- 您現在的位置：買賣IC網 > PDF目錄98002 > LT3503EDCB (LINEAR TECHNOLOGY CORP) 1 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO6 PDF資料下載
參數資料
| 型號： | LT3503EDCB |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封裝： | 2 X 3 MM, PLASTIC, MO-229, DFN-6 |
| 文件頁數： | 3/20頁 |
| 文件大?。?/td> | 423K |
| 代理商： | LT3503EDCB |
11
LT3503
3503f
APPLICATIO S I FOR ATIO
WU
U
Ceramic capacitors have very low equivalent series resis-
tance (ESR) and provide the best ripple performance. A
good value is:
COUT = 24/VOUT
where COUT is in F. Use X5R or X7R types and keep in
mind that a ceramic capacitor biased with VOUT will have
less than its nominal capacitance. This choice will provide
low output ripple and good transient response. Transient
performance can be improved with a high value capacitor,
but a phase lead capacitor across the feedback resistor R1
may be required to get the full benefit (see the Compen-
sation section). Using a small output capacitor results in
an increased loop crossover frequency and increased
sensitivity to noise. A 22pF capacitor connected between
VOUT and the FB pin is required to filter noise at the FB pin
and ensure stability.
High performance electrolytic capacitors can be used for
the output capacitor. Low ESR is important, so choose
one that is intended for use in switching regulators. The
ESR should be specified by the supplier and should be
0.1
or less. Such a capacitor will be larger than a
ceramic capacitor and will have a larger capacitance, be-
cause the capacitor must be large to achieve low ESR.
Table 2 lists several capacitor vendors.
Figure 5 shows the transient response of the LT3503 with
a few output capacitor choices. The output is 3.3V. The
load current is stepped from 0.5A to 1.1A and back to 0.5A,
and the oscilloscope traces show the output voltage. The
upper photo shows the recommended value. The second
photo shows the improved response (less voltage drop)
resulting from a phase lead capacitor. The last photo
shows the response to a high performance electrolytic
capacitor. Transient performance is improved due to the
large output capacitance.
BOOST Pin Considerations
Capacitor C3 and diode D2 are used to generate a boost
voltage that is higher than the input voltage. In most cases
a 0.1
F capacitor and fast switching diode (such as the
1N4148 or 1N914) will work well. Figure 6 shows two
ways to arrange the boost circuit. The BOOST pin must be
at least 2.3V above the SW pin for best efficiency. For
outputs of 3.3V and above, the standard circuit (Figure 6a)
is best. For outputs between 3V and 3.3V, use a 0.22
F
capacitor. For outputs between 2.5V and 3V, use a 0.47
F
capacitor and a small Schottky diode (such as the BAT-54).
For lower output voltages tie a Schottky diode to the input
(Figure 6b). The circuit in Figure 6a is more efficient
because the BOOST pin current comes from a lower
voltage source. You must also be sure that the maximum
voltage rating of the BOOST pin is not exceeded.
Table 2. Capacitor Vendors
Vendor
Phone
URL
Part Series
Comments
Panasonic
(714) 373-7366
www.panasonic.com
Ceramic,
Polymer,
EEF Series
Tantalum
Kemet
(864) 963-6300
www.kemet.com
Ceramic,
Tantalum
T494, T495
Sanyo
(408) 749-9714
www.sanyovideo.com
Ceramic,
Polymer,
POSCAP
Tantalum
Murata
(404) 436-1300
www.murata.com
Ceramic
AVX
www.avxcorp.com
Ceramic,
Tantalum
TPS Series
Taiyo Yuden
(864) 963-6300
www.taiyo-yuden.com
Ceramic
相關PDF資料 |
PDF描述 |
|---|---|
| LT3585EDDB-2 | 0.95 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LT3585EDDB-0#TRMPDF | 1.3 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LT3585EDDB-3 | 1.85 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LT3587EUD#PBF | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 |
| LT3587EUD#TRPBF | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3503EDCB#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 20V 6-Pin DFN EP 制造商:Linear Technology 功能描述:REG SWITCHING STEP DOWN 1A 2.2MHZ 制造商:Linear Technology 功能描述:REG, SWITCHING, STEP DOWN, 1A 2.2MHZ 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape 1A, 2.2MHz Buck Regulator ;RoHS Compliant: Yes |
| LT3503EDCB#TR | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 20V 6-Pin DFN EP T/R |
| LT3503EDCB#TRMPBF | 功能描述:IC REG BUCK ADJ 1A 6DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT3503EDCB#TRPBF | 功能描述:IC REG BUCK ADJ 1A 6DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT3503EDCBTRMPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 3.6-20V DFN6EP |
發布緊急采購，3分鐘左右您將得到回復。