:ADC Single Pipelined 105Msps 16-bit Parallel 48-Pin QFN EP
LTC2207IUK#PBF 制造商:Linear Technology 功能描述:ADC Single Pipelined 105Msps 16-bit Parallel 48-Pin QFN EP 制造商:Linear Technology 功能描述:IC ADC 16-BIT 105MSPS 48-QFN 制造商:Linear Technology 功能描述:ADC 16BIT 105MSPS 48QFN 制造商:Linear Technology 功能描述:IC, ADC, 16BIT, 105MSPS, QFN-48; Resolution (Bits):16bit; Sampling Rate:105MSPS; Supply Voltage Type:Single; Supply Voltage Min:3.135V; Supply Voltage Max:3.465V; Supply Current:273mA; Digital IC Case Style:QFN; No. of Pins:48 ;RoHS Compliant: Yes
LTC2207IUK#TRPBF 制造商:Linear Technology 功能描述:ADC Single Pipelined 105Msps 16-bit Parallel 48-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC ADC 16BIT 105MSPS 48-QFN