參數資料
型號: LT3503EDCB
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 1 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO6
封裝: 2 X 3 MM, PLASTIC, MO-229, DFN-6
文件頁數: 9/20頁
文件大?。?/td> 423K
代理商: LT3503EDCB
17
LT3503
3503f
APPLICATIO S I FOR ATIO
WU
U
local, unbroken ground plane below these components,
and tie this ground plane to system ground at one location,
ideally at the ground terminal of the output capacitor C1.
The SW and BOOST nodes should be as small as possible.
Finally, keep the FB node small so that the ground pin and
ground traces will shield it from the SW and BOOST nodes.
Include vias near the exposed GND pad of the LT3503 to
help remove heat from the LT3503 to the ground plane.
High Temperature Considerations
The die temperature of the LT3503 must be lower than the
maximum junction of 125
°C. This is generally not a
concern unless the ambient temperature is above 85
°C.
For higher temperatures, care should be taken in the layout
of the circuit to ensure good heat sinking of the LT3503.
The maximum load current should be derated as the
ambient temperature approaches 125
°C. The die tem-
perature is calculated by multiplying the LT3503 power
dissipation by the thermal resistance from junction to
ambient. Power dissipation within the LT3503 can be
estimated by calculating the total power loss from an
efficiency measurement and subtracting the catch diode
loss. The resulting temperature rise at full load is nearly
independent of input voltage. Thermal resistance depends
on the layout of the circuit board, but 64
°C/W is typical for
the (2mm
× 3mm) DFN (DCB) package.
Outputs Greater Than 6V
For outputs greater than 6V, add a resistor of 1k to 2.5k
across the inductor to damp the discontinuous ringing of
the SW node, preventing unintended SW current.
Other Linear Technology Publications
Application notes AN19, AN35 and AN44 contain more
detailed descriptions and design information for Buck
regulators and other switching regulators. The LT1376
data sheet has a more extensive discussion of output
ripple, loop compensation and stability testing. Design
Note DN100 shows how to generate a bipolar output
supply using a Buck regulator.
Figure 12. A Good PCB Layout Ensures Proper, Low EMI Operation
C2
D1
C1
SYSTEM
GROUND
: VIAS TO LOCAL GROUND PLANE
: OUTLINE OF LOCAL GROUND PLANE
VOUT
3503 F12
VIN
SHUTDOWN
相關PDF資料
PDF描述
LT3585EDDB-2 0.95 A BATTERY CHARGE CONTROLLER, PDSO10
LT3585EDDB-0#TRMPDF 1.3 A BATTERY CHARGE CONTROLLER, PDSO10
LT3585EDDB-3 1.85 A BATTERY CHARGE CONTROLLER, PDSO10
LT3587EUD#PBF SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20
LT3587EUD#TRPBF SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20
相關代理商/技術參數
參數描述
LT3503EDCB#PBF 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 20V 6-Pin DFN EP 制造商:Linear Technology 功能描述:REG SWITCHING STEP DOWN 1A 2.2MHZ 制造商:Linear Technology 功能描述:REG, SWITCHING, STEP DOWN, 1A 2.2MHZ 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape 1A, 2.2MHz Buck Regulator ;RoHS Compliant: Yes
LT3503EDCB#TR 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 20V 6-Pin DFN EP T/R
LT3503EDCB#TRMPBF 功能描述:IC REG BUCK ADJ 1A 6DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LT3503EDCB#TRPBF 功能描述:IC REG BUCK ADJ 1A 6DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓(升壓) 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式,混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LT3503EDCBTRMPBF 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 3.6-20V DFN6EP