- 您現在的位置：買賣IC網 > PDF目錄385501 > LT1715 (Linear Technology Corporation) 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies PDF資料下載
參數資料
| 型號： | LT1715 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies |
| 中文描述： | 4ns的，150MHz的雙通道比較器與獨立的輸入/輸出設備 |
| 文件頁數： | 14/16頁 |
| 文件大?。?/td> | 239K |
| 代理商： | LT1715 |
14
LT1715
APPLICATIOU
the frequency-dependent increase in power consumption.
The frequency dependence of the supply current is shown
in the Typical Performance Characteristics.
W
U
U
Speed Limits
The LT1715 comparator is intended for high speed appli-
cations, where it is important to understand a few limita-
tions. These limitations can roughly be divided into three
categories: input speed limits, output speed limits, and
internal speed limits.
There are no significant input speed limits except the
shunt capacitance of the input nodes. If the 2pF typical
input nodes are driven, the LT1715 will respond.
The output speed is constrained by three mechanisms, the
first of which is the slew currents available from the output
transistors. To maintain low power quiescent operation,
the LT1715 output transistors are sized to deliver 35mA to
60mA typical slew currents. This is sufficient to drive small
capacitive loads and logic gate inputs at extremely high
speeds. But the slew rate will slow dramatically with heavy
capacitive loads. Because the propagation delay (t
PD
)
definition ends at the time the output voltage is halfway
between the supplies, the fixed slew current makes the
LT1715 faster at 3V than 5V with large capacitive loads and
sufficient input overdrive.
Another manifestation of this output speed limit is skew,
the difference between t
PD+
and t
PD–
. The slew currents of
the LT1715 vary with the process variations of the PNP
and NPN transistors, for rising edges and falling edges
respectively. The typical 0.5ns skew can have either polar-
ity, rising edge or falling edge faster. Again, the skew will
increase dramatically with heavy capacitive loads.
A final limit to output speed is the turn-on and turn-off time
of the output devices. Each device has substantial base
charge that requires one nanosecond or more of active
charging or discharging by the bias current of the Darlington
driver stage. When toggle rates are high enough that insuf-
ficient time is allowed for this turn-on or turn-off, glitches
may occur leading to dropout or runt pulses. Furthermore,
power consumption may increase nonlinearly if devices
are not turned off before the opposing cycle. However,
once the toggle frequency increases or decreases, the part
will easily leave this undesired operating mode no worse
for the wear provided there is adequate heat sinking to
prevent thermal overload. At frequencies well beyond the
maximum toggle rate, the part will toggle with limited output
swing and well controlled power consumption.
The internal speed limits manifest themselves as disper-
sion. All comparators have some degree of dispersion,
defined as a change in propagation delay versus input
overdrive. The propagation delay of the LT1715 will vary
with overdrive, from a typical of 4ns at 20mV overdrive to
6ns at 5mV overdrive (typical). The LT1715’s primary
source of dispersion is the hysteresis stage. As a change
of polarity arrives at the gain stage, the positive feedback
of the hysteresis stage subtracts from the overdrive avail-
able. Only when enough time has elapsed for a signal to
propagate forward through the gain stage, backwards
through the hysteresis path and forward through the gain
stage again, will the output stage receive the same level of
overdrive that it would have received in the absence of
hysteresis.
The LT1715 is several hundred picoseconds faster when
V
EE
= –5V, relative to single supply operation. This is due
to the internal speed limit; the gain stage operates between
V
EE
and +V
S
, and it is faster with higher reverse voltage
bias due to reduced silicon junction capacitances.
In many applications, as shown in the following examples,
there is plenty of input overdrive. Even in applications
providing low levels of overdrive, the LT1715 is fast
enough that the absolute dispersion of 2ns (= 6 – 4) is
often small enough to ignore.
The gain and hysteresis stage of the LT1715 is simple,
short and high speed to help prevent parasitic oscilla-
tions while adding minimum dispersion. This internal
“self-latch” can be usefully exploited in many applica-
tions because it occurs early in the signal chain, in a low
power, fully differential stage. It is therefore highly im-
mune to disturbances from other parts of the circuit,
such as the output, or on the supply lines. Once a high
speed signal trips the hysteresis, the output will respond,
after some propagation delay, without regard to these
external influences that can cause trouble in nonhysteretic
comparators.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1715CMS | 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies |
| LT1715IMS | 4ns, 150MHz Dual Comparator with Independent Input/Output Supplies |
| LT1761 | 100mA, Low Noise, LDO Micropower Regulators in SOT-23(可調輸出,100mA,低噪聲，低壓差穩壓器（SOT-23封裝）) |
| LT1761-1.8 | 100mA, Low Noise, LDO Micropower Regulators in SOT-23(1.8V輸出，100mA,低噪聲，低壓差穩壓器（SOT-23封裝）) |
| LT1761-2 | 100mA, Low Noise, LDO Micropower Regulators in SOT-23(2V輸出，100mA,低噪聲，低壓差穩壓器（SOT-23封裝）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1715_1 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:4ns, 150MHz Dual Comparator with Independent Input/Output Supplies |
| LT1715CMS | 功能描述:IC COMPARATOR 150MHZ DUAL 10MSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS，推挽式，滿擺幅，TTL 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 電壓 - 輸入偏移（最小值）:5mV @ 5.5V 電流 - 輸入偏壓（最小值）:1pA @ 5.5V 電流 - 輸出（標準）:- 電流 - 靜態（最大值）:24µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA，CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586 |
| LT1715CMS#PBF | 功能描述:IC COMPARATOR 150MHZ DUAL 10MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:帶電壓基準 元件數:4 輸出類型:開路漏極 電壓 - 電源，單路/雙路(±):2.5 V ~ 11 V，±1.25 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:10mV @ 5V 電流 - 輸入偏壓（最小值）:- 電流 - 輸出（標準）:0.015mA @ 5V 電流 - 靜態（最大值）:8.5µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:- 磁滯:- 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 安裝類型:表面貼裝 包裝:管件 產品目錄頁面:1386 (CN2011-ZH PDF) |
| LT1715CMS#PBF | 制造商:Linear Technology 功能描述:High Speed Comparator IC |
| LT1715CMS#PBF | 制造商:Linear Technology 功能描述:IC HIGH SPEED COMPARATOR |
發布緊急采購，3分鐘左右您將得到回復。